Step 4:
The Pedals (No.8L/R) are marked "L" and "R" for
Left and Right. Make sure you attach the correct
pedal to the corresponding crank. Attaching the
pedal to the wrong crank can cause irreversible
damage to both the pedal and the crank. The
Nuts (No.9L/R) are preassembled to Pedals
(No.8L/R).
Attach Left Pedal (No.8L) to Left Crank (No.29).
Turn the Left Pedal (No.8L) counter-clockwise
with the hand until it is tight, then use the
Crosshead Spanner (No.88) to securely tighten.
Use the Crosshead Spanner (No.88) to hold the
bolt of the pedal in place, then use the Open
Wrench (No.89) to screw the Nut (No.9L) tightly
in a clockwise direction to the thread end of the
Left Pedal (No.8L).
Attach Right Pedal (No.8R) to Right Crank
(No.28). Turn the Right Pedal (No.8R) clockwise
with the hand until it is tight, then use the
Crosshead Spanner (No.88) to securely tighten.
Use the Crosshead Spanner (No.88) to hold the
bolt of the pedal in place, then use the Open
Wrench (No.89) to screw the Nut (No.9R)
tightly in a counter-clockwise direction to the
thread end of the Right Pedal (No.8R).
Remove 2 pre-assembled Screws (No.42) and 2
pre-assembled Flat Washers (No. 43) from the
Main Frame (No.1).Then attach the Bottle
Holder (No.65) to the Main Frame (No.1) using
the 2 Screws (No.42) and 2 Flat Washers
(No.43) that are removed. Tighten with a
Crosshead Spanner (No.89).
Assembly is complete!
