Vivotek AE2000 Manuale utente
Installation Guide for
Accommodating VIVOTEK Cameras in the Housing
AE2000
Camera Housing
The AE2000 camera housing, complying with IP66 standard, serves to provide protection against foreign substances and
water for VIVOTEK Cameras. Applicable to the following models: IP7131, IP7138, IP7151 and IZ7151.
Installation Guide - 2
AE2000 Camera Housing
AE2000 Camera Housing
1 2 3 4 5
1:Open the housing cover.
2:Release two screws both sides of camera bracket first and adjust the position of camera bracket by sliding it up and down. Use
the small wrench to do this. When completed, tighten the screws.
■ Detach the rectangular support from the camera bracket. Use the supplied L-type hex key wrench to do this.
3:Attach the camera to the rectangular support with an insulation pad in between; then secure the camera with the supplied
locking screw. Use the supplied L-type hex key wrench to do this.
4:Insert the rectangular support in the camera bracket and secure the rectangular support with the supplied locking screw. Always
check that the camera is firmly attached to the housing.
5:Connect the power cable and Ethernet cable to the camera.
For VIVOTEK Camera IP7131 and IP7138:
AE2000 Camera Housing
Installation Guide - 3
AE2000 Camera Housing AE2000 Camera Housing
1 2 3 4 5
1:Open the housing cover.
2:Release two screws both sides of camera bracket first and adjust the position of camera bracket by sliding it up and down. Use
the small wrench to do this. When completed, tighten the screws.
■ Detach the rectangular support from the camera bracket as it is not required for IP7151 and IZ7151 installation. Use the supplied L-type hex key wrench to do
this.
3:Attach the camera to the camera bracket with an insulation pad in between; then secure the camera with the locking screw. Use
the supplied L-type hex key wrench to do this. Always check that the camera is firmly attached to the housing.
4:Connect the power cable and Ethernet cable to the camera.
5:To turn on the light sensor of the camera housing, connect the circuits to the general I/O terminal block of the camera.
For VIVOTEK Camera IP7151 and IZ7151:
Installation Guide - 4
AE2000 Camera Housing
© 2008 VIVOTEK Inc. All rights reserved. 6F., No. 192, Lien-Cheng Rd., Chung-Ho, Taipei County, Taiwan
Tel: +886 2 82455282 Fax: +886 2 8245 5532 E-mail: [email protected] Http://www.vivotek.com
Altri manuali per AE2000
1
Indice
Altri manuali Vivotek Accessori per fotocamere
Vivotek
Vivotek AM-520 Manuale utente
Vivotek
Vivotek Fixed Dome AM-116 Manuale utente
Vivotek
Vivotek AM-516 Manuale utente
Vivotek
Vivotek IP8152 Manuale utente
Vivotek
Vivotek AM-108 Manuale utente
Vivotek
Vivotek AE-252 Manuale utente
Vivotek
Vivotek AE-153 Manuale utente
Vivotek
Vivotek Fixed Dome Series Manuale utente
Vivotek
Vivotek AM-21C Manuale utente
Vivotek
Vivotek Stainless Steel Housing Series Manuale utente
