6
EN
Installation instructions
• Remove the appliance from the carton box, then
remove the external and internal packaging and
wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See == > Warranty).
• Let the appliance stand upright for about 2 hours.
This is to reduce the malfunction of the cooling
system from improper handling during transpor-
tation.
• Clean interior surface with warm water and soft
cloth. (See == > Cleaning and Maintenance).
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
• Optimum working ambient temperature is be-
tween 16°C and 32°C. Otherwise, the functional-
ity will be limited.
• Ensure that there is sufficient ventilation. Keep a
minimum distance of 10cm around the appliance.
Do not block the ventilation holes.
• For energy savings, always make sure the door
is closed.
Operation
The appliance is divided into 2 separate zones. The “UPPER ZONE“ and “LOWER ZONE“ of the appliance are
cotrolled independently with the use of the control panel (2).
Upper zone
U1 L1U2 L2U3 L3T1 S1
Lower zone
Temperature control and display
• Plug into a suitable electrical outlet, “888” will be
blinked for few seconds and beep sound will be
heard for the default factory setting.
• Then, temperature of the upper zone and lower
zone will be shown on the display (U2/L2).
• Next, set the temperature in either zone by press-
ing the “+” or “-“ key of button (U1/L1) [Range:
39°F (4°C) to 68°F(20°C)]. The zone temperature
has a tolerance of + / - 5°F (+/- 3°C) from setting
depending on number of stored bottles & ambi-
ent temperature conditions.
Switch ON/OFF
• Press and hold S1 button for 3 to 4 seconds to
switch ON / OFF the appliance.
• After switch OFF the appliance, both displays (U2
and L2) will become dark.
Interior lighting
• Press either U3 or L3 button to turn ON the light
of UPPER ZONE or LOWER ZONE of the appli-
ance correspondingly.
• Press again the U3 or L3 button to turn OFF the
light of UPPER ZONE or LOWER ZONE.
• The interior light will keep on lighting if it is not
pressed to turn OFF.
Temperature unit conversion
• The temperature display can be changed be-
tween Celsius (°C) and Fahrenheit (°F) by press-
ing the button (T1).
Key Lock mode
• If no button is touch within 3 to 5 seconds, then
the appliance will enter into “Key Lock” mode.
Under the “Key Lock” mode, the button has no
response unless you cancel the “Key Lock” mode.
• To cancel the “Key Lock” mode, press & hold
the U1 button (Press both “+” and “-“ keys at the
same time for few seconds). Then, the “Key Lock”
mode will then be cancelled.
Note: The door of the appliance can be locked at
the bottom (8) by the keys (Supplied)
