FDS FD141CV-C-6 Manuale utente

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 1 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Installation and Operation Manual

FD141CV-C-6

14” Day/NVG Monitor

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 2 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Table of Contents

General Information.................................................................................................................3

Front View..................................................................................................................................3

Additional Information ...........................................................................................................3

Specifications.............................................................................................................................4

Installation Instructions ..........................................................................................................4

Power...........................................................................................................................................5

Wiring Suggestions ..................................................................................................................5

Composite Wiring.....................................................................................................................5

Power and Ground Wiring......................................................................................................6

Power/Video Pin Out ...............................................................................................................7

HDSDI Pin Out .........................................................................................................................8

Operation Instructions.............................................................................................................9

Button Control ...........................................................................................................................9

Accessing the Menu Systems................................................................................................10

User Menu’s ...................................................................................................................... 10- 23

Technical Drawing Monitor Only .......................................................................................24

Technical Drawing –Co-Pilot Position ..............................................................................25

Technical Drawing –Pilot Position.....................................................................................26

Portrait Co-Pilot.......................................................................................................................27

Portrait Pilot ............................................................................................................................28

User Instructions for Attaching Arm Support......................................................... 29 & 30

Maintenance and Inspections...............................................................................................31

Technical Support...................................................................................................................32

Instructions for Continued Airworthiness ........................................................................32

Warranty ...................................................................................................................................33

Log of Revisions......................................................................................................................34

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 3 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

General Information

The FD141CV-C-6 is a special mission 14” night vision/sunlight readable widescreen

monitor.

Built with retrofit aircraft integration in mind, the display can switch between three video

sources using the front button controls. The display includes a daylight/NVG rocker

switch mounted on the front bezel. Additional functions can be added using the 8 bezel

keys; 4-buttons on each side located on the front face of the bezel. These functions are

generated by the mission computer via USB connection through the circular 22-pin

connector.

Front View

Additional Information

The FD141CV-C-6 utilizes a state of the art digital video decoding chipset for video input.

The available video sources are HDSDI (High Definition SDI), VGA (Computer Video,

such as a Moving Map) and Composite Video (Camera, Standard Definition DVD).

The LCD is protected with a .060” non-glare Lexan lens to prevent scratching of the LCD,

and to meet stringent FAA abrasive load criteria.

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 4 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Specifications

Display Type

14.1” TFT Color LCD

Display Color

262K Colors

Screen Resolution

XGA 1024 x 768

Display Size

14.7”(W) x 9.7”(H) x 1.7” (D)

Weight

6 lbs. 9 oz.

Power

28V DC @ 2.0 Amps

Operating Temperature

0-50° C (32-122° F)

Video Input (via TVS06RF-13-35P)

HDSDI, VGA, Composite Video

Video Type Supported

NTSC/PAL

Screen Control

On Screen Display Menu

Materials

Aluminum

Certifications

Mil-STD 704 –Table IV for 28VDC

Altitude –MIL-STD-810F, Method 500.4, Procedure

II (Operation)

Low Temperature –MIL-STD-810F, Method 502.4,

Procedure II (Operation)

Humidity –MIL-STD-810F, Method 507.4, Procedure

II (Aggravated)

Vibration Performance –MIL-STD-810E, Method

514.4, Procedure I, Category 4

Shock –MIL-STD-810E, Method 516.4, Figure

516.4-4, Procedure I (Functional Shock)

Shock –MIL-STD-810E, Method 516.4, Figure

516.4-4, Procedure V (Crash Safety)

The

Explosive Atmosphere - RTCA-DO-160G, Sec 9.6.2

Cat E

Solar Radiation –MIL-STD-810F (N3) Method 505.4,

Procedure I, Cycle A1

High Temperature Operation –MIL-STD-810F (N3)

Method 501.4, Procedure II

Rapid Decompression –MIL-STD-810F (N3) Method

500.4, Procedure III,

Conducted Susceptibility MIL-STD-461F (N3)

Method 505.4, Procedure I, Cycle A1

Solar Radiation –MIL-STD-810F (N3) Method 505.4,

Procedure I, Cycle A1

Installation Instructions

All cabin equipment, such as the FD141CV-C-6, should be installed on a non-essential

bus and have a dedicated circuit breaker.

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 5 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Power

This is a 28VDC monitor that requires 2.0 Amps of power to operate. The unit turns on

automatically upon power application. See Power and Ground Wiring below for more

details.

Wiring Suggestions

Avoid routing video wiring parallel to:

AC wiring

Strobe wiring

DC motor supply cables

Inverter cabling

Or any other potential noise source

Composite Wiring

Recommended cable for composite and audio purposes is PIC 75 Ohm Coax, P/N

V76261. This is a lightweight, flexible, and low signal loss cable which meets FAA

flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).

Similar aviation coaxial cable can be used from other vendors, as well. Some aircraft are

prone to AC noise - we recommend adding to the composite source a 75Ohm video

isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1

(www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the video

output of the source.

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 6 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Power and Ground Wiring

The rated current of the equipment and associated voltage drop should be taken into

consideration when selecting wire gauge. The following example is based on an install with a

28VDC power system, 1.5 amp equipment load and a total of 50 feet of wire between the

circuit breaker, monitor and ground.

Example: 22awg wire has 16.2 Ohms per 1000 feet, this equates to .81 Ohms for 50 feet.

1.5 Amp of current on .81 Ohms will drop 1.22 Volts.

Resistance of Wire Type M22759/16-**

(** = Gauge)

Gauge (AWG)

OHMS/1000’

26.20

16.20

9.88

4.81

2.02

1.26

.701

Also, use short heavy gauge wire and a clean tight connection for ground.

It is the installer's responsibility to understand the product's requirements in order to install the

product in compliance with industry standards and safety.

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 7 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Power/Video

Pin out for 22 PIN Circular Connector

CONNECTOR P/N: TVPS00RF-13-35S

CONTACT P/N: M39029/58-360

STRAIN RELIEF P/N: M85049/38S13N

MATING FACE

Number

Description

28 VDC Power

28 VDC Ground

USB Data + (Green)

USB Data –(White)

USB Shield

Composite Video –Shield

Composite Video –Signal

N/C

Horizontal Sync (Pin 13 on Standard VGA)

Sync Ground (Pin 10 on Standard VGA)

Red Video (Pin 1 on Standard VGA)

Green Video (Pin 2 on Standard VGA)

Blue Video (Pin 3 on Standard VGA)

Blue Ground (Pin 8 on Standard VGA)

USB + 5VDC (Red)

USB Ground (Black)

N/C

Vertical Sync (Pin 14 on Standard VGA)

Red Ground (Pin 6 on Standard VGA)

Green Ground (Pin 7 on Standard VGA)

N/C

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 8 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

HDSDI (INPUT)

CONNECTOR P/N: Amphenol 112235

Description

Center

Video Signal

Shell

Video Return

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 9 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Operation Instructions

The FD141CV-C-6 is continuously on but may be de-energized by removing power from

the display system. No pilot or aircrew action is necessary during flight or ground

operation.

When applying 28VDC power, the display will turn on and look for a valid input. If no

input is found, the display will go to standby mode. The operator will be able to change

the video output from the FD141CV-C-6 using the video source select switch on the LCD

monitor.

Button Controls

Located on the bottom front of the FD141CV-C-6 are 8 buttons, and a backlit NVG

Rocker Switch. Functionality for these buttons are as follows:

BUTTON

DESCRIPTION

Activates the OSD menu or goes to previous menu.

Moves the highlight icon down to the function that user

wants.

Moves the highlight icon up to the function that the user

wants.

Moves the highlight icon left to the function that the user

wants.

Moves the highlight icon right to the function that the user

wants.

Auto-adjusts the display’s size and position.

Cycles through source inputs.

Powers monitor on and off.

Rocker

Switch

This rocker switch, switches between daylight and night

vision.

Document Number:

MAN –FD141CV-C-6

Rev:

Revision Date:

04/27/2017

Page 10 of 34

TECHNICAL SUPPORT

470-239-7421 or FDSAvionics.com

Accessing the Menu System

With the OSD (On Screen Display) off, push the MENU

button to activate the main OSD menu.

Press the UP or DOWN buttons to move from one function to another. As you

move from one icon to another, the function name changes to reflect the

function or group of functions represented by that icon.

Press the MENU button once to return to the main menu to select another

function or press twice to exit from the OSD.

To save the setting values, exit the OSD menu.

Image Menu

Brightness

Adjust to brighten or darken the picture.

Contrast

Adjust to increase or decrease picture contrast.

Saturation

Adjust to increase or decrease - a greater saturation will

have vivid color; a level of zero will reduced the picture to

shades of grey.

Hue

Adjust to increase or decrease the level of color in the

picture.

Sharpness

Adjust to sharpen or soften the picture.

Indice

Manuali Monitor popolari di altre marche

Linear Acoustic

Linear Acoustic LQ-1000 Manuale utente

AOC

AOC I2579V Manuale utente

Gateway

Gateway FPD1520 Manuale utente

Furuno

Furuno Mu 120c Manuale utente

Asus

Asus VB171D - 17" LCD Monitor Manuale utente

Dell

Dell S2230MX Istruzioni utente

Philips

Philips 107C64 Manuale utente

Dell

Dell S2409WFP Manuale utente

EverFocus

EverFocus EN-7517E Manuale utente

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuale utente

Dell

Dell Precision 7680 Manuale di istruzioni

LG 50PM1M - - 50" Plasma Panel Manuale utente

Bosch

Bosch DDU 9 Manuale utente

Acer

Acer A231HL Manuale utente

Philips

Philips 86BDL4152T Manuale utente

NEC

NEC AccuSync LCD5V Manuale utente

Emay

Emay SleepO2 Manuale utente

IBM

IBM 6360 Istruzioni per l'installazione