Dell PowerEdge 1950 Manuale tecnico

Dell™ PowerEdge™

1950 Systems

Information Update

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use

of your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data

if instructions are not followed.

WARNING: A WARNING indicates a potential for property damage,

personal injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of Dell Inc.; Intel

and Xeon are registered trademarks of Intel Corporation; Microsoft, Windows, and Windows Server

are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or

other countries; Red Hat and Red Hat Enterprise Linux are registered trademarks of Red Hat, Inc.;

SUSE is a registered trademark of Novell Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

November 2009 Rev. A09

Contents 3

Contents

Non-Optimal Memory Configurations . . . . . . . . . . . 5

PowerEdge 1950 III – New System Features . . . . . . . 5

New Performance Features . . . . . . . . . . . . . 5

New High-Efficiency Power Supply

and Power Monitoring Features . . . . . . . . . . . 5

New I/O and Storage Features . . . . . . . . . . . . 6

New Security Features . . . . . . . . . . . . . . . . 6

Optional Internal USB Memory Key . . . . . . . . . . . . 6

Installing the Optional Internal USB Memory Key . . 8

Support for 8-GB Memory Modules –

PowerEdge 1950 III Systems . . . . . . . . . . . . . . . . 9

Processor Upgrades – PowerEdge 1950 II

and PowerEdge 1950 III Systems . . . . . . . . . . . . . 9

System Board Replacement –

Safeguarding Encrypted Data . . . . . . . . . . . . . . 10

System Message Update. . . . . . . . . . . . . . . . . 10

LCD Status Messages Update . . . . . . . . . . . . . . 15

4Contents

System Setup Program Update. . . . . . . . . . . . . . 21

Memory Screen. . . . . . . . . . . . . . . . . . . 21

CPU Information Screen . . . . . . . . . . . . . . 22

Integrated Devices Screen . . . . . . . . . . . . . 22

System Security Screen . . . . . . . . . . . . . . 23

Operating System Information . . . . . . . . . . . . . . 25

Enumeration of NICs . . . . . . . . . . . . . . . . 25

RHEL – Incorrect Processor Information . . . . . . 25

System Support for Microsoft Windows 2000 . . . 25

Hardware Owner’s Manual Updates . . . . . . . . . . 26

Installing the Processor. . . . . . . . . . . . . . . 26

System Diagnostics Custom Test Options . . . . . 26

Information Update 5

Non-Optimal Memory Configurations

The POST may halt when a non-optimal memory configuration is detected

and the following message is displayed:

Non-Optimal Memory Configuration

Press F1 to continue or F2 for Setup

NOTE: Mixing DIMMs of different speeds renders the memory configuration

non6Hoptimal. The system clocks down the performance to the slowest speed

in the DIMM set for the channel.

PowerEdge 1950 III – New System Features

New Performance Features

• Two dual-core or quad-core Intel

Xeon

5400 Series and 5300 Series

processors.

• 8-GB memory module support.

New High-Efficiency Power Supply and Power Monitoring Features

• Higher system efficiency on power conversion across workloads.

• Baseboard Management Control (BMC) power monitoring monitors

current, voltage, and power utilization in the system.

6Information Update

New I/O and Storage Features

• Optional Intel quad-port Gigabit Ethernet NIC, capable of supporting

10-Mbps, 100-Mbps, and 1000-Mbps data rates and iSCSI remote boot.

• Support for 10-Gb Ethernet cards.

• One internal USB 2.0-compliant connector supporting an optional

bootable USB flash drive or USB memory key.

• Support for optional SAS 6i/R and PERC 6/i adapters.

New Security Features

• Trusted Program Module (TPM) support for improved security.

• Optional support for iSCSI boot.

Optional Internal USB Memory Key

The PowerEdge 1950 III system provides an internal USB connector located

on the system board for use with a USB flash memory key (see Figure 1-1).

The USB memory key can be used as a boot device, security key, or mass

storage device. To use the internal USB connector, the Internal USB Port

option must be enabled in the Integrated Devices screen of the System Setup

program. See "Integrated Devices Screen" on page 22.

Information Update 7

Figure 1-1. Internal USB Connector Location

To boot from the USB memory key, you must configure the USB memory

key with a boot image and then specify the USB memory key in the boot

sequence in the System Setup program. See

"Using the System Setup

Program" in the

Hardware Owner’s Manual

. For information on creating

a bootable file on the USB memory key, see the user documentation that

accompanied the USB memory key.

NOTE: USB keys that contain multiple LUNs (Logical Unit Numbers) must be

formatted using the format utility provided by the key manufacturer.

NOTE: To avoid interference with components inside the system, the USB key must

conform to the following maximum dimensions: 11.68mm thick (0.46") x 24.89mm

width (0.98") x 66.8mm length (2.63").

1 system board 2 internal USB connector location

8Information Update

Installing the Optional Internal USB Memory Key

WARNING: Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. See your Product

Information Guide for complete information about safety precautions,

working inside the computer, and protecting against electrostatic discharge.

Turn off the system, including any attached peripherals, and disconnect

the system from its electrical outlet.

Open the system. See "Opening the System" in the

Hardware Owner’s

Manual

Remove the memory cooling shroud. See "Removing the Memory Cooling

Shroud" in the

Hardware Owner’s Manual

Locate the USB connector on the system board and insert the USB

memory key into the USB connector. See Figure 1-2.

Figure 1-2. Installing an Internal USB Key

1 USB memory key 2 internal USB connector

Information Update 9

Replace the memory cooling shroud.

Close the system. See "Closing the System" in the

Hardware Owner’s

Manual

Reconnect the system to power and restart the system.

Enter the System Setup program and verify that the USB key has been

detected by the system. See "Using the System Setup Program" in the

Hardware Owner’s Manual

Support for 8-GB Memory Modules –

PowerEdge 1950 III Systems

PowerEdge 1950 III systems have added support for the following approved

8-GB memory configurations:

• 64 GB — 8 x 8-GB quad-rank memory modules

• 48 GB — 4 x 8-GB quad-rank and 4 x 4-GB dual-rank memory modules

If 64 GB of memory is installed, the system only recognizes and displays

63.75 GB during POST.

NOTE: Prior to upgrading your system, verify that the latest system BIOS version is on your

system. Loading the latest BIOS version ensures that your system is fully supported.

NOTE: Some operating systems cannot support more than 4 GB of physical memory. For

more information on memory support requirements and restrictions, refer to the operating

system documentation that ships with your system.

Processor Upgrades – PowerEdge 1950 II

and PowerEdge 1950 III Systems

• If the front of your system chassis is labeled with a "II," your system is

upgradeable to the 5100 series of dual-core Intel Xeon processors and

the 5300 series of quad-core Intel Xeon processors.

• If the front of your system chassis is labeled with a "III," your system is

upgradeable to the 5100 and 5200 series of dual-core Intel Xeon processors

and the 5300 and 5400 series of quad-core Intel Xeon processors.

See support.dell.com for information on the latest processor upgrade options

for your system.

10 Information Update

System Board Replacement – Safeguarding

Encrypted Data

On PowerEdge 1950 III systems using Windows Server®2008, you can use

encryption programs, such as the BitLocker utility, to secure the contents

of the hard drive.

If you are using the TPM with an encryption application, you are prompted

to create a recovery key during system setup. Be sure to store this recovery key.

If you replace the system board, you must supply the recovery key when you

restart your system before you can access the encrypted files on your hard

drive(s).

System Message Update

Table 1-1 lists new system messages for the PowerEdge 1950 III system and

the probable cause and corrective action when the message appears.

WARNING: Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. See your Product

Information Guide for complete information about safety precautions,

working inside the computer, and protecting against electrostatic discharge

Altri manuali per PowerEdge 1950

Indice

Lingue:

Altri manuali Dell Server

Dell

Dell 100 Series Manuale

Dell

Dell PowerEdge 1855 Manuale tecnico

Dell

Dell PowerEdge T100 Manuale tecnico

Dell

Dell PowerEdge 6350 Manuale utente

Dell

Dell POWEREDGE 1900 Manuale utente

Dell

Dell poweredge t330 Manuale utente

Dell

Dell E71S Manuale utente

Dell

Dell PowerEdge R520 Guida rapida

Dell

Dell ECS EX Series Istruzioni per l'installazione

Dell

Dell PowerEdge 6400 Manuale utente

Dell

Dell VxRail P670F Manuale

Dell

Dell EMC PowerEdge R740 Manuale

Dell

Dell DR4000 Restore Manager Manuale utente

Dell

Dell Dell DR4300e Manuale utente

Dell

Dell PowerEdge R410 Manuale utente

Dell

Dell PowerVault 530F Manuale tecnico

Dell

Dell W4X15 Manuale utente

Dell

Dell POWEREDGE SC1430 Manuale utente

Dell

Dell PowerEdge R430 Manuale utente

Dell

Dell PowerVault NX3500 Manuale utente

Dell

Dell Active Fabric Manager Guida di riferimento rapido

Dell

Dell Precision Workstation 350 Manuale tecnico

Dell

Dell PowerEdge XR8000r Manuale

Dell

Dell PowerEdge M420 Manuale operativo

Manuali Server popolari di altre marche

HP AlphaServer ES47 Manuale utente

PowerNAS

PowerNAS CMA Manuale utente

Supero

Supero FatTwin F617R3-FT Manuale utente

MSI

MSI P1-109N-L70 Manuale utente

EtroVISION

EtroVISION EV3151 Manuale utente

NEC

NEC Express5800/T110j Manuale utente

HP ProLiant Gen9 Manuale utente

Compaq

Compaq ProLiant 3000 Manuale

iRobo

iRobo IPC2U Manuale utente

Nortel

Nortel 1000 Con?guration guide Manuale utente

Asus

Asus AP7500 Manuale operativo e di manutenzione

Avid Technology

Avid Technology AirSpeed 5000 Manuale utente

HP Integrity rx2600 Guida all'installazione

Milestone

Milestone Husky IVO 350T Manuale utente

Planet

Planet NAS-7410 Manuale utente

Lenovo

Lenovo ThinkSystem SR635 V3 Manuale utente

Fujitsu

Fujitsu PRIMERGY BX900 Manuale utente

Asus

Asus RS700DA-E6 PS4 Manuale utente