ECS CDC-I Manuale utente
Preface
Preface
Copyright
This publication, including all photographs, illustrations and software, is protected
under international copyright laws, with all rights reserved. Neither this manual, nor
any of the material contained herein, may be reproduced without written consent of
the author.
Version 1.0
Disclaimer
The information in this document is subject to change without notice. The manufac-
turer makes no representations or warranties with respect to the contents hereof and
specifically disclaims any implied warranties of merchantability or fitness for any
particular purpose. The manufacturer reserves the right to revise this publication and
to make changes from time to time in the content hereof without obligation of the
manufacturer to notify any person of such revision or changes.
Trademark Recognition
Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.
MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel
Corporation.
Other product names used in this manual are the properties of their respective
owners and are acknowledged.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment onto an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Shielded interconnect cables and a shielded AC power cable must be employed with
this equipment to ensure compliance with the pertinent RF emission limits govern-
ing this device. Changes or modifications not expressly approved by the system’s
manufacturer could void the user’s authority to operate the equipment.
ii
Preface
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject to the
following conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interfer-
ence that may cause undesired operation
Canadian Department of Communications
This class B digital apparatus meets all requirements of the Canadian Interference-
causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur
le matériel brouilieur du Canada.
About the Manual
The manual consists of the following:
Chapter 1
Introducing the Motherboard
Describes features of the
motherboard.
Go to Hpage 1
Describes installation of
motherboard components.
Go to Hpage 7
Provides information on using
the BIOS Setup Utility.
Go to Hpage 23
Describes the motherboard soft-
ware.
Go to Hpage 45
Chapter 2
Installing the Motherboard
Chapter 3
Using BIOS
Chapter 4
Using the Motherboard Software
Chapter 5
Trouble Shooting
Provides basic trouble shooting
tips
Hpage 49Go to
iii
TT
TT
TABLE OF CONTENTSABLE OF CONTENTS
ABLE OF CONTENTSABLE OF CONTENTS
ABLE OF CONTENTS
Preface i
Chapter 1 11
11
1
Introducing the Motherboard 1
Introduction......................................................................................1
Feature...............................................................................................2
Motherboard Components.............................................................5
Chapter 2 77
77
7
Installing the Motherboard 7
Safety Precautions............................................................................7
Choosing a Computer Case.............................................................7
Installing the Motherboard in a Case............................................7
Checking Jumper Settings...............................................................8
Setting Jumpers...................................................................8
Checking Jumper Settings...................................................9
Jumper Settings...................................................................9
Installing Hardware........................................................................10
Installing Memory Modules...............................................10
Expansion Slots.................................................................11
Connecting Optional Devices............................................13
Installing a Hard Disk Drive/CD-ROM/SATA Hard Drive..17
Connecting I/O Devices................................................................18
Connecting Case Components.....................................................19
Front Panel Header...........................................................21
Chapter 3 2323
2323
23
Using BIOS 23
About the Setup Utility................................................................ 23
The Standard Configuration..............................................23
Entering the Setup Utility...................................................23
Resetting the Default CMOS Values...................................24
Using BIOS......................................................................................24
BIOS Navigation Keys.......................................................25
Main Menu.........................................................................27
Advanced Menu.................................................................28
Chipset Menu.....................................................................38
Tweak Menu........................................................................40
iv
Boot Menu..........................................................................41
Security Menu......................................................................42
Save & Exit Menu....................................................................43
Updating the BIOS..................................................................44
Chapter 4 4545
4545
45
Using the Motherboard Software 45
About the Software DVD-ROM/CD-ROM.....................................45
Auto-installing under Windows Vista/7..........................................45
Running Setup....................................................................46
Manual Installation..........................................................................48
Utility Software Reference..............................................................48
Chapter 5 4949
4949
49
Trouble Shooting 49
Start up problems during assembly....................................................49
Start up problems after prolong use..................................................50
Maintenance and care tips.................................................................50
Basic Troubleshooting Flowchart....................................................51
1
Introducing the Motherboard
Chapter 1
Introducing the Motherboard
Introduction
Thank you for choosing the CDC-I motherboard. This motherboard is a high perfor-
mance, enhanced function motherboard with Intel®Atom D2700/D2500/D2550 or
other CPU for high-end business or personal desktop markets.
The motherboard CDC-I supports one PCI slot. It implements an EHCI compliant
interface that provides eight USB 2.0 ports (four USB ports and two USB 2.0 headers
support additional four USB ports). Intel®NM10 integrates a Serial ATA host con-
troller, supporting two SATA ports with maximum transfer rate up to 3.0 Gb/s each.
The motherboard is equipped with advanced full set of I/O ports in the rear panel,
including PS/2 mouse and keyboard connectors, one VGA port, one parallel port, one
COM port, four USB ports, one LAN port and audio jacks for microphone, line-in
and line-out.
This motherboard is based on Intel®NM10 Chipset for best desktop platform
solution. NM10 is a single-chip, highly integrated.
The memory controller of this motherboard supports DDR3 memory SODIMM
frequency of 1066. It supports two DDR3 sockets with up to maximum memory of
4 GB.
2
Introducing the Motherboard
Feature
Processor
• D2700 supports “Hyper-Threading” technology CPU
“Hyper-Threading” technology enables the operating system into thinking it’s
hooked up to two processors, allowing two threads to be run in parallel, both on
separate “logical” processors within the same physical processor.
The Intel®NM10 chipset is based on an innovative and scalable architecture
with proven reliability and performance.
Chipset
• Enhanced DMA Controller, interrupt controller, and time functions
• Integrated SATA 3.0 Gb/s Host Controller
• Integrated USB 2.0 Host Controller
• Intel®Atom D2700/D2500/D2550 or other CPU
Memory
• Supports DDR3 1066 SO-DIMM with single-channel architecture
• Accommodates two unbuffered DIMMs
• 2 x 204-pin DDR3 SODIMM sockets support up to 4 GB
Onboard LAN (optional)
The onboard LAN provides the following features:
• Supports PCI ExpressTM 1.1
• Integrated 10/100 transceiver
• Wake-on-LAN and remote wake-up support
• Supports PCI ExpressTM 1.1
• Integrated 10/100/1000 transceiver
• Wake-on-LAN and remote wake-up support
The motherboard comes with the following expansion options:
• One 32-bit PCI slot
• Two 7-pin SATA connectors
Expansion Options
This motherboard may support either of the following Audio chipsets:
• 5.1 Channel High Definition Audio Codec
• ADCs support 44.1k/48k/96kHz sample rate
• Meets Microsoft WLP 3.10 Vista premium and mobile PCs audio
requirements
• Direct Sound 3DTM compatible
Audio
3
Introducing the Motherboard
• Two PS/2 ports for mouse and keyboard
• One parallel port
• One serial port
• One VGA port
• Four USB ports
• One LAN port
• Audio jacks for microphone, line-in and line-out
The motherboard has a full set of I/O ports and connectors:
Integrated I/O
• Power management
• Wake-up alarms
• CPU parameters
• CPU and memory timing
BIOS Firmware
This motherboard uses AMI BIOS that enables users to configure many system
features including the following:
1.Some hardware specifications and software items are subject to change
without prior notice.
2.Due to chipset limitation, we recommend that motherboard be oper-
ated in the ambiance between 0 and 50°C.
4
Introducing the Motherboard
• Intel®NM10 Express
• Single-channel DDR3 memory architecture
• 2 x 204-pin DDR3 SODIMM socket support up to 4 GB
• Supports DDR3 1066 DDR3 SDRAM
• 1 x PCI slot
• 2 x Serial ATAII devices
•VIA VT1705CD
• Realtek 8105E-VL 10/100 LAN (RTL8111E-VL Gigabit Lan
optional)
• 1 x PS/2 keyboard & PS/2 mouse connectors
• 4 x USB ports
• 1 x Parallel port
• 1 x VGA port
• 1 x COM port
• 1 x RJ45 LAN connector
• 1 x Audio port
• 1 x 24-pin ATX Power Supply connector
•1 x Case open header
• 2 x Serial ATA connectors
• 2 x USB 2.0 headers support additional 4 USB ports
• 1 x Front panel header
• 1 x Clear CMOS header
• 1 x Front panel audio header
•1 x Speaker header
• CPU FAN & SYS FAN connectors
•1 x LVDS header (optional)
•1 x COM header
Chipset
Memory
Expansion
Slot
Storage
Audio
LAN
Rear Panel I/O
Internal I/O
Connectors &
Headers
Specifications
• Intel®Atom D2700/D2500/D2550 or other CPU
CPU
• AMI BIOS with 16Mb SPI ROM
• Supports Plug and Play, STR/STD, Hardware monitor, PCI
interrupt selection, ACPI & DMI
System BIOS
Form Factor • Mini-ITX Size, 170mm x 170mm
5
Introducing the Motherboard
Motherboard Components
Table of Motherboard Components
This concludes Chapter 1. The next chapter explains how to install the motherboard.
LABEL COMPONENTS
1. CPU_FAN CPU cooling fan connector
2. DIMM_1~2 204-pin DDR3 SDRAM slots
3. ATX_POWER Standard 24-pin ATX power connector
4. CLR_CMOS Clear CMOS jumper
5. SATA1~2 Serial ATA connectors
6. F_PANEL Front panel switch/LED header
7. F_USB1~2 Front Panel USB headers
8. CASE Chassis detect jumper
9. USBPWR_F Front panel USB power select jumper
10. PCI 32-bit add-on card slots
11.SPDIFO SPDIF out header
12. F_AUDIO Front panel audio header
13. USBPWR_R Rear USB/PS2 power select jumper
14. SPK Speaker header
15. COM2 Onboard serial header
16. SYS_FAN System cooling fan connector
6
Introducing the Motherboard
Memo
Indice
Altri manuali ECS Scheda madre
ECS
ECS 761GXM-M2 Manuale utente
ECS
ECS 651C-M Manuale utente
ECS
ECS Z270-LIGHTSABER Manuale utente
ECS
ECS K7VZA Manuale utente
ECS
ECS L7S7A2 Manuale utente
ECS
ECS P55H-AK Manuale utente
ECS
ECS B75H2-M4 Manuale utente
ECS
ECS G41T-M7 Manuale utente
ECS
ECS P6EXP-Me Manuale utente
ECS
ECS H61H2-M12 Manuale utente
Manuali Scheda madre popolari di altre marche
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manuale utente
Gigabyte
Gigabyte GA-9IVDT Manuale utente
Texas Instruments
Texas Instruments ADS8372EVM Manuale utente
Commell
Commell MS-C73 Manuale utente
IBT Technologies
IBT Technologies MB860 Manuale utente
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuale utente
