STEP 3:
Insert the Handlebar Post (No.17) to the
Main Frame (No.1). Set at desired height,
insert and tighten the Adjustment Knob
(No.10).
Remove 2 Carriage Bolts (No.92) and 2
Washers (No.91), and 2 Domed Nuts
(No.99) from the Handlebar (No.18).
Attach Handlebar (No.18) to the
Handlebar Post (No.17) with 2 Carriage
Bolts (No.92) and 2 Washers (No.91), and
2 Domed Nuts (No.99)that were just
removed, then tighten with Spanner
(No.96). Removed Bolt (No. 90) from
Handlebar (No.18), then cover Tablet
Bracket (No. 20) to the Handlebar (No.18)
with Bolt (No. 90) that were just removed,
tighten with a Crosshead Spanner
(No.95).
Note: The Front Handlebar (No. 19) is
preassembled to the Handlebar (No.18).
If the Bolts (No. 62) is loose, use Inner
Hexagon Spanner (No. 93) to tighten.
(Figure A)
BATTERY INSTALLATION: Open the battery
cover from the back of Computer (No.
75), then put 2 pcs of batteries into the
battery compartment. Make sure the (-)
end of the battery goes to the spring end
of the battery compartment, then put the
battery cover back.
Insert the Sensor Wire (No. 76) into the
hole at the back of the computer marked
“SENSOR”, insert the Pulse Sensing Line
(No. 81) into the hole at the backside of
the computer marked “PULSE”. Then
attach the Computer (No.75) to the
computer bracket on the upside surface of
the Handlebar Post (No.17),
Removed 2 Screws (No. 42) from the
Main Frame (No. 1), attach the Front
Cover (No. 48) to Main Frame (No. 1)
with 2 Screws (No. 42) that were just
removed, tighten with a Crosshead
Spanner (No.95).
