Table 6: Naming Conventions for Appliance BFN630XL
Product Name Appliance
Label Product Descriptor Appliance Identifier
NS700CA Ultra High
Performance Control and
Application Server
NS700CA FortiNac Server SYS-BFN630XL-NS700CA
NS2000C Ultra High
Performance Control Server
NS2000CA FortiNac
Control Server
SYS-BFN630XL-NS2000C
NS2000A Ultra High
Performance Application
Server
NS2000CA FortiNac Application
Server SYS-BFN630XL-NS2000A
Ethernet Connections
Each Ethernet port is used for a different purpose during initial configuration and normal
operation. The following table provides details on the options for each appliance type and its
corresponding Ethernet ports.
Note: Manual configuration is required for eth2. The eth3 or fourth interface is reserved for future
use. Contact Customer Support for assistance.
Table 7: Ethernet Connections
Appliance Product Port Port Used During Initial (Basic Network) Configuration
BFN320
BFN330
BFN620
BFN630
All Products eth1 Used temporarily during configuration until the IP address,
mask, default gateway, and host name are setup.
Configuration Wizard DHCP Service—Disabled once
appliance is rebooted (or shutdown and restarted).
Appliance Product Port Port Used During Normal Operations (After Basic
Network Configuration Complete)
BFN320
BFN330
BFN620
BFN630
All Products eth0 Management
FortiNac Server eth1 Isolation networks, such as Registration or Remediation.
FortiNac
Application Server
eth1 Isolation networks, such as Registration or Remediation.
FortiNac Control Server eth1 Either DHCP detection or not used.
FortiNac Control Manager eth1 Not used.
FortiNac Server eth2
Rogue DHCP detection, additional isolation networks (for
example, Remote Registration and Remote Scan), access
point management, or not used.
FortiNac
Application Server
eth2 Additional isolation networks (for example, Remote
Registration and Remote Scan), access point
management, or not used.
3
