Apply the brake. Unfold the chassis by pulling the handle
upwards whilst you hold down the side of the chassis. The safety
catch (1) is activated to prevent unintentional folding only if the
chassis lock (2) is not locked into position.
The chassis locks need to click into the locked position.
Always check before you use the vehicle that the chassis lock (2)
is in the locked position, because the vehicle may otherwise be
Remove the plastic protection from the axles. Save them for
Attach the wheels with the wheel cogs (3). Press in the hub cap’s
release button (4), push the wheel onto the axles as far as it can
go. Release the button and pull the wheel towards you, until
you hear a de nite click. Repeat the same procedure for all four
wheels. Please make sure that the wheels are attached properly
and cannot be pulled off the axle.
Release the brake by pushing the brake bar up towards you using
minimum force with your foot.
The wheels are greased and can leave marks on textiles. Please
use wheel protection indoors to protect your oors.
Risk of suffocation. Don’t let your child play with or in some
Braking system on the vehicle/releasing the brake
Brake by pushing the brake bar down into the wheel cogs.
Release the brake by lifting it upwards.
Never leave the child unattended without engaging the braking
The brake should always be engaged when you lift your child in
Never park the vehicle on a hill.
Ensure that the brake unit sits rmly in the wheel cogs.
The vehicle is equipped with cog brakes. Check that there
a wheel cog on each wheel and that it is rmly attached. Engage
the brake only when the vehicle has come to a standstill.
Assemble the tray by moving the catch which is on the underside
of the tray slide under the rear axle.
Then press the two ends into the holes on the chassis as indicated
by the arrows. Adjust accordingly so that it ts well.
