HP LaserJet 9000 Manuale utente

Internal Peripherals Installation Guide

D Class and R Class

HP 9000 Enterprise Servers

Part No. A3262-90005

Edition 5

October 1998

E1098

Printed in: USA

Legal Notices

The information in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this

manual, including, but not limited to, the implied warranties of

merchantability and fitness for a particular purpose. Hewlett-Packard

shall not be held liable for errors contained herein or direct, indirect,

special, incidental or consequential damages in connection with the

furnishing, performance, or use of this material.

Restricted Rights Legend. Use, duplication or disclosure by the U.S.

Government is subject to restrictions as set forth in subparagraph (c) (1)

(ii) of the Rights in Technical Data and Computer Software clause at

DFARS 252.227-7013 for DOD agencies, and subparagraphs (c) (1) and

FAR 52.227-19 for other agencies.

HEWLETT-PACKARD COMPANY

3000 Hanover Street

Palo Alto, California 94304

U.S.A.

rights reserved.

Reproduction, adaptation, or translation of this document without prior

written permission is prohibited, except as allowed under the copyright

laws.

Trademark Notices UNIX is a registered trademark in the United

States and other countries, licensed exclusively through X/Open

Company Limited.

Contents

iii

1. D Class Internal Peripherals Installation

Internal Peripherals Installation Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Installation Procedures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Peripherals Installation Verification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-21

Peripherals Installation Verification Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . 1-22

2. R Class Internal Peripherals Installation

Internal Peripherals Installation Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Installation Procedures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Peripherals Installation Verification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-18

Peripherals Installation Verification Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . 2-19

Contents

Printing History

The manual printing date and part number indicate its current edition.

The printing date will change when a new edition is printed. Minor

changes may be made at reprint without changing the printing date. the

manual part number will change when extensive changes are made.

Manual updates may be issued between editions to correct errors or

document product changes. To ensure that you receive the updated or

new editions, you should subscribe to the appropriate product support

service. See your HP sales representative for details.

First Edition: October, 1995

Second Edition: May, 1996 (European, Localized)

Third Edition: May, 1996

Fourth Edition: August, 1998

Fifth Edition: October, 1998

NOTE Reader Comments. We welcome your comments about our

documentation. If you have editorial suggestions or recommended

improvements for this document, please write to us. You can reach us

through e-mail at: hardwaredocs@cup.hp.com or by sending your letter

to: Documentation Manager M/S 5657, Hewlett-Packard Company, 8000

Foothills Blvd., Roseville, CA 95747-6588 USA. Please include the

following information in your message:

• Title of the manual you are referencing.

• Manual part number (from the title page).

• Edition number or publication date (from the title page).

•Yourname.

• Your company’s name.

SERIOUS ERRORS, such as technical inaccuracies that may render a

program or a hardware device inoperative, should be reported to your HP

Response Center or directly to a Support Engineer.

Who Should Use this Guide

The procedures in this guide are intended to be performed by a person

who is qualified in the installation and servicing of computer equipment,

and is trained to recognize the hazards involved. Internal peripherals are

installed in an area of the product where energy levels considered

hazardous may be produced.

1-1

1 D Class Internal Peripherals

Installation

Internal Peripherals Installation

Overview

CAUTION If you are adding the Fast/Wide SCSI (Hot-Swap) option to a Model D2xx

server (step K in the list below), you must perform a full system backup

before starting the installation procedures.

NOTE Fast/Wide SCSI (Hot-Swap) disks are standard on Model D3xx servers,

and are available as an option on Model D2xx servers. The hot-swap disk

capability allows you to add Fast/Wide SCSI disks while power is on.

To install internal peripherals (other than Fast/Wide SCSI disks), you

must turn off system power, and open the server cabinet to gain access to

the cabinet interior. An overview of the procedures is given below:

A. Install Fast/Wide SCSI (hot-swap) disks.

B. Turn off power to the system.

C. Remove the front bezel.

D. Remove the side panel.

E. Remove the EMI cover.

F. Configure your peripheral, if necessary.

G. Select the peripheral slot in the cabinet.

H. Install the IDE floppy drive.

I. Install removable media drives (CD-ROM, DDS or quarter-inch tape

drives).

J. Install Single-Ended SCSI disks (Model D2xx only).

K. Install the Fast/Wide SCSI (hot-swap) disk option (Model D2xx only).

L. Replace the EMI cover.

M. Replace the side panel.

N. Replace the front bezel.

1-2 Chapter1

D Class Internal Peripherals Installation

Internal Peripherals Installation Overview

Aftercompletingthe installationprocedures, proceed to the Peripherals

Installation Verification section (located after the installation

procedures) for instructions on how to verify that internal peripherals

have been correctly installed.

Required Tools • Small flat-bladed screwdriver

• Torx driver, #15

• Torx driver, #10

• Phillips screwdriver

Safety Considerations

WARNING Turn off the system power and disconnect the power cable before

opening the system cabinet. Otherwise, personal injury may

occur.

Electrostatic

Discharge Precautions Electrostatic discharge can damage the integrated circuits on printed-

circuit boards. To prevent such damage from occurring, be sure to

observe the following precautions when handling and installing boards:

• Use a grounding mat and an anti-static wrist strap, such as those

included in the ESD Field Service Kit (HP P/N A3024-80004).

• Wear the anti-static wrist strap to ensure that any accumulated

electrostatic charge is discharged from you body to ground.

• Keep uninstalled printed-circuit boards in their protective anti-static

bags until you are ready to install them.

• Handle printed-circuit boards by their edges after you have removed

them from their protective anti-static bags.

Chapter 1 1-3

D Class Internal Peripherals Installation

Installation Procedures

A. Install Fast/Wide

SCSI Disks Fast/Wide SCSI disks (or Hot-Swap disks) can be installed while system

power is ON or OFF.

CAUTION You must follow proper hot-swap procedures before adding or replacing a

Fast/Wide SCSI disk. Refer to the Hot-Swap Procedure Guide for hot-

swap procedures and information before performing the following

installation procedure.

NOTE The hot-swap capability (up to five disks) is standard on Model D3xx

servers, and is available as a two-disk option on Model D2xx servers. To

add the optional hot-swap capability to your D2xx server, refer to the

procedure described in step K of this manual, then return to step A to

add the hot-swap disks.

1. Unlock the peripheral door using the key that was shipped with your

server. Open the peripheral door.

2. Pull out the latch of the disk so that it is in the open position.

3. Insert the disk into the peripheral slot.

1-4 Chapter1

D Class Internal Peripherals Installation

Installation Procedures

4. Push the disk all the way into the slot. The disk locking latch should

click shut when the disk is completely inserted. If it does not click,

gently push in the latch until you hear or feel the latch click into

place.

5. After installing all disks, close the peripheral door.

6. If no more peripherals are to be added, lock the peripheral door with

the key.

Altri manuali per LaserJet 9000

Indice

Altri manuali HP Server

HP cc2300 Guida

HP Compaq 6720t Manuale utente

HP Cisco MDS 8/24c Manuale di istruzioni

HP Cisco MDS 8/12c Manuale di istruzioni

HP ProBook 4320t Manuale

HP Proliant DL580 Istruzioni utente

HP ProLiant DL38 Istruzioni operative e di sicurezza

HP Compaq Presario,Presario 4400 Manuale di istruzioni

HP Apollo 4200 Gen10 Istruzioni per l'installazione

HP ProLiant DL560 Manuale utente

HP ProLiant BL20p Manuale

HP ProLiant BL685c Generation 7 Istruzioni utente

HP ProLiant DL180se G6 Server Manuale

HP st5742 - Streaming Client Manuale utente

HP ProLiant BL495c Generation 6 (G6) Manuale utente

HP Integrity BL890c - i2 Server Guida rapida

HP rp7420 Manuale utente

HP DL385 - ProLiant - G5 Istruzioni utente

HP ProCurve 1600M Istruzioni per l'installazione

HP D7171A - NetServer - LPr Manuale utente

HP ProLiant DL580 G7 Istruzioni per il montaggio

HP T5135 - Compaq Thin Client Manuale utente

HP Cluster Platform Hardware Kits v2010 Manuale utente

HP ProLiant DL360 G9 Istruzioni di montaggio

Manuali Server popolari di altre marche

Dell

Dell PowerEdge R410 Manuale utente

PowerNAS

PowerNAS CMA Manuale utente

Supero

Supero FatTwin F617R3-FT Manuale utente

MSI

MSI P1-109N-L70 Manuale utente

Dell

Dell PowerEdge XE9640 Manuale

Dell

Dell PS4100 Istruzioni di montaggio

EtroVISION

EtroVISION EV3151 Manuale utente

NEC

NEC Express5800/T110j Manuale utente

Compaq

Compaq ProLiant 3000 Manuale

Dell

Dell PowerEdge 3YPMN Manuale utente

iRobo

iRobo IPC2U Manuale utente

Nortel

Nortel 1000 Con?guration guide Manuale utente

Asus

Asus AP7500 Manuale operativo e di manutenzione

Avid Technology

Avid Technology AirSpeed 5000 Manuale utente

Milestone

Milestone Husky IVO 350T Manuale utente

Planet

Planet NAS-7410 Manuale utente

Lenovo

Lenovo ThinkSystem SR635 V3 Manuale utente

Dell

Dell PowerEdge HS5610 Manuale