Danfoss AK-CC 550A Manuale di istruzioni

Troubleshooting Guidelines

AK-CC 550A

Service Guide

ADAP-KOOL® Refrigeration Control System

Service Guide |Troubleshooting Guidelines, AK-CC 550A

2 | AX278927426184en-000101

The following troubleshooting guidelines detail the process of

verifying proper setup of an AK-CC 550A when encountering

communication/oﬄine issues with an AK-SM 800 series controller.

System Manager Programming

• Complete Rescan

- On Network Nodes screen, select ‘Press for complete rescan’

*Also complete rescan if any of the items below required

adjustment

• Ensure proper channel enabled on Network Nodes screen of

system manager

- ‘Channel LONWORKS’ for LON RS485 comm loop

- ‘Channel MODBUS-RS485’for Modbus comm loop

• Verify no Duplicates in System Manager

- Check under Network Nodes->Duplicates

- If duplicates exist, identify case controller with mistaken

address, and update

• Verify address has been assigned to case controller in

program

- Verify under Conﬁguration->Control->Refrigeration-

>Addresses

AK-CC 550A Hardware

• Verify part # of AK-CC 550A. This will be printed on front of

controller below display

- For 084B8030, verify 230Vac to terminals 1&2

- For 084B8036, verify 115Vac to terminals 1&2

AK-CC 550A Programming

• Ensure address is set correctly, via parameter o03.

• Ensure application is set correctly, via parameter o61.

Comm Loop Wiring

• Verify intended form of communication to be used (Modbus

or LON RS485)

- For Modbus communication:

- Ensure comm wires are landed on terminals 57&58.

- Modbus loop is polarity sensitive, ensure polarity is

consistent throughout loop

- Ensure any other Modbus devices on the loop use 38400

baud rate

- For LON RS485 communication:

- Ensure comm wires are landed on terminals 52&53

- Ensure EKA 175 comm card is installed in port below

display.

- EOL resistor

- For 1 loop from system manager, ensure 120 ohm resistor

at end of loop and switch above comm plug in ‘On’

position

- For 2 loops from system manager, ensure 120 ohm resistor

at end of each loop and switch above comm plug in ‘Oﬀ’

position

• For either comm type, max distance is 4000’. Beyond this

distance, a repeater is needed

• For either comm type, max # of case controllers is 120 per

system manager

• For either comm type, an EIA 485 rated cable should be used

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.

Altri manuali per AK-CC 550A

Altri manuali Danfoss Unità di controllo

Danfoss

Danfoss Akva Lux II TDP-F Manuale utente

Danfoss

Danfoss OPTYMA Manuale di istruzioni

Danfoss

Danfoss PN 16 Manuale utente

Danfoss

Danfoss VLT MCA 121 EtherNet/IP Manuale utente

Danfoss

Danfoss PVG 16 PVH/Covers Manuale

Danfoss

Danfoss GPS 40-150 Manuale utente

Danfoss

Danfoss SVA-S Manuale utente

Danfoss

Danfoss ChangeOver6 Manuale utente

Danfoss

Danfoss PCV-VFGS 2 DN 150-250 Manuale utente

Danfoss

Danfoss OSPE Manuale utente

Danfoss

Danfoss AB-QM DN 125 Manuale utente

Danfoss

Danfoss ICF 50-4 Manuale utente

Danfoss

Danfoss VHX-DUO Manuale di istruzioni per l'installazione

Danfoss

Danfoss MSV-F2 DN Series Manuale utente

Danfoss

Danfoss FH-WC Manuale utente

Danfoss

Danfoss VLT HVAC Drive FC 102 Manuale utente

Danfoss

Danfoss PVG 32 Manuale

Danfoss

Danfoss ECL Comfort 210 Manuale utente

Danfoss

Danfoss EKE 1P Manuale utente

Danfoss

Danfoss PVEO Manuale utente

Danfoss

Danfoss AB-QM series Manuale utente

Danfoss

Danfoss RLV-X Manuale utente

Danfoss

Danfoss BVTS Manuale utente

Danfoss

Danfoss ASV-PV Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente