Fakopp Bluetooth Caliper Manuale utente
Manual for
Bluetooth Caliper
2023
1
Contents
Introduction ................................................................. 1
Package content ........................................................... 2
Installation ................................................................... 4
Using the Bluetooth Caliper ........................................ 8
Maintenance .............................................................. 12
Contact ....................................................................... 13
Guarantee ................................................................... 13
Introduction
The Bluetooth Caliper is a tool that is capable of
quickly measuring distances between two points and
transferring the values to PC via Bluetooth. It speeds
up registering the sensor positions for Arborsonic3D
and ArborElectro, when the sensors are arranged in an
irregular shape.
2
Trunk shapes registered with caliper in ArborSonic
3D and in ArborElectro software.
Package content
Display unit with screen, battery and electronics
3
Measuring arms ending in pins
Extension arms (optional)
Textile case
Charging cable (USB)
Manual
Wrench 28
4
Installation
Installing the Bluetooth unit of the caliper is very
similar to the installation of the Bluetooth unit of the
ArborSonic 3D or ArborElectro.
Check if Bluetooth is enabled on your PC.
(Some computers have an external button to turn
Wireless communication on and off.)
Turn on the caliper by
pressing its button once. For
about 6 seconds ’- - - -’ is
displayed which shows that
booting up is in progress. When numbers appear,
the caliper is ready to be used.
Go to the control panel or taskbar of your
Windows PC. Click the Bluetooth icon and
select Add Device, then select Add Bluetooth or
other device and Bluetooth.
5
6
Wait for Caliper to appear in the list and select
it. You may have to enter the security PIN code
which is 1234.
After pairing check the newly installed COM
ports by clicking More Bluetooth options (you
may have to scroll down), then click COM Ports,
and then look for an Outgoing port with Caliper
in the name.
7
8
Setting up the caliper in ArborSonic 3D
o Go to the settings with
the wrench icon
o select Bluetooth
Caliper.
o Select the Caliper COM port
o
Using the Bluetooth Caliper
The two arms of the caliper need to be inserted into the
slots on the main part. The arms and extension arms are
color-coded, the right arm has a yellow mark.
The Bluetooth caliper has two arms and can have two
extension arms. The distance will be measured between
9
the tips of the measuring arms. The caliper without
extension is capable of measuring up to 1100 mm
distance. With extension arms, measuring is possible
up to 1999 mm distance.
When using the extension arms make sure that the nut
on the end is fastened properly. Normally you can do
this by hand.
If the arms are still wobbly, use the enclosed wrench to
tighten the connection. Use only a minor force and be
careful when handling the wrench. Always hold the
other side of the connection by hand. Make sure to keep
the screws clean, if needed apply grease.
Measurement with the Bluetooth caliper
1. Switch on the caliper by pressing the yellow
button, wait for the boot up the finish, this takes
approximately 6 seconds.
2. Calibrate zero position by making the measuring
tips touch and then holding the yellow button for
5 seconds.
Indice
Altri manuali Fakopp Strumento di misura
