oticon Dynamo BTE13 SP Manuale utente
Instructions for use Dynamo
BTE13 SP
Introduction to this booklet
This booklet guides you in how to use and maintain your new hearing
aid. Please read the booklet carefully including the Warning section.
This will help you to achieve the full benet of your new hearing aid.
Your hearing care professional has adjusted the hearing aid to meet
your needs. If you have additional questions, please contact your
hearing care professional.
About Start up Handling Options Warnings More info
For your convenience, this booklet contains a navigation bar to help
you navigate easily through the dierent sections.
Intended use
The hearing aid is intended to amplify and transmit sound to the ear,
and thereby compensate for impaired hearing. This hearing aid is
intended for use by adults and children older than 36 months.
IMPORTANT NOTICE
The hearing aid amplication is uniquely adjusted and optimised to your
personal hearing capabilities during the hearing aid tting performed by
your hearing care professional.
Table of content
About
Hearing aid view 6
Identify left and right hearing aid 8
Battery (size 13) 9
Start up
Turn the hearing aid on and off 10
When to replace a battery 11
How to replace the battery 12
Handling
Caring for your hearing aid 14
Sound hook with mould 16
Put on the hearing aid with mould 17
Clean the mould 18
Wash the mould 19
Options
Optional features and accessories 20
Mute the hearing aid (optional) 21
Change volume 22
Volume control and ConnectLine (Optional) 24
Change programs (optional) 26
Other options (optional) 30
Direct Audio Input (DAI) 31
Wireless accessories (optional) 32
Tamper-resistant battery drawer (optional) 34
Warnings
Warnings 36
More info
Troubleshooting guide 42
Water resistant (IP58) 44
Conditions 45
Warranty certificate 46
International warranty 47
Technical information 48
6 7
About Start up Handling Options Warnings More info
Hearing aid view
What it is What it does
Push button Change
programs
Volume
wheel
Change volume
and mute the
hearing aid
Battery drawer Contains the battery.
Battery drawer is the
on/o switch
Sound hook Microphone
openings
Sound in
Tube
Mould
Nail grip Open the
battery drawer
Sound out
About
8 9
About Start up Handling Options Warnings More info
Identify left and right hearing aid
It is important to distinguish between the left and the right hearing
aid as they might be programmed dierently.
Battery (size 13)
Your hearing aid is a miniature electronic device that runs on special
batteries. To activate the hearing aid, you must insert a new battery in
the battery drawer. See how in the “Replace the battery” section.
A RED indicator inside the
battery drawer marks the
RIGHT hearing aid
A BLUE indicator inside the
battery drawer marks the
LEFT hearing aid.
Battery drawer
Your hearing aid
battery size is 13
Pull out to open
10 11
About Start up Handling Options Warnings More info
Turn the hearing aid on and o
The battery drawer is also used to switch the hearing aid on and o. To
preserve the battery, make sure your hearing aid is switched o when
you are not wearing it.
When to replace a battery
When it is time to replace the battery you will hear two beeps
repeated in moderate intervals until the battery runs out.
Two beeps
= The battery is running low
Four beeps
= The battery has run out
Battery maintenance tip
To make sure the hearing aid is always working bring spare batteries
with you, or replace the battery before you leave home.
Turn ON
Close the
battery
drawer with
the battery
in place.
Turn OFF
Open the
battery drawer
Start up
12 13
About Start up Handling Options Warnings More info
How to replace the battery
2. Uncover 3. Insert
Fully open the
battery drawer.
Remove the battery.
Remove the
sticky label from
the + side of the
new battery.
Tip:
Wait 2 minutes so that the
battery can draw air, to ensure
optimal functioning.
Insert the new
battery into the
battery drawer.
Make sure the
+ side faces up.
1. Remove
MultiTool
Close the battery drawer. The
hearing aid will play a jingle
through the earpiece.
Hold the earpiece close to your ear
to hear the jingle.
The MultiTool can be used for
battery change. Use the magnetic
end to remove and insert batteries.
The MultiTool is provided by
your hearing care professional.
4. Close Tip
14 15
Caring for your hearing aid
When handling your hearing aid, hold it over a soft surface
to avoid damage in case you drop it.
Clean the microphone openings
Carefully brush away debris from
the openings. Gently brush the
surface. Make sure the brush is
not pressed in to the openings.
About Start up Handling Options Warnings More info
IMPORTANT NOTICE
Use a soft, dry cloth to clean the hearing aid. It must never be washed or
immersed in water or other liquids.
Microphone
openings
The MultiTool
The MultiTool contains a brush and a wire loop for cleaning ear wax
from the mould. The brush can be replaced and purchased from your
hearing care professional.
IMPORTANT NOTICE
Your MultiTool has a built-in magnet. Keep the MultiTool 30 cm away from
credit cards and other magnetically sensitive devices.
Brush
Wire loopMagnet
Handling
16 17
About Start up Handling Options Warnings More info
Sound hook with mould
The mould is customised for you and
ts your ear.
Put on the hearing aid with mould
Gently pull your ear outwards
and press the mould in the
direction of the ear canal,
twisting slightly.
Place the hearing aid
behind your ear.
Step 1 Step 2
18 19
About Start up Handling Options Warnings More info
Clean the mould
The mould should be cleaned
regularly. Use a soft cloth to
clean the surface of the mould.
Use the MultiTool wire loop
to clean the opening.
Replace the tube
The tubing between the mould
and the hearing aid should be
replaced when it becomes
yellow or sti. Consult your
hearing care professional in
relation to this.
Wash the mould
Make sure you are
able to identify which
mould is for which
hearing aid before
disconnecting them
from the hearing aids.
Disconnect the tube
and mould from the
hook. Hold the hook
rmly, when pulling
o the tube. Other-
wise the hearing aid
may be damaged.
Wash the mould
and tube using mild
soap. Rinse and dry
completely before
reconnecting to the
hearing aid.
Step 1 Step 2 Step 3
Indice
Altri manuali oticon Apparecchio acustico
oticon
oticon Aurora miniRITE 312 T Rc Manuale utente
oticon
oticon STREAMER PRO Manuale utente
oticon
oticon miniRITE Alta2 Manuale utente
oticon
oticon Real Series Manuale utente
oticon
oticon BTE Manuale utente
oticon
oticon Geno 1 Manuale utente
oticon
oticon Hearing Aid Listening Tube Manuale utente
oticon
oticon Agil BTE 13 Manuale utente
oticon
oticon amigo FM-CI Manuale utente
oticon
oticon IIc Manuale utente
oticon
oticon Sumo 20DM Manuale utente
oticon
oticon Streamer 1.4 Manuale utente
oticon
oticon ConnectLine Streamer Pro 1.3A Manuale utente
oticon
oticon Agil Manuale utente
oticon
oticon Corda miniFit Guida alla configurazione
oticon
oticon ConnectClip Manuale di istruzioni
oticon
oticon HIT PRO Manuale utente
oticon
oticon Intent 1 miniRITE Manuale utente
oticon
oticon Xceed BTE SP Manuale utente
oticon
oticon Agil BTE 13 Manuale utente
