Polycom RSS 2000 V1.0 Manuale utente
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 1
Polycom ™ RSS 2000 V1.0
Getting Started guide
General Safety Precautions
Follow these rules to ensure general safety:
• Keep the area around the Polycom RSS 2000 unit clean, free of clutter
and well ventilated.
• Decide on a suitable location for the equipment rack that will hold
the RSS 2000 unit and is near a grounded power outlet.
• • Use a regulating uninterruptible power supply (UPS) to protect the
RSS 2000 unit from power surges and voltage spikes, and to keep it
operating in case of a power failure.
Hardware Specification
Pentium 4, 2.8Mhz,1.5G RAM,250G Hardisk.
• Form Factor: 1U 19” rack mount
• Height: 1.73” (44 mm)
• Width: 16.83” (430 mm)
• Depth: 15.35” (390 mm)
• Gross Weight: 22.4 lbs (10.2 kg)
• Power Supply: Thermal controlled 220W
ATX AC power supply w/PFC
• AC Voltage: 100 - 240 VAC, 60-50 Hz, 5-3
Amps
XP OS
Preparations
Obtain the following information from your network administrator:
• RSS 2000 unit, Subnet Mask and Default Gateway IP addresses
• Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 2
Unpacking and Installing the RSS 2000
1 Place the RSS 2000 unit on a stable flat surface in the selected location.
2 To connect to the power source, insert the power cable into the
Power connector on the rear panel of the MGC+ unit and insert the
Power cable into the power source socket.
3Connect the lan cable to LAN1 in the back of the system.
4 Turn on the power switch.
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 3
Initial RSS 2000 IP Configuration
The system is shipped with a default IP address:
IP Address:192.168.1.254
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
There are two ways to change the initial IP address of the sytem:
1. Via a cross over lan cable
2. Via a RS232 or Telnet Console.
1. Changing the initial IP address via a cross over lan cable
1. Connect a cross over lan cable to LAN1 in the RSS 2000.
2. Set your laptop to the same segment of the RSS
a. For example (in your laptop IP config setting):
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 4
3. Open internet explorer and browse to:
http://192.168.1.254
4. Login to the system.
User name: Administrator
Password: polycom
5. Go to system configuration->IP setting and modify the IP address. Click the save button
and than reset the system.
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 5
2.Changing the initial IP address via an RS232 Console or Telnet
Another option to modify the IP address of the RSS 2000 is using the RS232 console.
1.Connect to the RS232 port – and activate the console (9600, 8bits)
Login: polycom (or any administrator password)
When login to the console, you will see the current IP address of the system.
Help
? – show all available commands
Changing the IP Address:
set lan1 static 172.21.100.20 mask 255.255.224.0 [gw 172.21.96.254]
Reset Password (back to polycom)
User may reset the password of the administrator to default to ‘polycom’
reset password
Note !
The same steps apply also for Telnet connection.
Only one console can be connected at any given time (either Telnet or RS232 not both).
The system is now ready for use, for additional configuration refer to the user guide.
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 6
RSS 2000 Maximum Capacity
Scenario Description Maximum Capacity
Conference
Recording How many conferences can be
recorded simultaneously 2 conference or 2 EPs dialing in the
same time1 H239 recorded link at a time
Point to Point
recording How many point to point calls can
be record (if both are dialing into the
POLYCOM ™ RSS 2000)
1
H323
Playback How many conferences can be
playback in H323 10
Archive view How many streaming can be
reviewed (unicast) – based on the
Web Server capacity
60
Network TCP/UDP ports used by RSS2000
Usage Type Port Range
Manager TCP 81
Web TCP 80
Trace UDP 30011
Gatekeeper UDP 1719
RAS UDP 1720
Q.931 Socket TCP 1720
H.245 Socket TCP 1730-1739
Endpoint/
H.323
Audio / Video / Data UDP 2000-2099
Live Broadcast TCP 1800-1801
Media On Demand Archive TCP 2800-2859
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 7
RSS2000 Policies and Limitations
Subject Description
H.323 Alias
length The maximum length of the system H.323 alias name is 16 characters
IVR message The format for IVR message files is: WAV files, PCM 16bits
Console
Service RS232 configuration: Baud rate 9600, Data bits 8, Parity None, Stop bits 1,
Flow control OFF.
ONLY ONE connection to the Console service is allowed, either by RS232 or
by Telnet, but not both.
Endpoint menu 1. When schedule a dial out & record from the Web UI, RSS will loopback the
video and NEVER show the menu unless a menu operation (FECC arrow
keys or DTMF 2/4/6/8) is given from the endpoint.
2. When a pre-defined endpoint dials into the RSS and the endpoint has the
"immediate recording" option, RSS will do the same as above.
3. When inviting an endpoint to a P2P recording room (using E.164 number
of the P2P room followed by #/* and E.164 number of the invited endpoint
), the inviting endpoint will have the menu and the invited endpoint won’t
have the menu
4. When two endpoints meet at a P2P recording room, only one of them can
have the menu at a time.
H.264
bandwidth The maximum bandwidth for H.264 is limited to 768K
P2P recording
maximum
bandwidth
Maximum bandwidth for a P2P recording room is 1024K. If video protocol for
P2P recording room is H.264, then the maximum bandwidth is 768K
Archive file size If the media file size exceeds 4GB, downloading it from Web UI may be
incomplete.
Media Player
Support Windows Media Player 9/10 is required. WMP 10 is recommended.
RealPlayer can also be used if WMP is properly installed.
QuickTime player is not supported.
Some third party media player such as Media Player Classic (MPC) and VLC
can also be used, but they were not certify
Archive
playback Archive playback with WMP does not support playback controls:
Pause/Resume/FF/Backward, etc
H.323 playback During H.323 playback, if there is packet loss and endpoint requests I-Frame,
RSS cannot apply the request. Since all audio/video data are from the media
file.
System Reset Hard reset (power off and on) is not recommended.
Reset should be done via the Web UI or Console service whenever possible.
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 8
Corrections and enhancements
Description Jira Bug# / Comments
Content from a recorded stream is not passed
when VSX is in a MP call RSS-71
H.264 HD support
1.H.264 maximum rate is set to 1920K to allow HD
connection
2.Creation of WMV archive for HD recording is
done offline in background process after recording
is stopped, due to system performance limitation.
Related Web interface are updated.
Live streaming is not available for HD calls
RSS-75, RSS-81, RSS-82
H.239 content is not played when Tandberg MXP
plays back archive RSS-85
Tandberg has no FECC capability when in a call
with RSS2000 RSS-84
When iPower is connected to RSS2000 it does not
have FECC RSS-27
HD H323 Playback will be shown in the archive list
only for supporting HD endpoints, non HD endpoint
will not see the HD archive list, to prevent crashes
on the non HD endpoint
Login screen appear corrupted, when using non
English IE version case 688767 (CRM)
HDX playback issues There are some issues with the HDX,
(Issues that are open under the HDX
project) – which should be verify with the
RSS
RSS shows connected and it’s not RSS-92
Gatekeeper setting lost RSS-94
RSS2000 Crashed upon multiple dial-in parties
coming and going RSS-96,RSS-102
RSS2000 crashed upon Recording Room dial-in
from LifeSize RSS-95
Improved: HD H.323 playback issues: LipSync and
audio distortion RSS-93 RSS-81
Enhancement: Automatic deletion of
C:\pagefile.sys file, to prevent low disk space on
drive C:
Enhancement: IP + extension dial out RSS-86 RSS-87 RSS-105
Fix: The audio is cut short at the end of a recording RSS-90 RSS-98
Enhancement: System name/ H.323 alias can be
changed when GK option is disabled
H.323 endpoint menu font color are adjusted for
HDX endpoints. (When HDX endpoints are connected to
current version, some part of the words on
the menu screen are missing. HDX
Release - 1.0.0-259).
H.264 HD Limitation
9H.264 maximum rate is set to 1920K to allow HD connection
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 9
9Creation of WMV archive for HD recording is done offline in background
(in a ratio of 1 to 6 (for each minute recording the archive will be ready to
view in 6 minutes) process after recording is stopped
9Live streaming is not available for HD calls
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 10
Installed Windows Security Updates List – RSS V1.0.1.002
Name Description
KB883939 Security Update for Windows XP (KB883939)
KB885836 Windows XP Hotfix - KB885836
KB886185 Windows XP Hotfix - KB886185
KB890046 Security Update for Windows XP (KB890046)
KB893756 Security Update for Windows XP (KB893756)
KB893803v2 Windows Installer 3.1 (KB893803)
KB896358 Security Update for Windows XP (KB896358)
KB896423 Security Update for Windows XP (KB896423)
KB896424 Security Update for Windows XP (KB896424)
KB896688 Security Update for Windows XP (KB896688)
KB896727 Update for Windows XP (KB896727)
KB898461 Update for Windows XP (KB898461)
KB899587 Security Update for Windows XP (KB899587)
KB899588 Security Update for Windows XP (KB899588)
KB899591 Security Update for Windows XP (KB899591)
KB900725 Security Update for Windows XP (KB900725)
KB901214 Security Update for Windows XP (KB901214)
KB902400 Security Update for Windows XP (KB902400)
KB903235 Security Update for Windows XP (KB903235)
KB904706 Security Update for Windows XP (KB904706)
KB905414 Security Update for Windows XP (KB905414)
KB905749 Security Update for Windows XP (KB905749)
KB905915 Security Update for Windows XP (KB905915)
KB908519 Security Update for Windows XP (KB908519)
KB908531 Update for Windows XP (KB908531)
KB910437 Update for Windows XP (KB910437)
Indice
Altri manuali Polycom Server
Polycom
Polycom DOC2562A Manuale utente
Polycom
Polycom RealPresence RMX 4000 Istruzioni per l'installazione
Polycom
Polycom DMA 7000 Manuale utente
Polycom
Polycom KIRK 300 Manuale utente
Polycom
Polycom Collaboration Server (RMX) 2000 Istruzioni per l'installazione
Polycom
Polycom DOC2559B Istruzioni per l'installazione
Polycom
Polycom KIRK 8000 Manuale utente
Polycom
Polycom Collaboration Server (RMX) 1800 Istruzioni per l'installazione
Polycom
Polycom RMX 2000 Scheda tecnica
Polycom
Polycom DOC2560C Manuale utente
Polycom
Polycom RealPresence 800s Manuale utente
Polycom
Polycom RMX 1500 Manuale utente
Polycom
Polycom DOC2557A Istruzioni per l'installazione
Polycom
Polycom Collaboration Server (RMX) 1800 Istruzioni per l'installazione
Polycom
Polycom Collaboration Server (RMX) 1500 Guida di riferimento rapido
Polycom
Polycom DOC2563A Manuale utente
Polycom
Polycom V2IU4300T Manuale utente
Polycom
Polycom Realpresence collaboration server 1500 Guida di riferimento rapido
Polycom
Polycom V2IU6400-S Manuale utente
Polycom
Polycom realpresence 1800 Manuale utente
