Cooper Lighting Solutions
User Guide
GUV Control System
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be
performed by a qualied electrician. This product must be installed in accordance with the applicable installation code
by a person familiar with the construction and operation of the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance.
Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Personal Injury- Due to sharp edges, handle with care.
FCC Regulations state that any unauthorized changes or modications to this equipment not expressly approved by the
manufacturer could void the user’s authorization to operate this equipment.
GUV Control System should only be operated by authorized personnel. Before operation, the installer must complete
and submit a checklist to Cooper Lighting Solutions to ensure the control system is installed correctly.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise
from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing product. Retain for future reference.
NOTICE: Product may become damaged and/or unstable if not installed properly.
Note: Specications and dimensions subject to change without notice.
ATTENTION Receiving Department: Note actual product description of any shortage or noticeable damage on delivery receipt. File claim for common
carrier (LTL) directly with carrier. Claims for concealed damage must be led within 15 days of delivery. All damaged material, complete with original
packing must be retained.
GENERAL: Upon receipt of controller thoroughly inspect for any freight damage, which should be brought to the attention of the delivery carrier.
Compare the catalog description listed on the packing slip with the label on the controller to assure you have received the correct parts.
NOTICE: These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, or to provide directions
for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not
covered suciently for user’s purpose, please contact your nearest representative.
NOTICE: Proper grounding is required to insure personal safety. Carefully observe grounding procedure under installation section.
CAUTION: See ratings on controller for appropriate voltage. Any other connection voids the warranty.
GUV Control System User Guide
READ AND FOLLOW ALL SAFETY INSTRUCTIONS. SAVE AND KEEP THESE INSTRUCTIONS WITH THE CONTROL PANEL.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
GUV Control System should only be operated by authorized personnel. Before operation, the installer must complete and submit a
checklist to Cooper Lighting Solutions to ensure the control system is installed correctly.
GUV Important Safeguards
a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
b. Safe use of this UV equipment relies primarily on equipment and site safeguards. It is the installer’s responsibility to ensure that
equipment is installed in accordance to the manufacturer’s instructions.
c. It is the operator’s responsibility to ensure the equipment is used in accordance with the manufacturer’s user guide.
(i.e. The device is operated when the room is unoccupied.)
d. This equipment is designed for use with germicidal xtures and must be installed in compliance with competent technical directions
to prevent the user’s eyes and bare skin from exposure to harmful UVC radiation.
e. UV radiation can reect off surrounding surfaces and may pass through certain clear or translucent materials. Follow the
manufacturer’s recommended practice for spacing this equipment from nearby objects and surfaces. Contact the manufacturer for
further guidance.
f. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
g. This equipment uses user-replaceable lamps, replace them only with the lamps for which the equipment is marked and intended.
h. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
i. Do not use this equipment for other than its intended use.
WARNING
