©Copyright 2011 by Henning GmbH & Co. KG
Rev. 1.2 10/2011 9
ii. Apply it by pressing . After that a countdown will be running
from 99999 to 00000. At 00000 the current weight of the
car will be measured. It goes without saying that at that moment
there must not be anything in the cabin or on the car roof that
does not belong there under normal operation conditions (tools!),
and that there must not stay any person in the cabin or on the car
roof in order not to warp the zero load parameter.
b. How to Adjust Full load
Take the following steps:
i. By navigate to menu-item CALib and select it by pressing
. Then navigate by to menu-item LoadC and select it
by pressing . After that adjust on the display an arbitrary load
to be loaded into the cabin. Unless you changed the standard of
menu-item Units enter this load in terms of a percentage of the
nominal load, i.e. 100% (100*o), if you are loading the nominal
load, or 75% (075*o) if you are going to load ¾ of the nominal
load only. As soon as you will have adjusted the last digit, the
whole figure will be flashing.
ii. Apply it by pressing . After that a countdown will be running
from 99999 to 00000. At 00000 the current weight of the
car including load will be measured. It goes without saying that at
that moment there must not be anything additional in the cabin or
on the car that does not belong there under normal operation
conditions (tools!), and that there must not stay any person in the
cabin or on the car roof in order not to warp the full load
parameter.
iii. As from now on calibration of the rope-sensors is completed and
in effect.
