IWILL DPL533 Manuale utente

Overview

Hard ware

Installation

BIOS Setup

BIOS Flash

Utility

Troubleshooting

DPL533

User’s Guide

The information in this document is subject to change without notice

IWILL makes no warranty of any kind with regard to this material, including,

but not limited to, the implied warranties of merchantability and fitness for a

particular purpose.

IWILL shall not be liable for errors contained herein or for incidental or

consequential damages in connection with the furnishing, performance, or use

of this material.

IWILL assumes no responsibility for the use or reliability of its software on

equipment that is not furnished by IWILL

This document contains proprietary information that is protected by copyright.

All rights are reserved. No part of this publication may be reproduced,

transcribed, stored in a retrieval system, translated into any language or

computer language, or transmitted in any form whatsoever without the prior

written consent of IWILL

IWILLTM is the trademark of IWILL Corp.

Other products and companies referred to herein the trademarks or registered

trademarks of their respective companies or mark holders.

Printed in Taiwan

Revision Version: 1.00

Release Date: September 2002

Contents

OVERVIEW…………………………………………………..I

UNPACKING............................................................................................ I

FEATURES HIGHLIGHT ........................................................................... II

ABOUT THIS USER GUIDE .....................................................................IIV

GETTING HELP...................................................................................... V

DPL533 MOTHERBOARD (PICTURE) ..................................................... VI

DPL533 MOTHERBOARD (LAYOUT).......................................................VII

CHAPTER 1:HARDWARE INSTALLATION………..…1-1

Step 1:Jumper Setting………………………………………………….1-2

Step 2:Install Memory ......................................................................1-3

Step 3:Install CPU............................................................................1-5

Step 4:Attach Cable to Connectors .................................................1-7

Step 5:Install Expansion Cards......................................................1-16

Step 6:Powering on Your Computer ..............................................1-17

CHAPTER 2:BIOS SETUP…………………………….….2-1

Section 1:Main Menu……………………………………………..…….2-5

Section 2:Advanced Menu.............................................................2-13

Section 3:Power Menu...................................................................2-19

Section 4:Boot Menu .....................................................................2-21

Section 5:Exit Menu.......................................................................2-24

CHAPTER 3:BIOS FLASH UPGRADE UTILITY……...3-1

INSTALLATION………………………………...………………….....…….3-1

EXECUTING PHOENIX PHLASH16.EXE PROGRAM………………..………3-2

CREATE THE RECOVERY DISKETTE .....................................................3-2

UPDATING THE RECOVERY DISKETTE ..................................................3-3

APPENDIX A: SYMPTOM CHECKING LIST……….A-1

APPENDIX B: SYMPTOM REPORT FORM…….…...A-3

Overview

Thank you for choosing the IWILLTM DPL533 high performance Workstation

motherboard. The DPL533 is a dual Socket-604 motherboard (M/B) based on

the ATX form factor. As the latest Intel North Bridge Placer (MCH) with South

Bridge ICH4: PCI-X Bridge P64H2 is built in the M/B, DPL533 fully supports

Intel®Xeon (Prestonia) socket-604 processor at 533 MHz FSB (Front Side

Bus) frequency. In memory support, DPL533 provides four sockets for the

system memory. Users just simply choose Unbuffered DDR DRAM Module as

the system memory and the total maximum memory size can be up to 8GB

(Unbuffered ECC DIMM Support). Flexibility and expandability are always

concerned by IWILLTM, DPL533 contains two PCI-X slots one PCI-64 slots

and two PCI-32 slots for numerous add-on cards and provides Peer PCI

transaction support to increase system performance.

Other features such as onboard Promise PDC20271 IDE RAID interface

(optional)  Broadcom 5702 Ethernet controller AGP 8X six USB 2.0

connectors  Hardware Monitor (PC87366) function and Wake-On-LAN

function will provides an optimal platform for performance workstation

environments.

Unpacking

Remove all items from the box and make sure you have these following items:

If you discover damaged or missing items, please contact your retailer.

Remove all items from the box and make sure you have these following items:

❒ One IWILL DPL533 motherboard

❒ One ATA /66 IDE ribbon cable

❒ One Floppy ribbon cable

❒ One CD containing user’s manual, drivers and utilities

❒ One Broadcom 5702 Ethernet Controller User’s Guide

ii Overview

Overview

Features Highlight

Processor  Support dual Intel®Xeon (Prestonia)

Socket-604 CPUs at 533 MHz Host Bus

Interface

 Integrated VRM complies to spec 9.1

Chipset  Chipset E7505

 North BridgePlacer (MCH)

 South BridgeICH4

 PCI-X BridgeP64H2

Memory

Support

 Four DIMM sockets and support up to 8GB

memory size Unbuffered DDR DRAM

Module Support Single and Dual Channel

(144-bits wide) DDR memory interface

 Unbuffered ECC DIMM support

Onboard IDE

RAID

(optional)

 Dual Promise PDC20271 IDERAID Channels

 Two Channels and up to four drives

 ATA133 Compatible

 RAID Level 0, 1, 10

Onboard

LAN

 Broadcom 5702 Gigabit Ethernet Controller

(32bit)

Onboard

Multi-I/O

 NS super I/O (PC87366)

 Two serial ports with UART 16550

 One parallel port with ECP/EPP support

 Dual onboard USB 2.0 connectors; Four

extendable USB 2.0 connectors

 PS/2 mouse and keyboard connectors with

Wake-up function

iii

Overview

System

BIOS

 Phoenix BIOS

 I2C support

 Legacy USB 2.0 support

 MP 1.1 & 1.4 compliant

 SMBIOS 2.3 compliant

 DMI 2.0 compliant

 Soft Power-down

System Bus  533/400 MHz Data Bus Frequency

 Dual Channel (144-bits wide) DDR memory

interface

System

Management

 IWILLTM CheckUpTM to alert the event of

hardware problem

 Prevent from abnormal system down/data

loss

 Alert on LAN ready

 Remote system controller ready

Expansion

Slots

 Two PCI-X slotsone PCI-32 slots and one

PCI-64 slot

 One AGP 8X slot

Floppy Drive  Supports 3.5” (1.44MB or 2.88MB) floppy

drive and Japanese standard “Floppy 3

mode” (3.5” disk drive: 1.44MB, 1.2MB,

720KB) and LS-120 floppy disk drives (3.5”

disk drive: 120 MB). BIOS supports IDE

CD-ROM boot-up.

Dimension  ATX form factor with size: 12” * 10”

iv Overview

Overview

About This User Guide

This manual explains how to build your system with DPL533 in detail. Please

follow the procedures of this User’s Manual carefully and pay special attention

to these icons.

IMPORTANT

This icon informs you for particularly important

details regarding the setup or maintenance of

your system. While we point out the most vital

paragraphs in a chapter, you should always

read every word carefully. Failing to do so can

cause exasperation.

WARNING

This icon alerted you for potential dangers

during setting up your system with DPL533.

These warnings should not be regarded as the

whole of your safety regimen. Never forget that

computer are electronic devices and are

capable of delivering a shock. Prevent damage

to yourself and to your board: always ensure

that your system is turned off and unplugged the

power cords whenever you are working with it,

and that you are equipped

NOTE

This icon alerted you for notice during setting up

your system. It provides you can useful alert

during setting up a new system.

TIP

This icon will show you how to configure your

system with DPL533 in an easy and simple

ways. This icon always provides some useful

description to help you configure your system.

Overview

Getting Help

If a problem arises with your system during installation or OS operating, you

should ask your dealer for help first as your system has most likely be

configured by them. They always have the best idea and quick response for

your symptoms. If your dealer is near to your locations, you should bring your

system to them to have it quickly serviced instead of attempting to solve the

problem by yourself. Besides these, IWILL also provides some helpful

resources to help you.

1. Select IWILL

TM ‘s website at www.iwill.net and navigate to this product

page which contain links to product updates such as Jumper settings or

BIOS updates.

2. Any driver issue please visit IWILL TM ‘s website ate www.iwill.net to

download the driver you need.

3. FAQ sections on IWILL Website are often helpful since other user’s

questions are often your own.

4. Email us at: [email protected] and we will try to answer your questions

within 24 hours. Before you email your symptom to [email protected],

please fill in the symptom report form (page A-5) in order to let our

engineers solve your problem quickly.

vi Overview

Overview

DPL533 Motherboard (Picture)

2 PCI-32

Slots

1 PCI-64

slot

2 PCI-64

Slots

Floppy

Connector

IDE Connectors

IDERAID

Connectors

GP 8X

CPU 1

CPU 2

Main Power Connecto

8 Pin Power Connector 4 DDR DIMM Sockets

Indice

Altri manuali IWILL Scheda madre

Manuali Scheda madre popolari di altre marche

DFI

DFI SD170 Manuale utente

ASROCK

ASROCK ROMED8-2T Manuale utente

Asus

Asus P2L97A Manuale utente

Winmate

Winmate IC70 Manuale utente

Asus

Asus MES-B Manuale utente

Grantech

Grantech SYS8F377VGGA-3OMN Manuale utente

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuale utente

Gigabyte

Gigabyte GA-9IVDT Manuale utente

Texas Instruments

Texas Instruments ADS8372EVM Manuale utente

Commell

Commell MS-C73 Manuale utente

IBT Technologies

IBT Technologies MB860 Manuale utente

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuale utente

Biostar

Biostar M7VIT Bravo Istruzioni per l'uso e l'installazione

Intel

Intel D33217CK Manuale utente

Asus

Asus F1A55-M LX PLUS R2.0 Manuale utente

EPC

EPC EPC9147C Manuale utente

Asus

Asus EX-B760M-V5 D4 Manuale utente

EPOX

EPOX MU-8KHA0010 Manuale utente