Uniz SLASH 2 Manuale utente

USER

MANUAL

UNIZ DESKTOP PRINTER

APPLICABLE TO

SLASH 2

DISCLAIMER

Please read and understand the contents of this installation and user manual.

Failure to read the manual may lead to personal injury, inferior results or damage to the

SLASH 2 printers. Always make sure that anyone who uses the 3D printer knows and

understands the contents of the manual to make the most out of the SLASH 2 printer.

The conditions or methods used for assembling, handling, storage, use or disposal of the device are beyond

our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility

and expressly disclaim liability for loss, injuries, damage, or expense arising out of or in any way connected

with the assembly, handling, storage, use or disposal of the product. The information in this document was

obtained from sources which we believe are reliable. However, the information is provided without any

warranty, express or implied, regarding its correctness.

Intended use

SLASH Series 3D printers are designed and built for liquid crystal display (LCD) based on Stereo lithography

Appearance (SLA) modeling for various high quality photopolymer resins within a commercial/business

environment. The combination of precision and speed makes the SLASH 2 3D printers the perfect machines

for concept models, functional prototypes and also the production of small series.

UNIZ does not warrant that the operation of the Hardware Product will be uninterrupted or error-free. UNIZ is

not responsible for damage arising from failure to follow instructions relating to the Hardware Product's use.

UNIZs warranty does not apply: a) to damage caused by use with non-UNIZ products including third-party

resins; b) to damage caused by accident, abuse, misuse, flood, fire, earthquake, or other external causes; c)

to damage caused by operating the Hardware Product outside the permitted or intended uses described by

UNIZ; d) to damage caused by service (including upgrades and expansions) performed by anyone who is not

a representative of UNIZ; e) to a Hardware Product or part that has been modified to alter functionality or

capability without the written permission of UNIZ; f) to consumable parts, unless damage has occurred due

to a defect in materials or workmanship; g) to cosmetic damage, including but not limited to scratches, dents;

or h) if any UNIZ serial number has been removed or defaced. THIS WARRANTY GIVES YOU SPECIFIC

LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE

OR COUNTRY TO COUNTRY. UNIZ's RESPONSIBILITY FOR HARDWARE DEFECTS IS LIMITED TO

REPAIR OR REPLACEMENT SERVICE AS DETERMINED BY UNIZ IN ITS SOLE DISCRETION.

TABLE OF CONTENTS

A SLASH 2 3D PRINTER .............................................................................................................. 1

MEET THE PRINTER......................................................................................................................................................1

PACKING LIST ..............................................................................................................................................................5

SPECIFICATIONS ..........................................................................................................................................................6

B GET STARTED......................................................................................................................... 7

UNBOXING ..................................................................................................................................................................7

SOFTWARE PREPARATION...........................................................................................................................................8

C PRINTER ACTIVATE AND UPGRADE......................................................................................... 9

PRINTER NETWORK SETUP ..........................................................................................................................................9

ACTIVATE THE PRINTER .............................................................................................................................................12

UPDATE THE FIRMWARE ...........................................................................................................................................13

D UNIZ SOFTWARE...................................................................................................................15

INTRODUCTION TO UNIZ DESKTOP............................................................................................................................15

PREPARE PRINT FILE ..................................................................................................................................................23

PRINTER CONTROL ....................................................................................................................................................39

ADDITIONAL TOOLS...................................................................................................................................................47

EMAINTENANCE .....................................................................................................................51

PRINTER PLACEMENT AND LEVELING ........................................................................................................................51

BUILD PLATFORM AND RESIN TANK ..........................................................................................................................52

CHANGE LCD PROTECTIVE FILM.................................................................................................................................59

Z-AXIS COMPENSATION.............................................................................................................................................61

RESIN LEVEL CONTROL SYSTEM .................................................................................................................................62

CHANGE BOTTOM FILTER ..........................................................................................................................................68

RELEASE PRESSURE IN COOLING SYSTEM ..................................................................................................................69

FHELP AND SUPPORT ..............................................................................................................72

G CERTIFICATE .........................................................................................................................78