5、Real-time temperature of the soldering iron. ERROR occurs when unconnected, and it only
shows real-time iron temperature when the soldering iron is inserted.
5. Menu
中文 English Korean
设置菜单 Main menu 메인메뉴
┣基本设置 Base setup 기본셋팅
┃┣运放增益 Amplify gain 증폭계수 Default value 239, range 100-350, change unnecessary
┃┣失调电压 Amplify offset 실조전압 Default value 50, range 0-400mv, change unnecessary
┃┗热电参数 Thermocouple 열전 계수 Default value 42, range 30-50, adjust when screen
temperature is different from real-time temperature
┣待机设置 Standby setup 절전설정
┃┣待机温度Standby temp 온도설정 Default 200 °C , range 180-250 °C
┃┣待机时间 Idle time 초과 시간 Default 2 minutes, range 1-30 minutes
┃┗唤醒模式 Wakeup mode 동작방법 (编码 / 震动) (KNOB/SHAKE) (핸들/진동)
┣休眠设置 Sleep setup 수면 설정 （Sleep mode, heating stops）
┃┗休眠时间 Poweroff time 초과 시간 Default 5 minutes, range 0-30 minutes
┣加强设置 Boost setup 강화설정
┃┣增加温度 Boost temp 온도강화 range 20-100 °C , Default 50 °C
┃┗加强时间 Boost time 시간강화 Default 1 minute, range 1-10 minutes
┣步进设置 Stepping temp 스텝 온도 Default 10°C , range 1-10°C
┣屏幕设置 Screen setup 화면설정
┃┣标题位置 Title line 표제위치 (上/下) (TOP/BOTTOM) (상/하)
┃┗屏保时间 Saver ActTime 대기시간 Default 15 seconds, range 0-240 seconds. Saver off at 0
second.
┣蜂鸣设置 Buzzer setup 알람설정
┃┣蜂鸣开关 Sound enable 알람사용 (关/开) (OFF/ON) (정/부) “on/off”, default off
┃┗提醒方式 When to beep 알람 방식 (Save/All) (저장 /전부)
┣恢复默认 Factory reset 초기화 (是/否) (Confirm/Cancel) (정/부)
┣电压设置 Power monitor 전원설정
┃┣蜂鸣电压 Alarm voltage 경고 전압 Default 14V, range 4-20V. Alarm voltage off at 4V.
┃┗休眠电压 Poweroff volt 차단전압 Default 12V, range 4-20V. Poweroff volt off at 4V.
┣调试信息 Debug Mode 검사모드 (关/开) (OFF/ON) (정/부)
┗开机全屏 Boot SCN test 화면 검사 (关/开) (OFF/ON) (정/부) The screen is white when
booting and you can tell if OLED is damaged.
6. Basic operation
1：Turn down temperature by switching counterclockwise (minimum 180°C), turn up clockwise
(maximum 430°C）
2：Go to boost mode by briefly pressing the encoder and the temperature on the screen will
