Kolcraft Contours Options 3 Manuale utente
©2008 Kolcraft®Enterprises, Inc. S74-T-R3 9/08
Contours®Options®3 Wheeler Stroller Instruction Sheet
Hoja de instrucciones de la carriola Contours®Options®de 3 ruedas
Feuille d’instructions pour la poussette à 3 roues Contours®Options®
2
Avoid serious injury from falling or sliding out. Always use Restraint
System. Your child's safety depends on you. Proper stroller use cannot be
assured unless you follow these instructions. DO NOT USE STROLLER
UNTIL YOU READ AND UNDERSTAND THESE INSTRUCTIONS.
IMPORTANT SAFETY INFORMATION:
How to Keep Your Child Safe While Using this Stroller
•Adult Assembly Required.
•NEVER LEAVE YOUR CHILD UNATTENDED WHILE IN STROLLER.
Accidents can happen quickly while your back is turned. You must
always keep your child in view while your child is in the stroller,
even when sleeping. Do not use this product as a bed. Your child
may become tangled in straps or pads and suffocate.
•Always use restraint systemto keep child fromstanding up or
falling out of the stroller. Do not use product without full 5 point
harness restraint. Removing the shoulder straps will not adequately
restrain child.
•Always lock the stroller open before allowing your child in or near
the stroller.This prevents injuries caused by stroller collapsing.
•
Onlyuse this stroller with children who weigh less than 40 lbs. (18.1
kg)or are less than 40” (1 meter)tall,and who’s head rests below the
top of the seat back. Use by larger children may damage the stroller,
or cause a hazardous unstable condition to exist.
•Use this stroller in the reclined position until child can sit up
unassisted.
•Always set the wheel brakes when stroller is not moving,especially
on an incline.This prevents the stroller from rolling away.
•Always fasten the canopyonto the seat back when using the
stroller in the reclined position.
What to Avoid While Using this Stroller
•Always balance the weight of the stroller evenly. To prevent the
stroller from becoming unstable or tipping:
• Do not place parcels or accessory items on the stroller canopy,
seat, or over the handle.
• Do not put more than 10 lbs. (4.54 kg) in the basket.
• Do not allow children to play with or hang onto the stroller.
•Never use this stroller on stairways or escalators.
•DO NOT lift by front bar.
•Make sure children are clear of any moving parts if you adjust the
stroller, otherwise they may be injured.
WARNING
Continued on next page
3
•
THIS IS NOT AN EXERCISE STROLLER! Do not use this product while
running, jogging, in-line skating or participating in other athletic
activities.
•DO NOT put child in basket.
•Take care when folding and unfolding to prevent finger pinching.
• Product may become unstable if a parcel bag, other than the one
recommended by the manufacturer is used.
•DO NOT allow children to climb into stroller unassisted. Stroller
may tip over and injure child.
• Only use replacement parts supplied by the manufacturer.
How to Use this Stroller with Your Infant Car Seat
•AVOID SERIOUS INJURY FROM FALLS:
• DO NOT place carseat in stroller seat. Car seat will not be secure.
• DO NOT use seat and infant car seat adapter at the same time.
• This product is only to be used with certain Infant Car Seats. See
below for list of compatible Infant Car Seats.
• When using this product with your Infant Car Seat, infant must
always be secured in the car seat with the car seat harness.
• To ensure your Infant Car Seat is properly installed on the stroller,
make sure it is:
• Facing the person pushing the stroller.
• Tightly secure to the stroller with the car seat adapter’s restraint
straps.
• If at any time your Infant Car Seat does not secure properly to the
stroller, or if you have questions about assembly or use of the
stroller, Do Not use this product. Call Kolcraft at 1-800-453-7673.
•Make sure the stroller is fullyunfolded and the car seat adapter is
securelylatched before attaching your Infant Car Seat. This
prevents finger pinching and injuries caused by stroller collapsing.
•Onlytransport infants that are within the size and weight
limitations of your Infant Car Seat,as described in the instruction
manual provided by the Infant Car Seat manufacturer.
•THE FOLLOWING INFANT CAR SEATS CAN BE USED IN CAR
SEAT ADAPTER:
•Baby Trend®Latch-Loc
•Century®Avanta™Series
•
Century®Vanté™5
•
Chicco®Key Fit
•
Combi®Tyro™
•Combi®Connection™
•
Cosco®Arriva®Series
•
Cosco®Designer 22®
Series
•
Cosco®Eddie Bauer®Opus® 35®
•
Cosco®
Eddie Bauer
®
Caress
•
Cosco®First Ride DX
•
Cosco®Turn-A-Bout®
•
Evenflo®Discovery™
•Evenflo
®
EmbraceTM
•
Evenflo®On-My-Way™
•
Graco®Snug Ride™ Series
•
Graco® Safe Seat™
•
Maxi Cosi Micro
•
Peg Perego®Primo Viaggio
•
Peg Perego®SIP
•
Safety 1st®Designer® 22™
•
Safety 1st®Starter™
Continued on next page
4
Parts List
Stroller Frame
Front Wheel
Assembly
Rear Wheels (2)
Wheel Cover
12mm Screws
(2)
Rear Axle
Front Bar
Parent Tray
16mm Screws
(6)
Seat Infant Car Seat
Adapter
Washers
(4) Cotter Pins
(2) Hub Caps
(2)
Canopy
•If your Infant Car Seat is not one of the models listed above,DO
NOT use your infant car seat with this stroller.Other Infant Car
Seat models will not fit properlyand may result in serious injuryto
your child.
•
DO NOT USE THE FOLLOWING CAR SEATS WITH THIS STROLLER!
This list is not inclusive.
Baby Trend®, Britax®, Century®, Chicco®, Combi®, Cosco®, EvenFlo®, Gerry®,
Fisher Price®, Graco®, Peg Perego®and Safety 1st®are trademarks of their
respective owners. They are not associated with Kolcraft Enterprises, Inc. and
no approval by them is to be implied.
•Britax®Baby Safe™
•Britax®Companion
•Britax®Handle with Care®
•Century®535/580/590 Series
•Century®Assura®Series
•Century
®
Smart FitTM Series
•
Cosco®TLC
•
Cosco®Dream Ride®
•
Evenflo®Cozy Carry™
•
Evenflo®Portabout™
•
Fisher Price®Stay in View™
•All Gerry
®
Infant Car Seats
•Kolcraft
®
Secura
•Kolcraft
®
Infant Rider
®
Left Brake
Assembly Right Brake
Assembly
Rear Brake Tube
5
How to Assemble Your Stroller
To Open Stroller
Remove any cardboard inserts or plastic
ties used to protect the product during
shipment.
Release the locking latch.
Unfold, making sure both side locks on
each side of the stroller snap into place.
To Test for use: First pull up and then
push down on handle to make sure it is
fully engaged.
2
3
2
1
3
Side
locks
To Assemble Brake Assembly
Secure Right Brake Assembly to Brake
tube using two 16mm screws. Please
note the curve of the tube should be
curving towards outside as shown.
Place one washer onto end of rear axle.
Insert rear axle with washer into right
brake assembly hub.
Repeat for left side.
2
3
1
4
1
2
34
6
To Assemble Rear Wheels
Position brake assembly as shown, with
brake levers pointing towards stroller
handle.
Push both sides of brake assembly onto
rear leg tubes at the same time until
spring loaded buttons click into place.
Lay stroller on its side.
Slide a rear wheel onto the axle than
slide a washer onto the axle.
Fit straight part of cotter pin through
hole on axle as shown.
Line up each of the tabs in the hub cap
with the slots in the wheel, snap hub cap
into place.
Repeat for second side.
2
3
1
1
4
5
6
2
4
57
7
4
5
4
To Assemble Front Wheel & Attach Wheel Cover
1Place stroller back on handle bar.
Slide front wheel assembly onto frame.
NOTE: Make sure that spring loaded
buttons pop through frame. If your
spring loaded button becomes out of
place, take pliers and feed button into
hole.
CAUTION: If spring loaded buttons DO
NOT pop through, front wheel assembly
could fall off during use.
Secure front wheel assembly to the front
frame tubes using 12mm screws. The
screws should be aligned into the 2
holes closest to the spring loaded but-
tons. Secure with a Phillips screwdriver
on both sides.
Align bosses underneath wheel cover to
the two holes on the metal frame. If
bosses DO NOT line up, wheel cover on
front wheel is not on correctly. Repeat
steps 1-3. If you are still having trouble,
call customer service for assistance.
Secure wheel cover into remaining holes
underneath frame by basket with 16mm
screws using a Phillips screwdriver.
Repeat for second side.
2
2
33
Spring
Loaded
Buttons
Spring
Loaded
Buttons
5
8
To Attach Seat
Place stroller upright with all 3 wheels on
ground.
Pick up seat frame with handle and place
seat in either forward or reverse position.
Align seat tabs with side rail slot as
shown.
Press seat down until a “click” is heard.
Pull up on seat to make sure it is secured
to the frame.
To reverse seat, push in release levers
located underneath handles and lift up.
NOTE: Springs in seat frame are
designed to give your child a
comfortable ride.
1
2
3
14
Side Rail
Slot
Forward Position Reverse Position
WARNING
DO NOT Place car seat in stroller
seat. Car seat will not be secure.
Seat
Tab
Release levers
5
To Attach Front Bar
Release Button
CAUTION
To prevent injury to your child, take
care when inserting bar into frame.
Align bar into holes located on seat
frame.
Snap tab in place until a click is heard.
Repeat for second side.
TO ROTATE OR REMOVE BAR: Push in
release button located near side housing
and pull bar out. Repeat on other side,
to remove bar completely.
1
3
2
1 & 2
9
To Attach Canopy
Slide canopy on as shown.
1
1
To Attach Parent Tray
Align tray holes with posts near handle
and snap on.
TO REMOVE, pull each side up and out.
For cleaning, parent tray is top rack
dishwasher safe.
1
WARNING
DO NOT place more than 3 lbs.
(1.36 kg) in this tray to avoid tipping!
DO NOT place hot liquids in this tray.
Hot liquids can burn your child.
1
10
How to Properly Use Your New Stroller
WARNING
Avoid serious injury from falling or sliding
out. Always use restraint system. Do not
use product without full 5-point Harness
Restraint. Removing the shoulder straps
will not adequately restrain child.
Adjust Restraint
System Harness
To Secure Child In Stroller
Lock foot brake to keep stroller from
rolling.
Place child in stroller.
Hook shoulder straps to waist belt.
To fasten restraint system buckles -
push together. Be sure both buckles
are fastened to secure child safely.
To unsnap restraint system buckles -
press tabs to release.
For proper fit, adjust shoulder straps and
waist band as shown.
1
3
2
3
4
5
6
4
6
To Operate Brakes
1TO LOCK BRAKE: Push 1-Touch brake
bar down to lock wheels.
TEST: Push stroller slightly to make sure
brakes are engaged.
TO UNLOCK BRAKE: Lift up on brake
bar.
2
Unlock
Lock
Indice
Lingue:
Altri manuali Kolcraft Passeggino
Kolcraft
Kolcraft Contours Options Manuale utente
Kolcraft
Kolcraft Tour Sport Universal Umbrella Manuale utente
Kolcraft
Kolcraft Jeep Cherokee Sport S51J-T-R5 Manuale utente
Kolcraft
Kolcraft cloud PLUS Manuale utente
Kolcraft
Kolcraft travel about S51-T Manuale utente
Kolcraft
Kolcraft Contours Options Manuale utente
Kolcraft
Kolcraft Umbrella Stroller Manuale utente
Kolcraft
Kolcraft Jeep Cherokee Sport Series Manuale utente
Kolcraft
Kolcraft Contours Options Manuale utente
Kolcraft
Kolcraft Jeep Cherokee Sport Series Manuale utente
Kolcraft
Kolcraft S69-R1 Manuale utente
Kolcraft
Kolcraft Jeep S47J-R7 Manuale utente
Kolcraft
Kolcraft Jeep Overland Limited Manuale utente
Kolcraft
Kolcraft OPTIMA S82-R2 Manuale utente
Kolcraft
Kolcraft Contours Options Manuale utente
Kolcraft
Kolcraft Jeep S47J-A-R1 Manuale utente
Kolcraft
Kolcraft Contours Options Manuale utente
Kolcraft
Kolcraft Contours Options Optima S82-R3 Manuale utente
Kolcraft
Kolcraft Jeep Wrangler Twin Sport Series Manuale utente
Kolcraft
Kolcraft Escape Series Manuale utente
