DEEP SEA ELECTRONICS
DSEG8680 Installation Instructions
This document details the installation and operation requirements of
the DSEG8680 module and is part of the DSEGenset® range of
products.
The DSE8680 module is a bus tie controller designed to control a
Bus Tie. A bus tie controller separates two halves of a generator
common bus. The DSE8680 manages the synchronising and check
synch and automatically controls the DSE AMSC (Advanced Multi
Set Communications) Link when opening/closing the bus tie.
CONTROL BUTTONS
Auto Button
In the G8680 the auto button is used to select Auto Mode.
Alarm Mute / Lamp Test
This button silences the audible alarm in the controller,
de-activates the Audible Alarm output (if configured) and
test function.
Open Close Bus Breaker
There are two controller buttons (left and right) which
provide various control options for the breaker:
This button opens and closes the breaker.
Manual
This mode allows manual control of the functions. Once in
Manual mode the module will respond to the breaker
button , toggling the bus breaker.
Reset
Resets any alarms that have been detected by the
controller.
Menu Navigation
Used for navigating the instrumentation, event log and
configuration screens.
ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
NOTE: Depending upon module configuration, some parameters in the
‘Running’ Editor may not be available. For more information refer to DSE
publication 057-326 DSEG8680 Configuration Suite PC Software Manual
available from www.deepseaelectronics.com
RUNNING’ CONFIGURATION EDITOR PARAMETERS
Parameter As Shown On
Display
EDITING A PARAMETER
•Press and hold the Tick button for 5 seconds to access the editor.
•Press the Scroll buttons to select parameter.
•Press the Tick button to adjust the value (flashing) using the .Scroll
buttons
•Press the Tick button save the changes.
