COMPLIANCE REQUIREMENTS (LABELING)
The FCTN-MD09-XXX has been tested by an FCC-approved facility and found
to comply will all applicable FCC requirements as of the date, of this document.
A declaration of conformity (DOC) is on file.It is the user’s responsibility to
consult the FCC or other testing body to determine what additional testing may
be required on the user’s completed product. In products where no additional
testing is required, the product may be offered for sale when labeled in the
following manner:
•The following label shall be affixed in a conspicuous location to any device
self-certified under the FCC's Declaration of Conformity process, when the
product is authorized based on assembly using separately authorized
components and the resulting product does not require additional testing:
• When the device is constructed in two or more sections connected by wires
and marketed together, the label is required to be affixed only to the main control
unit.
•When the device is so small or for such use that it is not practical to place
the statement on the unit itself, the information shown on the label shall be
placed in a prominent location in the instruction manual or pamphlet supplied to
the user or, alternatively, shall be placed on the container in which the device is
marketed.However, the unique FCC logo, device trade name, and model number
must be present on the device.
•The label shall not be a stick-on paper label.The label shall be "permanently
affixed" to the device (meaning the label is etched, engraved, stamped, silk-
screened, indelibly printed on a permanently attached part of the device or on a
nameplate fastened to the equipment by welding, riveting, or a permanent
adhesive. The label must be designed to last the expected lifetime of the
equipment in the environment in which the equipment may be operated and may
not be readily detachable.
Your Company Name Your Product Name/ID#
Assembled From
Tested Components
(Complete System Not Tested)
FOR HOME OR OFFICE USE
SETTING DECODER MODULE’S ADDRESS
Nine tri-state address lines are provided which allow the selection of up to 19,683
unique identification codes.The address lines are normally attached to a DIP
switch or PCB Jumpers.*Note: Tri-State means the address lines have three
distinct states; hi, low, and floating. The data lines will not function unless the
address lines share identical stateswith the encoder address lines.
CONTENTION CONSIDERATIONS
An unlimited number of decoder modules may be operated in proximity without
interference. It is important, however, to understand that only one transmitter at
a time can be activated within a reception area. While the transmitted signal
consists of encoded digital data, only one carrier of any frequency can occupy
airspace without contention at any given time.
Page 3
