■CONNECTIONS
■DIMENSIONS
INSTRUCTION MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
■Do not open or modify
Do not open the cabinet exit during maintenance and
installation,as it may be dangerous and cause damages.
■Do not put objects inside the unit
Make sure that no metal objects or flammablesubstances get inside
the camera. It could cause fire, short-circuits or damages.
■Be careful when handling the unit
To prevent damage,do not drop the camera or subject
it to strong shock or vibration.
■Install away from electric or magnetic fields
■Protect from humidity and dust
■Protect from high temperature
Be carefulwhen installingclose to the ceiling , in a kitchen or boiler
room, as the temperature may raise to high levels.
■Cleaning
Dirt can be removed from the cabinetonly by wiping it
with a soft cloth moistened with a soft detergentsolution.
■Mounting Surface
The mounting surfacematerial must be strong enough to securethe
camera.
INSTALLATION
CONNECTIONS
WARRANTY INFORMATION
“
”
This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
If the problem is not handled to your satisfaction,then write to the
PRECAUTIONS
MC355T
About this manual
12VDC
CAUTION :
Check for polarity when using a DC 12V.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
VIDEO O UT
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
TROUBLESHOOTING
Before sendingthe camera out for repair, check the items below. If the
problem persists after checking these items, contact your service
center.
■If no image appears.
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprintsoff the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commerciallyavailable).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
■Do not open or modify
Do not open the cabinet exit during maintenance and
installation,as it may be dangerous and cause damages.
■Do not put objects inside the unit
Make sure that no metal objects or flammablesubstances get inside
the camera. It could cause fire, short-circuits or damages.
■Be careful when handling the unit
To prevent damage,do not drop the camera or subject
it to strong shock or vibration.
■Install away from electric or magnetic fields
■Protect from humidity and dust
■Protect from high temperature
Be carefulwhen installingclose to the ceiling , in a kitchen or boiler
room, as the temperature may raise to high levels.
■Cleaning
Dirt can be removed from the cabinetonly by wiping it
with a soft cloth moistened with a soft detergentsolution.
■Mounting Surface
The mounting surfacematerial must be strong enough to securethe
camera.
INSTALLATION
CONNECTIONS
WARRANTY INFORMATION
Digital Watchdog (referred to as “the Warrantor”) warrants the
Camera Series against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years from the date of original purchase,
if the camera is determined to be defective,the Warrantor will repair or
replace the unit, with
new or refurbishedproduct at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for
the initial five (5) years. To obtain warranty or out of warranty service,
please contact a Technical Support Representativeat 1-866-446-3595
Monday throughFriday from 9:00 AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the original purchase is
required before warranty service is rendered. This warranty only
covers failuresdue to defects in materialsand workmanship which
arise during normal use. This warranty does not cover damage which
occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failures which result from accident,
misuse, abuse, neglect, mishandling, misapplication,alteration,
modification,faulty installation, set-up adjustments,improper antenna,
inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply,
lightning damage, rental use of the product or service by anyone other
than an authorized repair facility or damage that is attributable to acts
of God.
This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
If the problem is not handled to your satisfaction,then write to the
Addressabove.
Servicecalls which do not involvedefectivematerials or workmanship
as determinedby the Warrantor, in its sole discretion,are not covered.
Costs of such service calls are the responsibility of the purchaser.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above. The Warrantor
will not be liable for incidental or consequential damages (including,
without limitation, damageto recordingmedia) resulting from the use of
these products,or arising out of any breach of the warranty. All express
and implied warranties, including the warranties of merchantabilityand
fitness for particularpurpose, are limitedto the applicablewarranty
period set forth above.
Some states do not allow the exclusion or limitation of incidentalor
consequentialdamages, or limitationson how long an implied warranty
lasts, so the above exclusionsor limitationsmay not apply to you.
PRECAUTIONS
MC355T
About this manual
12VDC
CAUTION :
Check for polarity when using a DC 12V.
A. Removing the screw on the upper case by using
L-wrench.
B. Separate the upper case from the bottom case
C. Make the 4 mounting screwhole on the ceiling/wall by drawing
the positions using the bottom case
D. PutPowercable andVideocable intotheceiling/wall.
E. Align the bottom case to the ceiling/wall by using
the screws.
F. Adjust the camera to its position
(Referance - "CAMERA SETTING" )
G. Connect the upper case and bottom case.
H. Tighten the Stop Screw to the upper case using L-wrench.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
E
D
C
B
A
F
VIDEO O UT
