Honeywell Galaxy 2 Series Manuale utente

Galaxy 2 Series 2-Way Voice Kit

The Galaxy 2 Series 2-Way Voice Kit consists of a TP800 2-way voice speaker-mic and an Audio

Terminal Board (part number A233). The 2-Way Voice Kit only operates with the Galaxy 2-44+.

The Galaxy 2 Series Audio Terminal Board is a connector that allows 2-way audio communication (speak

and listen) between the panel PCB and the Alarm Receiving Centre. The Audio Terminal Board is

connected to the TP800 speaker-mic which allows audio communication via the on-board PSTN/Modem

or the plug-on GSM module. The Audio Terminal Board is fitted to the main PCB at the location shown

in the diagram below.

Figure 1. Audio Terminal Board

Fitted to Audio Header

Warning: Make sure that all power is disconnected when working with the Audio Terminal Board.

Figure 2. TP800 Back-Plate

Illi

Installation Instructions

A. Audio Terminal Board

1. Fit the Audio Terminal Board to the pins of the audio header on the main PCB.

2. Make sure that the orientation of the Audio Terminal Board is the same as the illustration above.

B. TP800 Speaker-Mic

1. Remove the screw at the top that attaches the front cover to the back plate.

2. If necessary, carefully prise the top cover from the back plate with a screw driver.

3. Remove the knockout hole from the back plate.

4. Attach the TP800 back plate loosely to a wall using screws through the elongated attachment

holes. This will enable the wire from the Audio Terminal Board to be fed through from the back.

NOTE: The TP800 can be adjusted for audio levels. Refer to the instructions supplied with the

module for further information.

Wiring Instructions

The wires between the TP800 units must be no longer than 30 metres in total. The wiring from the Audio

Terminal Board to the TP800 speaker-mic is as follows:

AUDIO TERMINAL

BOARD

TP800

ECT ECOUT

RML RML

CMD CMD

NC NOT USED

VS+ VS+

VS- VS-

1. Wire the TP800 to the Audio Terminal Board as per the above table.

2. Finally secure the TP800 back plate to the wall through the elongated attachment holes.

3. Attach the TP800 front cover to the back plate by locating the bottom slot into the locating boss

and then snapping shut. Attach the screw to the top.

Operation of 2-Way Audio

Communication Modes

Two types of audio communication are possible: Listen-in (after alarm) or Dial-in.

Listen-in

In this mode, the panel will stay on-line for 30 seconds after sending an alarm signal to the ARC to allow

the operator to listen to the audio on site. The operation is controlled by the remote DTMF telephone and

is as follows:

1. Press the *then 6 keys to start listen-in.

2. Use the 0and 1keys to toggle between listen and talk modes (0 = listen, 1 = talk).

3. To end the call, press the *then #keys.

4. The call ends with three beeps.

Dial-in

In this mode, a user can dial into the alarm system from a DTMF telephone and type in a special PIN

code (controlled in Menu 42, User 99). This will allow the user to listen to the audio on site, and talk to

the site. The operation is controlled by the remote telephone and is as follows:

1. Dial in to either the PSTN number or the GSM audio number.

2. The panel answers after the number of rings set up in Menu 56.1.09.

3. Wait for a long tone then enter the PIN code to start listening.

4. Use the 0and 1keys to toggle between listen and talk modes (0 = listen, 1 = talk).

5. To end the call, press the *then #keys.

6. The call ends with three beeps.

In both modes, if no commands are detected within 2 minutes the call will be timed out and hung up. If

the remote user hangs up without using *and #then it can take up to 2 minutes before the call times out

at the panel end.

II1-0084 Rev 1.0

Altri manuali per Galaxy 2 Series

Indice

Altri manuali Honeywell Unità di controllo

Honeywell

Honeywell CentraLine CLIOL822A Manuale operativo

Honeywell

Honeywell RV283P Manuale utente

Honeywell

Honeywell FIRE-LITE ALARMS TS540/1 Manuale utente

Honeywell

Honeywell Braukmann FD300 Manuale utente

Honeywell

Honeywell Silent Knight SK-Monitor Manuale utente

Honeywell

Honeywell XW100 Manuale utente

Honeywell

Honeywell PEHA 952 JRM Manuale utente

Honeywell

Honeywell SLATE R8001S9001 Manuale utente

Honeywell

Honeywell Elster Jeavons S200 Manuale utente

Honeywell

Honeywell SOMAT39 Manuale utente

Honeywell

Honeywell MI-DCMOE Manuale di istruzioni

Honeywell

Honeywell SG160S Manuale utente

Honeywell

Honeywell 7800 SERIES Manuale utente

Honeywell

Honeywell AlarmNet 7845i-GSM Istruzioni per il montaggio

Honeywell

Honeywell L5000-Wi-Fi Manuale utente

Honeywell

Honeywell Resideo ADEMCO 4101SN V-Plex Istruzioni per il montaggio

Honeywell

Honeywell RV280 Manuale utente

Honeywell

Honeywell BCU 370 Manuale

Honeywell

Honeywell ControlEdge 900 platform Manuale utente

Honeywell

Honeywell V100P Manuale utente

Honeywell

Honeywell RV284 Manuale utente

Honeywell

Honeywell Kromschroder TC 1 Manuale utente

Honeywell

Honeywell 5496 Istruzioni operative

Honeywell

Honeywell NOTIFIER XP10-M Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente