Philips BT4200 Manuale utente
2.0
BT4200
General information
Warnings
•Only use attachments or accessories specied by manufacturer.
•The battery shall not be exposed to excessive heat such as sunshine, re etc.
•Only for indoor use.
Care and safety information
Avoid high temperatures, moisture, water and dust
•Apparatus should not be exposed to dripping or splashing of liquid.
•Do not place any source of danger on the speaker
•Do not install near heat sources.
Do not block any ventilation opening
•
•Place the apparatus in a location with adequate ventilation to prevent internal heat build up. Allow at
least 10cm (4 inches) of free space all around the apparatus for adequate ventilation.
Care of the cabinet
•Use a soft cloth slightly moistened to clean the cabinet.
Do not use a solution containing alcohol, spirits, ammonia or abrasives.
Accessories
Item 3.5mm to stereo cable User manual USB cable
Quantity 1 1 1
02
Top & Back panel
3
2
1
86 7
45
AUX
IN
ON OFF
DC IN
5V 1A
DC in USB socket
03
Top panel operation
04
A. Switch operation
B. LED
4. Yellow - charging and after fully charged it will be o.
5. Blue and Green - blue for BT and green for Aux in connection.
C. Back panel
6. AUX in - For Aux in cable in connection.
7. On/o - power on or o switch.
8. DC in USB socket - power in socket for charging from 5V DC,1A source only.
* In case of laptop BT connection, this will work with windows media player.
Prev Song/Track*
a. play or pause song
b. accept or reject an incoming call
Disconnect BT connection
Volume decreases,
when it reaches lower
volume it will make sound
Next Song/Track*
Volume increases,
when it reaches higher
volume it will make sound
short press
long press
BT
mode.
AUX
mode.
Volume decreases,
when it reaches lower
volume it will make sound
Volume increases,
when it reaches higher
volume it will make sound
long press
1. 2. 3.
For bluetooth connection
1. When in Bluetooth mode, the speaker will give out 'Beep' sound, and the blue LED will ash quickly.
2. Turn on the bluetooth of the devices like mobile, computer or others, search the bluetooth name 'BT4200'.
3. Press 'Pair' in the device to connect with the speaker, it will give out a 'Beep' sound after pairing successfully.
Blue light will stop ash. (Normally no need to provide password. If need, just put '0000' as the password.)
4. After pairing sucessfully, the device will connect with speaker automatically next time.
Charging
Connect one side of the USB charging cable with the speaker, the other side connected with the
computor or a standard charger with 5V 800mA for charging. The LED light will be yellow when charging,
after it's full, the yellow light will disappear.
The charging time is 3~4 hours. The working time will depend on the volume user sets up.
When the speaker is low power, it will give out a 'Beep' sound, then it should be charged.
If no charging, the speaker will be shutdown for no power. If you are not using the speaker for long time,
ensure that it is being charged fully once every month in order to protect the battery.
Instruction of the LED light
Yellow light: Charging light;
Blue light: Bluetooth light and low power light.
Green light: AUX in connected
05
Troubleshooting
* In case these measures do not work contact the nearest PHILIPS service center or call at customer care numbers.
Warning -
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.
below before taking the system for repair. If you are unable to remedy the problem by following hints
mentioned in below table, Consult your dealer or PHILIPS APSC for help.
06
Problem Solution
1. No power.
2. No sound or distorted sound.
3. Low hum or buzz sound.
4. No response from the speaker.
5. The audio quality is poor after
connection with Bluetooth enabled
device.
6. Cannot connect with the device.
Charge the unit by using USB charging cable.
Adjust the volume / select the correct source to choose the equipment
that you want to hear through the system.
Place the product as far away as possible from electrical devices that may be
causing interference.
Restart the speaker.
Move the device closer to this product or remove obstacle between them.
This product is already connected with another Bluetooth enabled device.
Disconnect that device and then try again.
This Philips 2.0 multimedia speakers system is warranted against any defect due to defective materials or
workmanship for 12 months from the date of purchase, should a defect develop during the period of warranty,
Gibson Innovations India Private Limited undertake to repair the apparatus FREE OF CHARGE through the dealer
from whom it has been purchased or at any of the Philips Authorised Service Centres.
The warranty is not valid in case :
1. Proof of purchase is not accompanied with this warranty card.
2. The warranty card is not completed immediately after purchase.
3. The apparatus is not used according to this manual.
4. Defects are caused by improper or reckless use.
5. Any repairs are done by persons other than Philips Authorised service centre.
7. The serial number is tampered with.
8. Defects due to causes beyond control like lightning, abnormal voltage, acts of God or while in
transit to the purchaser’s residence.
All consumables and parts susceptible to normal wear and tear are not covered under warranty.
Week/S.No.: ___________________________ Bill No. ___________________________
Date of purchase _________________________________________________________
Dealer’s name: ___________________________________________________________
Dealers stamp: __________________________________________________________
Customer’s name and address: _____________________________________________
Model No.: _____________________________________________________________
Dealer’s signature: ________________________________________________________
Warranty
Gibson Innovations India Private Limited 4th Floor, Block-1, Vatika Business Park, Sector 49, Sohna Road,
Gurgaon-122018, Haryana, India 07
Rated output power
Signal to Noise Ratio
10W RMS(5Wx2)
Audio input
Frequency Response
Speaker
Amplier
Bluetooth
>60db
Speaker Impedance 4 ohm
600MV
70Hz~20KHz
Speaker Driver 1.75 inch/4.5cm
80 dBm
Sensitivity
Bluetooth version V 4.0
V2.1+EDR
Bluetooth prole
Bluetooth freg 2.4GHz~248GHz
Bluetooth range Upto 10M(freespaee)
General Introduction
Power supply
Built in Battery Li-polymer battery
Dimension main unit 210x90x90
Weight 0.4 kg
5V, 1A
The Philips trademark and Philips shield emblem are
registered trademarks of koninklijke Philips N.V. used
under license.
This product has been manufactured by and sold
under the responsibility of Gibson Innovation India
Private Ltd. and Gibson Innovations India private Ltd.
is the warrantor in relation to this product.
Indice
Altri manuali Philips Altoparlanti
Philips
Philips AD902W/05 Manuale utente
Philips
Philips Fidelio SoundRing DS3801W/37 Manuale utente
Philips
Philips BT3000 Scheda informativa del prodotto
Philips
Philips SPA8210 Manuale utente
Philips
Philips HTD3500 Manuale di istruzioni
Philips
Philips FB651 Manuale utente
Philips
Philips Fidelio E6 Manuale utente
Philips
Philips HTL5130B Manuale utente
Philips
Philips HTL2111A Manuale utente
Philips
Philips MMS2160B Manuale utente
Philips
Philips HTB5544D Manuale utente
Philips
Philips SB5200 Manuale utente
Philips
Philips BT2000R Manuale utente
Philips
Philips PHBT2600 Manuale utente
Philips
Philips HTB9150 Manuale utente
Philips
Philips CSS5123/93 Manuale utente
Philips
Philips SBCBC300/05 Manuale utente
Philips
Philips SB365B Scheda informativa del prodotto
Philips
Philips STS9500/00 Manuale utente
Philips
Philips SB5200 Manuale utente
