Hamilton Beach 840111900 Manuale utente

840111900

Iron

English .............................. 2

USA: 1-800-851-8900

Canada : 1-800-267-2826

This product is intended for household use only.

This appliance is equipped with a polarized plug. This type of plug

has one blade wider than the other. The plug will fit into an electrical

outlet only one way. This is a safety feature intended to help reduce

the risk of electrical shock. If you are unable to insert the plug into

the outlet, try reversing the plug. If the plug should still fail to fit,

contact a qualified electrician to replace the obsolete outlet. Do

not attempt to defeat the safety purpose of the polarized plug by

modifying the plug in any way.

When using your flat iron, basic safety precautions should always be

followed, including the following:

1. Read all instructions.

2. Use iron only for its intended use.

3. To protect against risk of electric shock, do not immerse the iron

in water or other liquids.

4. The iron should always be turned to OFF before plugging

or unplugging from outlet. Never yank cord to disconnect from

outlet; instead, grasp plug and pull to disconnect.

5. Do not allow cord to touch hot surfaces. Let iron cool completely

before putting away. Loop cord loosely around iron when storing.

6. Always disconnect iron from electrical outlet when filling with

water or emptying and when not in use.

7. Do not operate iron with a damaged cord or if the iron has been

dropped or damaged. To avoid the risk of electric shock, do not

disassemble the iron. Contact an authorized service facility for

information on examination and repair. Incorrect reassembly can

cause a risk of electric shock when the iron is used.

8. Close supervision is necessary for any appliance being used by

or near children. Do not leave iron unattended while connected

or on an ironing board.

9. Burns can occur from touching hot metal parts, hot water, or

steam. Use caution when you turn a steam iron upside down –

there may be hot water in the reservoir.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage

appliance on the same circuit.

2. If an extension cord is absolutely necessary, a 10-ampere cord

should be used. Cords rated for less amperage may overheat.

Care should be taken to arrange the cord so that it cannot be

pulled or tripped over.

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!

CONSUMER SAFETY INFORMATION

Parts and Features

1. Reset Button*

2. Automatic Shutoff/Power Light

3. Spray and Blast Buttons*

4. Adjustable Steam Switch

5. Flip Open Water Tank Cover

6. Water Tank

7. Temperature

Control Dial

8. Soleplate

9. Heel Rest

10. Swivel Cord

* Featured on selected models

Before First Use

• Steam vents should be cleaned before first use. Prepare iron

for steam ironing, then iron over an old cloth for a few min-

utes while letting the iron steam. This will clean the vents.

• Many irons spit or sputter during the first few uses with

tap water. This happens as the steam chamber becomes

conditioned. This will stop after a few uses.

• During first use of the iron, it may appear to smoke.

This will stop and does not indicate a defect or hazard.

To Dry Iron

1. Plug in iron.

2. Turn the Adjustable Steam Switch to the Dry Iron position.

3. Turn the Temperature Control Dial to desired temperature.

Allow 3 minutes for iron to reach desired temperature.

4. To turn iron off, turn Temperature Control Dial to OFF.

To Steam Iron

1. Unplug iron. Flip open water tank

cover. Using a cup, slowly pour

8 ounces of tap water into the

water tank opening as illustrated.

2. Plug in iron.

3. Turn the Temperature Control Dial

to the desired setting in the steam

range. With the iron in an upright

position, allow 3 minutes for the

iron to reach desired temperature.

Do not preheat the iron with the soleplate facing down.

4. Set the Adjustable Steam Switch to desired steam output.

5. To turn iron off, turn Adjustable Steam Switch to Dry Iron.

Turn Temperature Control Dial to OFF.

6. Empty water from the iron following directions in “Caring

for Your Iron and Soleplate.”

Water

Please use ordinary tap water. If you have extremely hard

water, alternate between tap water and distilled water for

use in the iron.

Features (on selected models)

Adjustable Steam Switch

This switch provides minimum steam

for wool or maximum steam for linen.

Set the switch to Oto change to Dry

Iron.

Spray and Blast Buttons

Push Blast Button for an extra blast

of steam. Push Spray Button to

release a fine spray of water for

difficult wrinkles in cotton or linen.

Automatic Shutoff Light and

Reset Button

If the iron is an Automatic Shutoff

model, the light comes on when the

iron is first plugged in. After 1 hour

the iron will shutoff and the light will

go out. Push the Reset Button to

turn the iron back on for another

hour of ironing.

Vertical Steam

1. Unplug iron. Flip open water tank

cover. Using a cup, slowly pour

8 ounces of tap water into water

tank opening.

2. Plug iron into outlet.

3. Turn the Temperature Control Dial

to highest setting.

4. Allow three minutes for the iron to

reach desired temperature.

5. Hang garment in a location that is not susceptible to

damage from heat or moisture. Do not hang in front of

wallpaper, window, or mirror.

6. Hold iron about 6 inches away from garment and press

and release the Blast Button to steam out wrinkles. Do not

press the Blast Button more than once every 2 seconds.

7. To turn iron off, turn Temperature Control Dial to Off.

Unplug iron.

8. Empty water from the iron following directions in “Caring

for Your Iron.”

NOTE: Do not allow hot soleplate to touch delicate garments.

Features (on selected models)

Fabric Setting Chart

To Iron

Off

Nylon

Acrylic

Silk

Polyester

Wool

Rayon

Cotton

Linen

Ironing Instructions

Steam

Setting

Dry iron on the wrong side of the fabric.

Iron with fabric still damp.

Steam iron on the wrong side of fabric.

Iron on the wrong side of fabric.

Iron while still damp using steam

and/or spray.

Iron on wrong side of fabric while still

damp.

Power Light

Models that do not have the auto-

matic shutoff and the reset button,

do have a power light. This light

comes on when the iron is plugged

in. The light will remain on even if

the Temperature Control Dial is

turned to off. The light will stay on

until iron is unplugged.

Caring for Your Iron and Soleplate

1. The Water Tank of your iron should

be emptied after each use. Turn

Temperature Control Dial to OFF.

Unplug the iron and hold over a

sink. Turn iron upside down until

Water Tank Opening is parallel with

sink. Water will run out of water

tank opening.

2. After iron has completely cooled,

wrap cord loosely around the iron and store in an upright

position. Do not store iron laying flat on soleplate.

Soleplate

1. Never iron over zippers, pins, metal rivets, or snaps, as

these may scratch the soleplate.

2. To clean occasional build-up on the soleplate, wipe with

a sudsy cloth. Do not use abrasive cleansers or metal

scouring pads.

3. Always store iron upright in the heel rest position.

Troubleshooting

Won’t

heat

PROBLEM THINGS TO CHECK

Water is

leaking

Won’t

steam

Leaves

spots

• Is the iron plugged in and the outlet working?

Check the outlet by plugging in a lamp.

• Is the Temperature Control Dial turned to a

fabric setting?

• If automatic shutoff model, is light on? If not,

press Reset Button.

• Do not overfill the water tank.

• If steam ironing, is Adjustable Steam Switch in

a steam position, the Temperature Control Dial

in the steam range and did the iron have

enough time to preheat?

• If dry ironing, make sure the Adjustable Steam

Switch is in the DRY IRON position.

• Check the water level.

• Is the Adjustable Steam Switch in the STEAM

position?

• Has the iron had enough time to preheat?

• ALWAYS empty the water tank of the iron

after using. Water left in the tank may discolor

clothing and soleplate.

• If the iron cord should become twisted, unplug

iron and let cool. Hold iron cord in the middle

of entire length. Let plug and iron dangle freely

until cord uncoils. This will extend the life of

your iron cord.

Twisted

cord

LIMITED WARRANTY

This product is warranted to be free from defects in material and workmanship for a

period of two (2) years for Hamilton Beach Portfolio products or one (1) year for

Hamilton Beach products from the date of original purchase, except as noted below.

During this period, we will repair or replace this product, at our option, at no cost. THE

FOREGOING WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, WHETHER

EXPRESS OR IMPLIED, WRITTEN OR ORAL INCLUDING ANY WARRANTY OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ANY LIABILITY IS

EXPRESSLY LIMITED TO AN AMOUNT EQUAL TO THE PURCHASE PRICE PAID, AND

ALL CLAIMS FOR SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES ARE

HEREBY EXCLUDED. There is no warranty with respect to the following, which may be

supplied with this product: glass parts, glass containers, cutter/strainer, blades, and/or

agitators. This warranty extends only to the original consumer purchaser and does not

cover a defect resulting from abuse, misuse, neglect, use for commercial purposes, or

any use not in conformity with the printed directions. This warranty gives you specific

legal rights, and you may also have other legal rights which vary from state to state, or

province to province. Some states or provinces do not allow limitations on implied

warranties or special, incidental or consequential damages, so the foregoing limitations

may not apply to you.

If you have a claim under this warranty, DO NOT RETURN THE APPLIANCE TO THE

STORE! Please call our CUSTOMER SERVICE NUMBER. (For faster service please

have model, series, and type numbers ready for operator to assist you.)

CUSTOMER SERVICE NUMBERS

In the U.S. 1-800-851-8900

In Canada 1-800-267-2826

Web site address: www.hamiltonbeach.com

KEEP THESE NUMBERS FOR FUTURE REFERENCE!

Customer Service

If you have a question about your iron, call our toll-free

customer service number. Before calling, please note the model,

type, and series numbers and fill in that information below. These

numbers can be found on the bottom of your iron. This informa-

tion will help us answer your question much more quickly.

MODEL:_____________ TYPE:_____________ SERIES: _____________

02/03

AMILTON

EACH

ROCTOR

-S

ILEX

ROCTOR

-S

ILEX

ANADA

263 Yadkin Road

Southern Pines, NC 28387

Picton, Ontario K0K 2T0

840111900 Web site address: www.hamiltonbeach.com

Indice

Altri manuali Hamilton Beach Ferro

Hamilton Beach

Hamilton Beach Easy-Touch 14417 Foglio di istruzioni

Hamilton Beach

Hamilton Beach 14280 Manuale utente

Hamilton Beach

Hamilton Beach 14525 Manuale utente

Hamilton Beach

Hamilton Beach 17130 Manuale utente

Hamilton Beach

Hamilton Beach 14975 - Professional Iron Manuale utente

Hamilton Beach

Hamilton Beach 14505 Manuale del proprietario

Hamilton Beach

Hamilton Beach 14X60 - Expression Ergonomic Handle Iron Manuale utente

Hamilton Beach

Hamilton Beach 840154800 Manuale utente

Hamilton Beach

Hamilton Beach 840124900 Manuale utente

Hamilton Beach

Hamilton Beach 840101300 Manuale utente

Hamilton Beach

Hamilton Beach 14506 Manuale del proprietario

Hamilton Beach

Hamilton Beach 19801 Manuale utente

Hamilton Beach

Hamilton Beach 14210 Manuale del proprietario

Hamilton Beach

Hamilton Beach HIR750 DURATHON IRON Manuale utente

Hamilton Beach

Hamilton Beach 14978 Manuale del proprietario

Hamilton Beach

Hamilton Beach 840068700 Manuale utente

Hamilton Beach

Hamilton Beach Durathon 19901 Manuale del proprietario

Hamilton Beach

Hamilton Beach 14515 - Steam Storm Iron Manuale utente

Hamilton Beach

Hamilton Beach 840124300 Manuale utente

Hamilton Beach

Hamilton Beach 14515R Manuale utente

Hamilton Beach

Hamilton Beach Easy Touch Iron Manuale utente

Hamilton Beach

Hamilton Beach 14017 Manuale del proprietario

Hamilton Beach

Hamilton Beach 15410T Manuale utente

Hamilton Beach

Hamilton Beach 840087000 Manuale utente

Manuali Ferro popolari di altre marche

Clatronic

Clatronic DB 3703 Manuale utente

TEFAL

TEFAL FV4093Z0 Manuale utente

Gorenje

Gorenje SIH 2200 BS Manuale utente

Philips

Philips GC6012 Manuale utente

Bosch

Bosch 2 Series Manuale utente

Riffel

Riffel Catena KB-819 Manuale utente

Texi

Texi Hestia Manuale utente

Maxwell

Maxwell MW-3010 Manuale utente

TREVIDEA

TREVIDEA Girmi ST60 Manuale utente

Philips

Philips HI5914/30 Manuale utente

Primula

Primula Vapormat Manuale utente

Magio

Magio MG-541 Manuale utente

Scarlett

Scarlett SC-1334S Manuale utente

Bosch

Bosch Sensixx B22L Manuale utente

Philips

Philips GC651 Manuale utente

Vitek

Vitek VT-1247 VT Manuale utente

Cleanmaxx

Cleanmaxx 3397 Manuale utente

Philips

Philips GC800 Manuale utente