ATI Technologies Scorpion X2 Manuale utente

Scorpion X2 Pad

Part # A.5.10.1015

-Installation Instructions-

Thank you for purchasing an ATI product!

Buttpad Installation

Point the shotgun in a safe direction and place the safety in the "on" position. Next pull back the

slide, and carefully inspect the chamber to be sure the shotgun is unloaded.

www. ATIgunstocks.com Page 1

Step #1

Cut out the buttpad template below.

Note: If your ATI buttstock already has pre-drilled

holes for buttpad installation, skip to step #7.

Step #2

Pull down the latch lever and slide the ATI buttstock away

from the buffer tube.

Figure 1

Step #3

Place the buttpad template onto the buttstock and

secure the template to the buttstock with tape.

NOTE: Make sure the paper template is aligned

perfectly with the outside profile of the

buttstock. If the template is not aligned correctly,

the buttpad will not correctly assemble to the

stock.

Figure 2

Figure 3

Scorpion X2 Pad

Part # A.5.10.1015

-Installation Instructions-

Thank you for purchasing an ATI product!

Buttpad Installation

Step #4

With the template secured to the buttstock, use a

1/4" drill bit to drill 2 straight holes on each side of

the buttstock. Use the designated "X" in circles on

the template as markers for these 2 holes.

NOTE: ATI is NOT responsible for broken drill bits

Figure 4

Step #5

Using the circle on the template and the same 1/4"

drill bit, drill the single hole on the bottom of the

buttstock 1/8" deep.

NOTE: This hole will not be drilled through, you

must only drill 1/8" into the buttstock. The best

way to drill 1/8" is to measure 1/8" from the edge

of the drill bit and then place tape at the 1/8"

mark so you don't drill any deeper.

1/8"

Figure 5A

Figure 5B

Step #6

Remove the buttpad template and clean the

buttstock of any burrs and drilling material.

Figure 6

Step #7

Place the buttpad on the rear of the buttstock and

using a T-20 torx driver, install the (2) 8 x 48-2 x 1/2"

plastite torx head screws until snug.

Page 2

Figure 7

Questo manuale è adatto per i seguenti modelli

Altri manuali ATI Technologies Strumento di misura

ATI Technologies

ATI Technologies 2i Manuale utente

ATI Technologies

ATI Technologies 2i Manuale utente

ATI Technologies

ATI Technologies Q46H/65 Manuale utente

ATI Technologies

ATI Technologies Q45P Manuale utente

ATI Technologies

ATI Technologies Q45S/87 Manuale utente

ATI Technologies

ATI Technologies Q45H/62 Manuale utente

ATI Technologies

ATI Technologies PQ45H Manuale utente

ATI Technologies

ATI Technologies Q46 Series Manuale utente

ATI Technologies

ATI Technologies C12-17 Manuale utente

ATI Technologies

ATI Technologies SmartTachSmartTach Manuale utente

ATI Technologies

ATI Technologies 39-0050 Guida

ATI Technologies

ATI Technologies A15/82 Manuale utente

ATI Technologies

ATI Technologies Q-Card Scheda tecnica

ATI Technologies

ATI Technologies 2H Manuale utente

ATI Technologies

ATI Technologies Q46 Series Manuale per l'uso e la cura

ATI Technologies

ATI Technologies Q46P Manuale utente

ATI Technologies

ATI Technologies Q45CT Manuale utente

ATI Technologies

ATI Technologies Q46H/79PR Manuale utente

ATI Technologies

ATI Technologies TDA-110P Manuale

ATI Technologies

ATI Technologies Q45R Manuale utente

ATI Technologies

ATI Technologies 39-0215 Manuale utente

ATI Technologies

ATI Technologies Q45D Manuale utente

ATI Technologies

ATI Technologies Q45D Manuale utente

ATI Technologies

ATI Technologies Q46 Series Manuale per l'uso e la cura

Manuali Strumento di misura popolari di altre marche

Suaoki

Suaoki D40 Manuale utente

Elster

Elster BK-G1.6 Manuale utente

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuale

Duratool

Duratool D03128 Manuale utente

Vega

Vega VEGAPULS 65 Manuale utente

Tonghui

Tonghui TH2618B Manuale utente

Tenmars

Tenmars TM-801 Manuale utente

MSR

MSR 145 Manuale utente

TPS

TPS WP-82 Manuale utente

ELMETRON

ELMETRON CP-511 Manuale utente

PCB Piezotronics

PCB Piezotronics 003C30 Manuale utente

Tenma

Tenma 72-10465 Manuale utente

Endress+Hauser

Endress+Hauser Proline Promag 50 Specifiche tecniche

Siemens

Siemens SITRANS F Coriolis FCT030 Manuale elenco delle parti

KLINGER

KLINGER CMF V Series Manuale utente

EXFO

EXFO FTB-2 Manuale operativo e di manutenzione

Keysight

Keysight M8290A Manuale utente

ADTEK

ADTEK MW-5 Manuale utente