Siemens HLIM Manuale utente

Siemens Building Technologies

Fire Safety

P/N 315-033170-2

OPERATION The SIEMENS Model HLIM Loop Isolator Module solates short c rcu ts on F reF nder-

XLS analog loops. By plac ng dev ces between HLIMs dur ng nstallat on, a short n

the w r ng w th n that group s d sconnected from the rest of the loop. The rema nder

Figure 1

The HLIM-1 Loop Isolator Module

does not have a loop address and therefore does not requ re address programm ng

nor does t reduce the loop capac ty below 252 dev ces.

Remove all system power before installation, first the battery and then the AC.

INSTALLATION The HLIM s a polar ty nsens t ve module. Refer to F gure 1 for the locat on of the

two nput term nals and two output term nals. L ne 1 and L ne 2 can be e ther l ne of

the loop.

The HLIM may be used n two c rcu t conf gurat ons as follows:

Class B (See F gure 2) In Class B w r ng each HLIM solates a branch on the c rcu t. Note that

a short on the ma n branch causes the ent re loop to fa l. To prevent th s, mount the

HLIMs at the F reF nder-XLS enclosure and run each branch ndependently.

of the dev ces cont nue

to operate. The HLIM

operates n both Class A

and Class B c rcu ts.

A yellow LED flashes

when a dev ce detects a

short c rcu t. The HLIM

then solates that part of

the loop. When the short

s removed, the HLIM

automat cally restores

the loop to normal

operat on. The HLIM

FRONT BACK

FAULT

IN - LINE 1

IN - LINE 2

OUT - LINE 1

OUT - LINE 2

Loop Isolator Module

Installation Instructions

Model HLIM

Siemens Building Technologies

Fire Safety

P/N 315-033170-

Figure 2

HLIM Wiring Diagram - Class B Installation

Class A S ngle Loop (See F gure 3) In Class A w r ng the HLIMs are w red n ser es w th the loop w r ng.

Th s results n a s ngle cont nuous loop. If any group n the loop has a short, that

group s lost and a Class A c rcu t fa lure results. The F reF nder-XLS d splays commu-

n cat on errors for the dev ces and a Class A fa lure for the loop tself.

Figure 3

HLIM Wiring Diagram - Class A Installation Single Loop)

1. All wiring must comply with

national and local codes.

. In order to provide adequate

protection, it is recom-

mended that you do not

install more than 0 devices

on a single HLIM.

3. Minimum wire gauge is

18 AWG.

4. The total wire resistance

(both wires) between HLIMs

cannot exceed 0 ohms.

5. Do not install more than 15

HLIMs per DLC loop.

6. All circuits are supervised.

7. Refer to DLC Installation

Instructions, P/N 315-033090

for the list of compatible

devices.

8. All terminals are power

limited.

1. All wiring must comply with

national and local codes.

. In order to provide adequate

protection, it is recom-

mended that you do not

install more than 0 devices

on a single HLIM.

3. Minimum wire gauge is

18 AWG.

4. The total wire resistance

(both wires) between HLIMs

cannot exceed 0 ohms.

5. Do not install more than 15

HLIMs per DLC loop.

6. All circuits are supervised.

7. Refer to DLC Installation

Instructions, P/N 315-033090

for the list of compatible

devices.

8. All terminals are power

limited.

ANALOG LOOP

LINE 1

LINE 2

IN IN OUT OUTIN IN OUT OUTIN IN OUT OUT

TO ANALOG

LOOP RETURN

INSIDE ENCLOSURE

TO ANALOG

LOOP FEED

LINE 1

LINE 2

LINE 1

IN IN OUT OUT

IN IN OUT OUT IN IN OUT OUT

ININ

OUTOUT

ININ

OUTOUT

ININ

OUTOUT

Siemens Building Technologies

Fire Safety

P/N 315-033170-3

Figure 4

Mounting

Mechan cal Installat on (See F gure 4)

 Use a standard 3 1/2- nch deep, double gang electr cal sw tchbox or a 4- nch

square electr cal box that s 2 1/8 nches deep.

 Connect the f eld w r ng. Press the HLIM nto the box and fasten the

module plate to the box.

 Cover the module front plate w th the plate suppl ed and fasten w th screws

suppl ed.

ELECTRICAL RATINGS Input power: 24 VDC, 1mA max

SWITCHPLATE

4-INCHES SQUARE

(SUPPLIED)

SWITCHPLATE

(SUPPLIED)

4-INCHES SQUARE

4-INCH SQUARE BOX

2 1/8-INCHES DEEP

DOUBLE GANG BOX

3 1/2-INCHES DEEP

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 0793

Siemens Building Technologies, Ltd.

Kenview Boulevard

Brampton, Ontario L6T 5E4 P/N 315-033170-

Indice

Altri manuali Siemens Unità di controllo

Siemens

Siemens PM240 Istruzioni per il montaggio

Siemens

Siemens COM060 Manuale utente

Siemens

Siemens XDLC Manuale utente

Siemens

Siemens EcoView Manuale utente

Siemens

Siemens FDK:521H1134 Manuale utente

Siemens

Siemens 3WN 6 3WX3661-0JA00 Manuale utente

Siemens

Siemens SIMOTION D4 Series Manuale utente

Siemens

Siemens S-60 Manuale utente

Siemens

Siemens GAMMA instabus Touch control TC5 Manuale utente

Siemens

Siemens ASIsafe 3RK1205-0B.00 Manuale utente

Siemens

Siemens SIRIUS 3RK3 Manuale utente

Siemens

Siemens SINUMERIK 840D sl Foglio di istruzioni

Siemens

Siemens SINUMERIK 808D Manuale utente

Siemens

Siemens RUGGEDCOM RS900F Manuale utente

Siemens

Siemens SAFEDLINK Guida

Siemens

Siemens 3RK2 Series Manuale utente

Siemens

Siemens REP-1 Manuale utente

Siemens

Siemens SINAMIC G130 Manuale utente

Siemens

Siemens 3VL9800-3MJ00 Manuale utente

Siemens

Siemens SIRIUS ACT 3SU1400-1EK10-6AA0 Manuale utente

Siemens

Siemens Flowrite 599 Series Manuale del proprietario

Siemens

Siemens SINAMICS G120 Manuale utente

Siemens

Siemens CZM-4 Manuale utente

Siemens

Siemens SIMATIC S7 Documento tecnico

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente