FDS FD70CV-M-C-6 Manuale utente

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 1 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Installation and Operation Manual

FD70CV-M-C-6

7” Widescreen LCD /Standard Arm

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 2 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Table of Contents

General Information....................................................................................................................3

Front View.....................................................................................................................................3

Specifications................................................................................................................................4

Installation Instructions .............................................................................................................4

Power..............................................................................................................................................4

Wiring Suggestions .....................................................................................................................5

Composite Wiring........................................................................................................................5

VGA Wiring ..................................................................................................................................6

Mounting and Base Information...............................................................................................7

Power and Ground Wiring.........................................................................................................7

Power/Video..................................................................................................................................8

Operation Instructions................................................................................................................9

Monitor Button Controls ............................................................................................................9

Technical Drawing.....................................................................................................................10

Technical Support......................................................................................................................11

Instructions for Continued Airworthiness ...........................................................................11

Warranty ......................................................................................................................................12

Log of Revisions.........................................................................................................................13

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 3 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

General Information

The FD70CV-M-C-6 is a special mission high-resolution panel mount 7” Widescreen LCD

on a pivoting, rotating arm. The LCD features NVG compatibility which can be switched

to day or night mode using the rocker switch conveniently located at the top of the

display. The FD70CV-M-C-6 will support 2 Composite video inputs, and VGA

connections.

The arm has both a hinge and a pivot point, and it can rotate 180° around the attach

point at the base and 180° at the bottom of the center of the LCD.

Front View

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 4 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Specifications

Display Type

7” TFT Color LCD /Standard Arm

Supported Resolutions

640x480 ~ 1024x768

Native Resolution

800x480

Display Brightness

800 cd/ m2

Contrast Ratio

500:1

Dimensions

6.80”(W) x 5.375”(H) x 1.535”(D)

LCD Dimension

6.00”(W) x 3.60”(H)

Weight

1 lb. 8 oz.

Viewing Angle

140°/120°

Power

28VDC @ .5 Amps

Operating Temperature

0-50° C (32-122° F)

PC Video Input

VGA (High Density DB-15 Receptacle

(Supplied w/Base))

Standard Video Input

2 Composite Video

Video Type Supported

NTSC, PAL

Screen Control

On-Screen Display Menu

Remote Control

IR, included

Materials

Aluminum

DO-160 Testing

Section 21, Category B

Installation Instructions

All cabin entertainment equipment, such as the FD70CV-M-C-6, should be installed on a

non-essential bus and have a dedicated circuit breaker. It is a requirement that a switch

be installed in the cockpit so that the pilot can de-energize the entertainment system

should it become necessary.

It is recommended that you leave approximately ¼ inch of space around the rear of the

display to have circulating air.

Power

This is a 12-28VDC monitor that requires 0.3 Amps (@28V) to 0.6 Amps (@12V) of

power to operate.

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 5 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Wiring Suggestions

All shields should be grounded to the connector at the source, and floating at the display.

Avoid routing video wiring parallel to:

AC wiring

Strobe wiring

DC motor supply cables

Inverter cabling

Or any other potential noise source.

Composite Wiring

Recommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax,

P/N V76261. This is a lightweight, flexible, and low signal loss cable which meets FAA

flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).

Similar aviation coaxial cable can be used from other vendors, as well.

Some aircraft are prone to AC noise - we recommend adding to the composite source a

75 Ohm video isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1

(www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the video

output of the source.

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 6 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

VGA Wiring

Recommended cable for VGA purpose is ECS P/N 453005. This is a single shielded

cable containing 5 separate coaxial cables, color-coded to match the functions of the

wires.

We recommend coax cables be terminated using solder sleeve coaxial cable terminators

such as Raychem Part Number CWT-4174-W122-5/9.

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 7 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Mounting and Base Information

The FD70CV-M-C-6 mates with a standard FDBASE( left); however, FDS Avionics Corp. has

various types of bases that maybe more suitable for your aircraft. Below are examples of the

FDBASE and FDBASE-W(right, wall mount):

The connector seats deeply in the mount, the secure High Density DB15 pin and connector can only

be connected one direction.

Power and Ground Wiring

22 AWG wire is recommended for Power and Ground applications.

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 8 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Power/Video

Pin out for High Density DB-15 Receptacle (Supplied w/Base)

Connector P/N: M24308/2-286 or Equivalent

Crimp Contacts P/N: M39029/57-354 or Equivalent

Number

Description

28VDC Power

28VDC Ground

N/C

Composite Video 1 - Signal

Composite Video 1 - Shield

N/C

Composite Video 2 - Signal

Composite Video 2 - Shield

Red Video (Pin 1 on Standard VGA)

Green Video (Pin 2 on Standard VGA)

Blue Video (Pin 3 on Standard VGA)

Red Ground (Pin 6 on Standard VGA)

Green Ground (Pin 7 on Standard VGA)

Horizontal Sync (Pin 13 on Standard VGA)

Vertical Sync (Pin 14 on Standard VGA)

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 9 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Operation Instructions

The FD70CV-M-C-6 is continuously on but can be de-energized by removing power from

the entertainment system. The user can change the video output from the FD70CV-M-C-

6 using the video source select switch on the LCD monitor. When power is applied, the

display will turn on and look for a valid input on the last known source. If no input is

found, the display will go to standby mode.

Monitor Control Buttons

Button

Function

Description

Document Number:

MAN –FD70CV-M-C-6

Rev:

Revision Date:

05/05/2017

Page 10 of 13

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Technical Drawing

Indice

Manuali Monitor popolari di altre marche

Linear Acoustic

Linear Acoustic LQ-1000 Manuale utente

AOC

AOC I2579V Manuale utente

Gateway

Gateway FPD1520 Manuale utente

Furuno

Furuno Mu 120c Manuale utente

Asus

Asus VB171D - 17" LCD Monitor Manuale utente

Dell

Dell S2230MX Istruzioni utente

Philips

Philips 107C64 Manuale utente

Dell

Dell S2409WFP Manuale utente

EverFocus

EverFocus EN-7517E Manuale utente

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuale utente

Dell

Dell Precision 7680 Manuale di istruzioni

LG 50PM1M - - 50" Plasma Panel Manuale utente

Bosch

Bosch DDU 9 Manuale utente

Acer

Acer A231HL Manuale utente

Philips

Philips 86BDL4152T Manuale utente

NEC

NEC AccuSync LCD5V Manuale utente

Emay

Emay SleepO2 Manuale utente

IBM

IBM 6360 Istruzioni per l'installazione