WX-500-0168
© 2014 Wavetronix LLC. All rights reserved. Protected by US Pat. Nos. 6,556,916; 6,693,557; 7,426,450; 7,427,930; 7,573,400; 7,889,097; 7,889,098; 7,924,170; 7,991,542; 8,248,272;
8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,
Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-
ers. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.
8Terminate the SmartSensor 6-conductor cable
9Complete wiring
To land the 6-conductor cable into the terminal block section:
1 Aer routing your SmartSensor 6-conductor cable into the cabinet, strip
back the cable jacket and shielding on the service end of the cable.
2 Open the insulation displacement connectors on the plug by inserting a
small screwdriver into each square slot and rocking it back.
3 Insert the wire leads into the bottom side of the plug-in terminal accord-
ing to the colors of the wires and the labels on the plug. Make sure the
wires are completely inserted in the terminal.
4 Close the insulation displacement connector by reinserting the screwdriver into the square slot and
rocking it forward. e plug-in terminals will automatically complete the electrical connection. ere is
no need to manually strip the insulation on the end of each wire.
5 If you removed the plug to wire it, insert it back into the terminal block section.
e Click 222 has three RJ-11 jacks on the faceplate:
˽RS-485 A (yellow) – Connects the data bus from sensor 1 to the rack cards.
˽RS-485 B (orange) – Connects the data bus from sensor 2 to the rack cards.
˽RS-485 Bridge (blue) – Connects the conguration buses from sensors 1 and 2 to the
control bridge, to the detector rack cards, and to the T-bus. is jack combines the
input from ports C and D.
To connect and autobaud to the detector rack cards:
1 Connect from the Click 222 RS-485 A port to a bus 1 port on the appropriate rack
card. Connect from the Click 222 RS-485 B port to a bus 1 port on another rack card.
2 If you are using Click 112 cards, use a patch cord to share bus 1 between cards dedicated to the
same sensor. If you have more than two sensors in your system, repeat steps 1–3 to connect
bus 1 for all remaining rack cards.
3 Connect from a Click 222 bridge port to bus 2 of the rack cards.
4 Daisy-chain between the bus 2 ports of all of the rack cards for device conguration.
5 e Click 112/114 should begin to receive data from the sensor.
4 Turn on AC mains power.
5 Press the circuit breaker switch on the le side of the top DIN rail to switch power to the backplate.
6 Verify power is regulated by verifying that the DC OK LEDs are illuminated on the Click 201/202/204.
