Smart auto-stop feature for the maximum safety:
Self-cleaning procedures:
Anti-drip feature:
Anti-calc feature:
The Anti-calc function filtrate the minerals from the water to prevent
mineral residue build up at the steam chamber.
Cleaning
Before cleaning, unplug the power plug from the wall socket and
allow the iron to cool down for a while.
The upper part of the appliance can be cleaned with a damp cloth.
Keep the soleplate smooth. Avoid any hard contact with metal o
bjects.
Calcium and other residue can be wiped off from the soleplate
with a damp cloth.
How to fill water:
The built-in smart IC controller will automatically switch off the
iron if it detects no movement for 30 seconds in horizontal
position and 8 minutes in vertical position
Once it is activated the auto shut off indicator will flash.
To restart the iron, pick up the iron or move it slightly, then the
auto shut off indicator goes out and the power lamp will be on
to indicate the iron is ready for use.
1. Set the position switch to position (corded iron mode)
2. Take the iron off from the power base.
3. Make sure that there is enough water in the water tank.
4. Set the temperature knob to MAX.
5. Insert the power plug into the socket.
6. When the power lamp first goes out and then comes on again,
remove the power plug from the wall socket
7. Press the “self clean” button for about 1 minute,
8. Strong steam and hot water will be sprayed out to clean the
steam chamber.
9. Let the iron heat up again, the remaining water inside the
steam chamber will be vaporized.
This iron is equipped with an Anti-drip function: the iron automatically
stops steaming when the temperature is too low to prevent water
from dripping out of the soleplate.
