Createbot Super Mini Manuale utente
1
Super Mini 3D Printerx1 PLA Filament 1kgx1
Super Mini Packing List
The items listed below are all the accessories in the box.Please check the items
before using
Power Supply x1
USB Cablex1
Door Plate x3 Filameant Support x1 SD Cardx1 Card
Readerx1
Plastic Partsx2
Thumb screw(M3X6)x8
Circular magnets(12*6*1)x1
Bucklex8
Screw (M4x6)x10
Wrenchx3
(1.5/2/2.5)
Tweezersx1
Printing platform
(115x100mm)x1
Soft magnet palte
(105x105mm) x1
2
Extruder
Appearance Introduction
SD Slot
Touch Screen Printing Platform
Input slot
Filament
Filamet support
Step1
I
Filament support
White pipe
Filament input
Operartion Guide
3
Place the filament on the filament support
First,assemble the two filament support and put into the input slot on the back
of the printer.Second,insert the filament into the white pipe till it reached the
end which means the filament is on the extruder and ready to print.
Door Plate x3 Assembled
Taking out the three door plate,fix the left and right door plate on the printer with
M4x6 screw.Then assemble the plastic parts and door handle with the M4x6 screw
on front of the printer.
Step2
4
Power input Power Cable
Turn on the Printer
Insert the power cable into the power input on the back of the machine and insert
the power cable into the wall power connector. Then the printer will automatically
running and you can hear the “di” sound. The display shows the startup interface,
indicating that the 3D printer is running good.
Home page Tool menu Preheat interface
Firstly,press the tool button into the tool menu then press the PREHEAT button you can
see the interface on picture 3 .Press the left up button to raise the temperature till it
reached at 195-225C .
Extruding Test
Step3
Step4
5
Place the printing platform
First,put the magnet plate on the top of the printing platform.Then adjust the
leveling screw to modify the gap betwween the extruder and the platform
Printing Platform
Printing Platform
Soft Magnet Plate
Gap adjusting screw
Tool Menu Load and unload the filament
Click “TOOL”, then choose “FILAMENT” and click “DOWN” to extrude
the filament. If it is extruded normally and smoothly, click “STOP” to
finish it and click “BACK” to return to home page.
Step5
P
6
Printing Test
Slicing Software Installation
Slicing Software
Home Page File select Printing interface
In the print home page, click the print icon, enter the print interface, open (openSD)
icon, open the SD card file interface, choose the 001 testing model ,then the
printer will start printing.
Copy the slicing software file from the SD card into your comoputer and Open
the installer
7
Select the path where the slice software is installed, then click Next, click
Install, the software will automatically instaledl until finished
The software will insatll the drive automatically,click next to finish the installation
Indice
Altri manuali Createbot Stampante 3D
Createbot
Createbot MaxI Manuale utente
Createbot
Createbot MAX Manuale utente
Createbot
Createbot Mini I Manuale utente
Createbot
Createbot MaxI Manuale utente
Createbot
Createbot Mini I Manuale utente
Createbot
Createbot MINI-Pro Manuale utente
Createbot
Createbot R3D S1 Guida utente
Createbot
Createbot S3 Manuale utente
