Extech Instruments TG20 Manuale utente

User's Guide

Wire Tracer Probe and Transmitter

Model TG20

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

TG20-EU-EN-V1.0 03/12

Introduction

Congratulations on your purchase of Extech’s Model TG20. This tone generator and amplifier probe

set is used to quickly trace and identify cables or wires within a group and also check the operation of

phone lines. With proper use and care, this meter will provide many years of reliable service.

Meter Description

1. Modular connector

2. Test leads

3. Function LEDs

4. Power switch

5. Probe tip

6. Power/Sensitivity control

Operating Instructions

Note: To extend battery life, remember to turn off the probe and transmitter after tracing the cables

Self Check

1. Turn the probe on and set the transmitter to TONE.

2. The RED LED on both units will light up. Replace the batteries if they do not.

3. Touch the probe to the transmitter wires and check for the generated tone..

Cable/Wire tracing

CAUTION: Do not connect the transmitter to any wire or cable with an active circuit of more than

24VAC.

1. Connect the transmitter to the cable

a) For cables terminated at one end, connect the red alligator clip to a wire and the black

alligator clip to equipment ground

b) For un-terminated cables, connect the red alligator clip to one wire and the black alligator

clip to another wire.

c) For cables with modular connectors, insert the RJ11 plug directly into the connector.

2. Set the transmitter power switch to the TONE position. The red TONE LED will turn on.

3. On the probe, rotate the Power/Sensitivity control so that the POWER LED is on..

4. Hold the insulated probe tip against the wire in question to pick up the signal generated by the

transmitter.

5. Rotate the volume/sensitivity control on the probe for the appropriate level and sensitivity to

identify and trace the wire.

6. The tone will be the loudest on the wires connected to the tone generator.

Continuity testing

CAUTION: Disconnect power and loads from any circuits to be tested.

4. Connect the test leads to the wire under test.

5. Switch the transmitter to the CONTINUITY position.

6. The CONTINUITY LED will glow GREEN for if the resistance is less than 10,000 ohms. The

LED intensity will be very bright for very low resistances and will decrease in intensity as

resistance increases.

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

TG20-EU-EN-V1.0 03/12

Identifying telephone cable Tip and Ring – Using Alligator Clips

1. Switch the transmitter to the OFF position

2. Connect the BLACK clip to ground

3. Connect the RED clip to a line.

4. The LED color identifies the line.

5. GREEN indicates the Ring line, RED indicates the Tip line.

6. If both RED and GREEN light up, AC voltage is present (do not exceed 24V)

Identifying telephone cable Line Condition

1. Switch the transmitter to the OFF position

2. Plug the connector into the phone line or connect the RED clip to the RING line and the

BLACK clip to the TIP line.

3. The LED color identifies the line condition.

a. GREEN indicates a clear line.

b. RED indicates a busy line.

c. Green with a flashing RED indicates a ringing line.

Battery replacement

Open the battery cover and replace the battery as needed.

You, as the end user, are legally bound (Battery ordinance) to return all used batteries

and accumulators; disposal in the household garbage is prohibited!

You can hand over your used batteries / accumulators at collection points in your

community or wherever batteries / accumulators are sold!

Disposal: Follow the valid legal stipulations in respect of the disposal of the device at the

end of its lifecycle

Specifications

Power 9V battery (1 for transmitter and 1 for probe))

Dimensions Probe - 8.7x2x1.3" (220x50x32mm)

Transmitter - 2.6x2.7x1.1" (65x68x28mm)

Weight Probe 3.2oz (91g);

Transmitter3.2oz (91g)

www.extech.com

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

Indice

Altri manuali Extech Instruments Strumento di misura

Extech Instruments

Extech Instruments RF153 Manuale utente

Extech Instruments

Extech Instruments RH520 Manuale utente

Extech Instruments

Extech Instruments UV510-NIST Manuale utente

Extech Instruments

Extech Instruments AN340 Manuale utente

Extech Instruments

Extech Instruments SDL470 Manuale utente

Extech Instruments

Extech Instruments CO240 Manuale utente

Extech Instruments

Extech Instruments 407860 Manuale utente

Extech Instruments

Extech Instruments MA610 Manuale utente

Extech Instruments

Extech Instruments AM300 Manuale utente

Extech Instruments

Extech Instruments 380943 Manuale utente

Extech Instruments

Extech Instruments 407730 Manuale utente

Extech Instruments

Extech Instruments HD755 Manuale utente

Extech Instruments

Extech Instruments CO240 Manuale utente

Extech Instruments

Extech Instruments 461920 Manuale utente

Extech Instruments

Extech Instruments CO250 Manuale utente

Extech Instruments

Extech Instruments RPM10 Manuale utente

Extech Instruments

Extech Instruments AN300 Manuale utente

Extech Instruments

Extech Instruments MO210 Manuale utente

Extech Instruments

Extech Instruments 380460 Manuale utente

Extech Instruments

Extech Instruments HD300-NISTL Manuale utente

Extech Instruments

Extech Instruments 401036 Manuale utente

Extech Instruments

Extech Instruments HD750-NIST Manuale utente

Extech Instruments

Extech Instruments TKG250 Manuale utente

Extech Instruments

Extech Instruments Oyster 341350A-P Manuale utente

Manuali Strumento di misura popolari di altre marche

Suaoki

Suaoki D40 Manuale utente

Elster

Elster BK-G1.6 Manuale utente

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuale

Duratool

Duratool D03128 Manuale utente

Vega

Vega VEGAPULS 65 Manuale utente

Tonghui

Tonghui TH2618B Manuale utente

Tenmars

Tenmars TM-801 Manuale utente

MSR

MSR 145 Manuale utente

TPS

TPS WP-82 Manuale utente

ELMETRON

ELMETRON CP-511 Manuale utente

PCB Piezotronics

PCB Piezotronics 003C30 Manuale utente

Tenma

Tenma 72-10465 Manuale utente

Endress+Hauser

Endress+Hauser Proline Promag 50 Specifiche tecniche

Siemens

Siemens SITRANS F Coriolis FCT030 Manuale elenco delle parti

KLINGER

KLINGER CMF V Series Manuale utente

EXFO

EXFO FTB-2 Manuale operativo e di manutenzione

Keysight

Keysight M8290A Manuale utente

ADTEK

ADTEK MW-5 Manuale utente