Advantech PCM-4862 Manuale utente

PCM-4862

All-in-One 486 Single Board

Computer with SVGA, Ethernet,

and SSD

This document is copyrighted, 1996. All rights are reserved. The

original manufacturer reserves the right to make improvements to

the products described in this manual at any time without notice.

No part of this manual may be reproduced, copied, translated or

transmitted in any form or by any means without the prior written

permission of the original manufacturer. Information provided in

this manual is intended to be accurate and reliable. However, the

original manufacturer assumes no responsibility for its use, nor for

any infringements upon the rights of third parties which may result

from its use.

Acknowledgements

VIA is a trademark of VIA Technology, Inc.

AMD is a trademark of Advanced Micro Devices, Inc.

Award is a trademark of Award Software International, Inc.

Cyrix is a trademark of Cyrix Corporation.

IBM, PC/AT, PS/2 and VGA are trademarks of International

Business Machines Corporation.

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows ®is a registered trademark of Microsoft Corp.

SMC is a trademark of Standard Microsystems Corporation.

RTL is a trademark of Realtek Semi-Conductor Co., Ltd.

C&T is a trademark of Chips and Technologies, Inc.

UMC is a trademark of United Microelectronics Corporation.

All other product names or trademarks are properties of their

respective owners.

Part No. 2006862020 3rd Edition

Printed in Taiwan September 1997

Packing list

Before you begin installing your card, please make sure that the

following materials have been shipped:

• 1 PCM-4862 All-in-One Single Board Computer

• 1 utility disk with system BIOS, VGA BIOS, and Ethernet

utility programs

• 1 utility disk with SVGA utility programs and drivers for

Windows 3.1 and Windows 95

• 1 utility disk with Ethernet drivers

If any of these items are missing or damaged, contact your

distributor or sales representative immediately.

Contents

Chapter 1 General Information ................................. 1

Introduction............................................................................ 2

Features ................................................................................... 3

Specifications.......................................................................... 3

Standard SBC functions ....................................................... 3

Local-bus flat panel/VGA interface ..................................... 4

Ethernet controller function ................................................. 5

Solid state disk function ....................................................... 5

PC/104 bus expansion .......................................................... 5

Mechanical and environmental ............................................ 5

Board layout and dimensions ................................................ 6

Chapter 2 Installation ................................................ 7

Jumpers and connectors........................................................ 8

Locating jumpers ................................................................. 10

Locating connectors ............................................................. 11

Setting jumpers .................................................................... 12

Safety precautions ................................................................ 13

Installing the CPU................................................................ 13

Removing a CPU................................................................ 13

Installing a CPU ................................................................. 14

CPU type select (J1-J13, J17-J19) ..................................... 15

CPU power supply select (J4, J6) ....................................... 17

CPU clock select (J1, J2, J3).............................................. 17

CMOS setup (J14).............................................................. 17

Buzzer enabled/disabled (J21) ........................................... 17

Installing DRAM (SIMMs) ................................................. 18

Installing SIMMs ............................................................... 18

IDE hard drive connector (CN12) ...................................... 19

Connecting the hard drive .................................................. 19

Floppy drive connector (CN15)........................................... 20

Connecting the floppy drive ............................................... 20

Parallel port connector (CN16)........................................... 21

Parallel port IRQ ................................................................ 21

Keyboard and PS/2 connector (CN9) ................................. 21

Front panel connector (CN4) .............................................. 22

Power connectors (CN6, CN11, CN14)............................... 22

Peripheral power connector, -5V, -12V (CN6) ................... 22

Main power connector, +5V, +12V (CN11) ....................... 22

Fan power supply connector (CN14).................................. 22

Serial ports (CN13, CN8) .................................................... 23

COM1 RS-232 port (CN13)............................................... 23

COM2 RS-232/422/485 selection (CN8)........................... 23

VGA interface connections.................................................. 24

CRT display connector (CN1)............................................ 24

Flat panel display connector (CN2) ................................... 24

Ethernet configuration ........................................................ 25

10BASE-2/10BASE-5 AUI connector (CN7) .................... 25

10BASE-T connector (CN10) ............................................ 26

Network boot ...................................................................... 26

Watchdog timer configuration............................................ 26

Watchdog timer enable/disable .......................................... 26

Watchdog timer action (J23, J24)....................................... 26

Solid State Disk Configuration ........................................... 27

Memory devices ................................................................. 28

Memory address selection (J27) ........................................ 29

I/O address selection (J27) ................................................. 29

Drive emulated (J27) .......................................................... 30

SSD device and size selection (J31, J30) ........................... 31

SSD hardware enable/disable (J29).................................... 31

DOS 5.0 .............................................................................. 32

DOS 3.3 .............................................................................. 32

Booting from the Flash/ROM disk..................................... 33

Inserting memory devices .................................................. 33

Using a memory manager (EMM386.EXE) ...................... 34

Chapter 3 Software Configuration ......................... 33

Introduction.......................................................................... 34

Utility disk ............................................................................ 34

VGA display software configuration .................................. 36

Connections for four standard LCDs ................................. 38

Connections to Sharp LM64183P

(640 x 480 DSTN MONO LCD)........................................ 38

Connections to PLANAR EL

(640 x 480 AD4 EL)........................................................... 39

Connections to Toshiba LTM09C016

(640 x 480 TFT Color LCD) .............................................. 40

Connections to Sharp LM64C142

(640 x 480 DSTN Color LCD)........................................... 41

Ethernet software configuration......................................... 42

Chapter 4 Award BIOS Setup .................................... 45

System test and initialization .............................................. 46

System configuration verification ..................................... 46

AWARD BIOS setup............................................................. 47

Entering setup..................................................................... 47

Standard CMOS setup........................................................ 48

BIOS features setup............................................................ 49

CHIPSET features setup .................................................... 50

Power management setup ................................................... 51

Load BIOS defaults............................................................ 52

Change password ................................................................ 53

Auto detect hard disk ......................................................... 54

Save & exit setup................................................................ 54

Exit without saving............................................................. 54

Chapter 5 SVGA Setup............................................... 55

Simultaneous display mode ................................................. 56

Sleep mode ............................................................................ 56

Software support .................................................................. 57

Driver installation ................................................................ 58

Windows setup ................................................................... 59

AutoCAD R12.................................................................... 62

Lotus 1-2-3 and Lotus Symphony...................................... 64

VESA ................................................................................. 66

Word ................................................................................... 67

WordPerfect ........................................................................ 68

Appendix A Programming the Watchdog Timer .... 71

Appendix B Installing PC/104 Modules .................... 73

Installing PC/104 modules................................................... 74

Appendix C Pin Assignments ................................... 77

CRT display connector (CN1)............................................ 78

Flat panel display connector (CN2) ................................... 78

PC/104 connectors (CN3, CN5)......................................... 79

Front panel connector (CN4) ............................................. 80

Peripheral power connector (CN6)..................................... 80

10BASE-2/10BASE-5 AUI connector (CN7) .................... 80

COM2 RS-232/422/485 serial port (CN8)......................... 81

Keyboard and mouse connector (CN9) .............................. 81

Ethernet 10BASE-T connector (CN10) ............................. 82

Main power connector (CN11)........................................... 82

IDE hard drive connector (CN12) ...................................... 82

COM1 RS-232 serial port (CN13) ..................................... 83

Fan power connector (CN14) ............................................. 83

Floppy drive connector (CN15) ......................................... 84

Parallel port connector (CN16) .......................................... 85

Appendix D Optional Extras ..................................... 87

PCM-10586-1 Cable kit for PCM-4862/5860.................... 88

PCM-20486-1 Boot ROM binary files for............................

PCM-4860/4862 ................................................................. 88

Chapter 1 General Information 1

General

Information

This chapter gives background informa-

tion on the PCM-4862.

Sections include:

• Card specifications

• Card layout and dimensions

CHAPTER

2PCM-4862 User's Manual

Introduction

The PCM-4862 is an enhanced, all-in-one single board 486

computer with an on-board Ethernet interface, local-bus SVGA

controller and solid state disk. The PCM-4862 offers all the

functions of an AT-compatible industrial computer on a single

board, but it fits in the space of a 5¼" floppy drive (only 5.75" x

8"). For maximum performance, the PCM-4862 also supports 2nd

level cache sizes from 128 KB to 512 KB (32 KB x 8, 64 KB x 8,

or 128 KB x 8).

On-board features include two serial ports (RS-232 and RS-232/

422/485), one parallel port, an enhanced IDE hard-drive controller

(for up to two drives), a floppy-drive controller and a keyboard/PS/

2 mouse interface. The board's watchdog timer can automatically

reset the system or generate an interrupt if it stops due to a program

bug or EMI problem.

An on-board solid state disk (SSD) emulates a floppy drive using

EPROM or Flash memory devices. You access the SSD using

standard DOS commands or BIOS I/O. The system can even boot

from the SSD. Disk capacity is up to 1.44 MB, depending on the

size of the memory chips. If you use Flash memory, you can read

and write to the disk just like a floppy. If you use EPROM, the disk

is read-only and you must program the chips with an EPROM

programmer.

The PCM-4862 also complies with the "Green Function" standard

and supports three types of power saving features: Doze mode,

Standby mode, and Suspend mode.

All display and Ethernet configuration is done through software. A

single Flash chip holds the system BIOS, VGA BIOS and the

network boot ROM image. This minimizes the number of chips and

eases configuration. You can change the display BIOS or install a

boot ROM simply by programming the Flash chip.

If you need any additional functions, you can add up to six

industry-standard PC/104 expansion modules. For those who

require special functions, we have developed a PC/104 to ISA

adaptor so you can use your standard ISA card.

Altri manuali per PCM-4862

Indice

Altri manuali Advantech Scheda madre

Advantech

Advantech PCA-6166 Manuale utente

Advantech

Advantech SIMB-A21 Manuale di installazione e funzionamento

Advantech

Advantech PCM-4386 Manuale di installazione e funzionamento

Advantech

Advantech PCM-4825 Manuale utente

Advantech

Advantech PCM-4862 Manuale di installazione e funzionamento

Advantech

Advantech SOM-5871 Manuale utente

Advantech

Advantech AIMB-780 Manuale utente

Advantech

Advantech B+B SmartWorx Airborne WLNN-EK-DP551 Manuale utente

Advantech

Advantech AIMB-581 Manuale utente

Advantech

Advantech AIMB-228 Manuale di installazione e funzionamento

Advantech

Advantech PCA-6743 Manuale di installazione e funzionamento

Advantech

Advantech POS-760F Manuale di installazione e funzionamento

Advantech

Advantech RSB-6410 Manuale utente

Advantech

Advantech AIMB-286 Manuale utente

Advantech

Advantech MIO-5850 Manuale utente

Advantech

Advantech ASMB-922I Manuale di installazione e funzionamento

Advantech

Advantech PCI-6881 Series Manuale utente

Advantech

Advantech ASR-1000K-00A1E Manuale di installazione e funzionamento

Advantech

Advantech SOM-5787 Manuale utente

Advantech

Advantech PCI-6771 series Manuale utente

Advantech

Advantech HPC-7485 Manuale utente

Advantech

Advantech PCA-6774 Manuale utente

Advantech

Advantech SIMB-M22 Manuale utente

Advantech

Advantech PPC-MB-8260AE Manuale di installazione e funzionamento

Manuali Scheda madre popolari di altre marche

DFI

DFI SD170 Manuale utente

ASROCK

ASROCK ROMED8-2T Manuale utente

Asus

Asus P2L97A Manuale utente

Winmate

Winmate IC70 Manuale utente

Asus

Asus MES-B Manuale utente

Grantech

Grantech SYS8F377VGGA-3OMN Manuale utente

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuale utente

Gigabyte

Gigabyte GA-9IVDT Manuale utente

Texas Instruments

Texas Instruments ADS8372EVM Manuale utente

Commell

Commell MS-C73 Manuale utente

IBT Technologies

IBT Technologies MB860 Manuale utente

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuale utente

Biostar

Biostar M7VIT Bravo Istruzioni per l'uso e l'installazione

Intel

Intel D33217CK Manuale utente

Asus

Asus F1A55-M LX PLUS R2.0 Manuale utente

EPC

EPC EPC9147C Manuale utente

Asus

Asus EX-B760M-V5 D4 Manuale utente

EPOX

EPOX MU-8KHA0010 Manuale utente