Remember to hit Save before you close the window for the changes to load to the
memory.
Mode
TBT
Sensor Type
The device is capable of communicating with 0-5 V and 4-20 mA type analog sensors. If you are
using an analog sensor with the device, please select the appropriate sensor type. By default,
the device is configured for 0-5 V type sensors.
ADC Wait(s)
This parameter enables you to set the number of seconds the device queues up the sensor for
a reading before it collects the sensor level data from the sensor. The Default value is 3
seconds. This should only be increased if using a non-contact sensor such as a radar gauge,
sonic sensor or laser sensor.
Digital Wake
This feature is associated with digital input such as a high level float gauge for overfill protection
or other types of normally open/normally closed contacts. If enabled, the input device will close
its circuit and engage the no/nc on the digital input of the F100m forcing the monitor to turn on
and report. The Digital Wake value is set in seconds and correlates to the number of seconds
that NO/NC waits after triggered to force the F100 to report, i.e. if set to 3 seconds, when the DI
is triggered for more than 3 seconds, the unit will force a report. The default value of this
parameter is Off.
Force LCD On
The F100 turns on the LCD only when a user forces a report. In other scenarios, the LCD is off
while the monitor performs normal tasks in the background, i.e. regular scheduled reporting. If
Force LCD is enabled, the LCD will turn on everytime the device conducts any action. Default
Value of this parameter is off.
Warning : Enabling the option, Force LCD ON, will cause the device to use much more
power and may drain the batteries much sooner than expected. Use this option
