InFocus LP630 Manuale utente

Altri manuali per LP630

6

Questo manuale è adatto per i seguenti modelli

1

Indice

Altri manuali InFocus Accessori per proiettori

Manuali Accessori per proiettori popolari di altre marche

Optoma

Optoma BX-AL133B Manuale utente

PEERLESS

PEERLESS PE 1120 Guida

Osram

Osram SIRIUS HRI Series Manuale

Presentation Switchers

Presentation Switchers PS111 Manuale utente

Kramer

Kramer VIA GO Manuale utente

Yamaha

Yamaha PJL-112 Manuale elenco delle parti

Swedstyle

Swedstyle CL23AA02ZA25E Manuale utente

Mitsubishi Electric

Mitsubishi Electric 236CB Manuale del proprietario

Epson

Epson BrightLink 475Wi Manuale utente

Acer

Acer WP100 Manuale utente

i3

i3 i3board Manuale utente

CHIEF

CHIEF HB-43E Manuale utente

Biamp

Biamp Modena Hub Manuale di servizio

NEC

NEC MP10RX Manuale utente

Panamorph

Panamorph DCR-S3 Manuale utente

Exact solutions

Exact solutions FRAME-EVO-P10 Manuale utente

CHIEF

CHIEF VCM103S Manuale utente

Sharp

Sharp AN-PH20EZ Manuale utente

SP-CEIL-LM630

Projector Mount

INSTALLATION INSTRUCTIONS

qStep 1

Place warning label on lamp door where indicated. Invert the

projector and place it on a soft and flat surface.

Locate the four (4) 4 (mm) mounting points found on the bottom

of the projector. Secure the three (3) Quick release sleeves (D)

withthethree(3)4(mm)x16(mm)PhillipScrews(C)

(supplied). Align the keyhole openings from the mounting

bracket (B) to the sleeves (D) and secure the bracket with the

4 (mm) x 12 (mm) knurl knob(A) (supplied). Do not over

tighten!

See Figure 1

qStep 2

Install the base box securely to the ceiling structure in

accordance with proper commercial standards. Use

(commercially available) suitable hardware depending on the

installation requirements.

NOTE:If the (Optional) SP-LTMT-EXT adjustable height

suspension adapter is a part of the installation, securely install

the ceiling adapter to the ceiling at this time.

(Refer to its Installation Instructions)

qStep 3

Install the two (2) conical spacers (J) and two (2) flat washers (K), two

(2) hinge screws (L) loosely on both sides of the base box (H). Raise

the projector with the mounting bracket attached and slip though the

hinge pin slots openings on the bracket into the base box. Install the

two (2) angle locking screws (I) adjust the angle, lock it, and then

tighten the hinge pin screws.

See Figure 2

qStep 4

Check all the hardware for proper tightness and security. Do not

over tighten hardware.

PORTABLEPROJECTORS

(1) Remove the knurl knob screw and hold the projector with

two hands.

(2) Slide it backwards to detach the sleeves from the keyholes.

(3) Reverse the process for quick reinstall.

qStep 5

Raise the projector with the mounting bracket (B) and slip through the

hinge pin slot openings on the bracket into the base box (H). Loosely

install the two (2) hinge pin screws (L), conical spacers (J) and flat

washers (K) and the angle lockingscrews (I). Adjust the angle and lock

it. Then tighten the hinge pin screws (L). Donot overtighten

See Figure 3

Check all hardware for proper tighten and security.

-_LA 073001_-

The ceiling should be capable of supporting a weight of

at least five (5) times the projector(s) or monitor(s)weight.

If it cannot, the ceiling must be reinforced. Proper

installation procedure by qualified personnel as outlined

in the installation instructions must be adhered to.

Failure to do so could result in serious personal injury.

To prevent eye injury wear protective eyewear before

openinglamp door.

DESCRIPTION/HARDWARE

A.4 (mm) x 12 (mm) Knurl Knob (1ea)

B. SP-CEIL-LM630 Mounting Bracket (1ea)

C. 4 (mm) x 16 (mm) Phillip Screws (3ea)

D.4 (mm) Quick Release Sleeves (3ea)

E.Projector (not supplied)

F. Ceiling Structure (See Warning Label)

G. Suitable Hardware (Commercially Available)

H.Base Box/Jam Screw (1ea)

I. 6 (mm) x 12 (mm) Angle Locking Screws (2ea)

J. Conical Spacer (2ea)

K.FlatWashers(2ea)

L.6 (mm) x 12 (mm) Hinge Pin Screws (2ea)

M.SP-LTMT-EXT Adjustable Suspesion Adapter (Optional)

N. Suspension Adapter Ajustable Pins (2ea)

27700B S.W. Parkway Ave.

Wilsonville, Oregon 97070-9215

Phone 1-800-294-6400 Fax

www.infocus.com

For further in

formation or ordering assistance

contact us at the phone/address number shown

on the front of this page.