M-system R3-PA4 Manuale utente

R3-PA4

P. 1 / 3 EM-8399 Rev.2

BEFORE USE ....

Thank you for choosing M-System. Before use, please check

the contents of the package you received as outlined below.

If you have any problems or questions with the product,

please contact M-System’s Sales Office or representatives.

■ PACKAGE INCLUDES:

Pulse input module ..................................................... (1)

■ MODEL NO.

Check that model No. described on the specification label is

exactly what you ordered.

■ INSTRUCTION MANUAL

This manual describes necessary points of caution when you

use this product, including installation, connection and basic

maintenance procedures.

INSTRUCTION MANUAL

MODEL R3-PA4

HIGH SPEED PULSE INPUT MODULE

(4 points, isolated)

POINTS OF CAUTION

■ HOT INSERTION/REMOVAL OF MODULES

Removing or replacing modules does not affect other modules

on the same backplane. It is possible to replace them without

removing the power supply. However, replacing multiple

modules at once may greatly change line voltage levels. We

recommend that you replace them one by one.

■ ENVIRONMENT

• Indoor use

• When heavy dust or metal particles are present in the air,

install the unit inside proper housing with sufficient ventila-

tion.

• Do not install the unit where it is subjected to continuous

vibration. Do not subject the unit to physical impact.

• Environmental temperature must be within -10 to +55°C

(14 to 131°F) with relative humidity within 30 to 90% RH in

order to ensure adequate life span and operation.

■ WIRING

• Do not install cables (power supply, input and output) close

to noise sources (relay drive cable, high frequency line, etc.).

• Do not bind these cables together with those in which noises

are present. Do not install them in the same duct.

■ AND ....

• The unit is designed to function as soon as power is

supplied, however, a warm up for 10 minutes is required for

satisfying complete performance described in the data sheet.

INSTALLATION

Use the Installation Base (model: R3-BSx).

R3-PA4

P. 2 / 3 EM-8399 Rev.2

COMPONENT IDENTIFICATION

SW1SW2

SW3

■FRONT VIEW ■SIDE VIEW

ERR LED

RUN LED

Gain Input 2 (SW1)

Input 4 (SW2)

Range

Input 1 (SW1)

Input 3 (SW2)

•Gain: SW3

■SIDE DIP SW

•Input Range: SW1, SW2 (independent range selectable)

INPUT 1 (SW1) INPUT 2 (SW1)

INPUT 3 (SW2) INPUT 4 (SW2) RANGE

12345678

OFF OFF OFF OFF OFF OFF OFF OFF

0 – 100 kHz(*)

ON OFF OFF OFF ON OFF OFF OFF 0 – 10 kHz

OFF ON OFF OFF OFF ON OFF OFF 0 – 1 kHz

ON ON OFF OFF ON ON OFF OFF 0 – 100 Hz

OFF OFF ON OFF OFF OFF ON OFF 0 – 10 Hz

ON OFF ON OFF ON OFF ON OFF 0 – 1 Hz

OFF ON ON OFF OFF ON ON OFF 0 – 0.1 Hz

SW GAIN INPUT

1 (*)2

SW3-1 OFF ON Input 1

SW3-2 OFF ON Input 2

SW3-3 OFF ON Input 3

SW3-4 OFF ON Input 4

(*) Factory setting

■ DIMENSIONS mm (inch)

TERMINAL CONNECTIONS

Connect the unit as in the diagram below.

130 (5.12)

27.5 (1.08) 109 (4.29) POSITIONING

GUIDE

TERMINAL

COVER

20–M3

SCREW

6.2

(.24)

■STATUS INDICATOR LED

RUN indicator: Bi-color (red/green) LED;

Red when the bus A operates normally;

Green when the bus B operates normally;

Amber when both buses operate normally.

ERR indicator: Bi-color (red/green) LED;

Red with the excitation abnormality;

Green in normal operating conditions.

R3-PA4

P. 3 / 3 EM-8399 Rev.2

■ CONNECTION DIAGRAM

M-SYSTEM WARRANTY

M-System warrants such new M-System product which it manufactures to be free from defects in materials and workmanship during the 36-month period following the date that such

productwasoriginallypurchasedifsuchproducthasbeenusedundernormaloperatingconditionsandproperlymaintained,M-System'ssoleliability,andpurchaser'sexclusiveremedies,

under this warranty are, at M-System's option, the repair, replacement or refund of the purchase price of any M-System product which is defective under the terms of this warranty. To

submit a claim under this warranty, the purchaser must return, at its expense, the defective M-System product to the below address together with a copy of its original sales invoice.

THIS IS THE ONLY WARRANTY APPLICABLE TO M-SYSTEM PRODUCT AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. M-SYSTEM SHALL HAVE NO LIABILITY FOR CONSEQUENTIAL, INCIDENTAL OR

SPECIAL DAMAGES OF ANY KIND WHATSOEVER.

M-System Co., Ltd., 5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN, Phone: (06) 6659-8201, Fax: (06) 6659-8510, E-mail: [email protected]

WIRING INSTRUCTIONS

■SOLDERLESS TERMINAL mm (inch)

Refer to the drawing below for recommended ring tongue

terminal size. Spade tongue type is also applicable. Solderless

terminals with insulation sleeve do not fit. Applicable wire

size: 0.3 – 0.75 mm2

3.2 (.13) dia.

4 min.

(.16)

12 (.47) max.

6 max.

(.24)

3 (.12) max.

EXC +

INP TERM. 1

INP TERM. 2

INP TERM. 3

COM

INTERNAL POWER

BUS A

BUS B*

*For dual redundant communication.

BUS CONNECTOR

Input 1

EXC +

INP TERM. 1

INP TERM. 2

INP TERM. 3

COM

Input 2

EXC +

INP TERM. 1

INP TERM. 2

INP TERM. 3

COM

Input 3

EXC +

INP TERM. 1

INP TERM. 2

INP TERM. 3

COM

Input 4

■Input Connection Example (Input 1)

• Open Collector

12VDC

20kΩ

1kΩ7.5kΩ

Altri manuali M-system Unità di controllo

M-system

M-system R8-SVT8 Manuale utente

M-system

M-system R5-NM1 Manuale utente

M-system

M-system 73VR3100 Manuale utente

M-system

M-system R7HL-DAC15E Manuale utente

M-system

M-system R7M-DA16 Manuale utente

M-system

M-system M8CD1 Manuale utente

M-system

M-system R3-NP1 Manuale utente

M-system

M-system R7ML-DC16D Manuale utente

M-system

M-system R3-PA2 Manuale utente

M-system

M-system R7L-EC8A Manuale utente

M-system

M-system R3-NL1 Manuale utente

M-system

M-system R6N-RS2 Manuale utente

M-system

M-system R7L-DA16-R Manuale utente

M-system

M-system MECHATROLINK R7K4FML3-6-DAC32B Manuale utente

M-system

M-system R7ML-EC16D Manuale utente

M-system

M-system R7L-EC8B Manuale utente

M-system

M-system R7D-EC16B Manuale utente

M-system

M-system R7D-MS4 Manuale utente

M-system

M-system R7M-DC16A Manuale utente

M-system

M-system EtherCAT R7I4DECT-1-PA8A Manuale utente

M-system

M-system R7D-EC8B Manuale utente

M-system

M-system R30MS4 Manuale utente

M-system

M-system R3Y-SV16 Manuale utente

M-system

M-system R7M-MS4 Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente