GIR1002 FR / GIA1000 FR Connecting and Operating Manual Version: 4.03-3 page: 6
Operation
Start-up
As soon asthe supply voltage has been applied the GIR1002 FR will carry out a ssystem test for
approx. 8s. Then thecurrent measuringvalue will be displayed.
Table of Functions
The various functionsare called up/input by meansof the4 buttons located at the front side of the
device. We would like to point out that depending on the output configuration (also refer to chapter
‘configuration’)onlyacertainnumberof functionswill beavailable.
Thefollowingtable shows all thefunctionsof theGIR1002FR. Therighthandcolumn
indicatesthecontrollerconfigurationforthevariousfunctions. Output
Functions To be called up by configuration
-------------------------------------------------------------------------------------------------------------------------------------
displayof current measuring value: briefly pressing button 4 0 .. 8
set tara function: briefly pressing button4 optional
alarm reset: pressing button 4 for 4 s 2,3,5,6
tarafunction reset: pressing button 4 for 4 s optional
displayof max.value: briefly pressing button 2 0 .. 8
max. valuereset: pressing button 2 for 4 s 0 .. 8
displayof min.value: briefly pressing button 3 0 .. 8
min. valuereset: pressing button 3 for 4 s 0 .. 8
Switching point output 1
display/setting of making point: button 1 .. 4 1,2,3,7
display/setting of switching point: button 1 .. 4 4,5,6,8
display/setting of breaking point: button 1 .. 4 1,2,3,7
display/setting of hysteresis: button 1 .. 4 4,5,6,8
Switching point output 2
display/setting of making point: button 1 .. 4 1
display/setting of switching point: button 1 .. 4 8
display/setting of breaking point: button 1 .. 4 1
display/setting of hysteresis: button 1 .. 4 8
Alarm
display/setting of max. alarm limit: button 1 .. 4 2,3,5,6
display/setting of min. alarm limit: button 1 .. 4 2,3,5,6
display/setting of alarm delay: button 1 .. 4 optional (2,3,5,6)
Display of current measuring value or acitvate tara function
To be called up by: briefly pressing button4
Note: If thecontroller isset to the function “display of max. value“respectively
“display of min. value“, pressing of button 4 will result in the display
switching over to showthecurrent measuringvalue. If the current
measuring value is already on display, pressing of button 4 results in a
reset of the tarafunction.
Display: the current measuring valueis shown on the 7-segment display
LED “1”: gives status of relay 1
LED “2”: gives status of relay 2
LED flashing: relay contact made
LED not flashing: relay contact broken
LED “ALARM”: LEDflashing in case of alarm.
LED “min”: LEDflashingincase of MINalarm.
LED“max.”: LEDflashing in caseof MAXalarm.
LED“CAL”: LEDflashingincase of tarafunctionbeing active
