AUDAC CS55 Istruzioni per l'installazione e il funzionamento

Indice

Altri manuali AUDAC Altoparlanti

Manuali Altoparlanti popolari di altre marche

argon audio

argon audio IE20 Manuale utente

Denon

Denon SC-N7 Manuale utente

Gemline

Gemline Ace 3952 Manuale utente

Focal

Focal ON WALL 300 Manuale di istruzioni

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuale utente

SoundLogic

SoundLogic BCCS-6/6395 Manuale utente

Peavey

Peavey DTH 218 Manuale utente

Avantree

Avantree Pluto Air Manuale utente

Morel

Morel Integra Series INTEGRA OVATION 4 Manuale utente

Oppo

Oppo SONICA Manuale utente

Bose

Bose SoundLink Wireless Music System Manuale utente

Rocksteady

Rocksteady Stadium Manuale utente

Bowers & Wilkins

Bowers & Wilkins 4 Manuale utente

Sonance

Sonance SONOS OUTDOOR Series Manuale utente

Electro-Voice

Electro-Voice EVID FM4.2 Manuale utente

Pioneer

Pioneer XW-HTD630 Manuale utente

Onn

Onn BWA16AA002 Manuale utente

HP

HP GL313AA - USB Speakers PC Multimedia Manuale utente

PROFESSIONAL AUDIO EQUIPMENT

Built-in Ceiling or Wall Spea er CS55

User Manual &

Installation Guide

Ceiling Speaker

CS55

AUDAC

1

11

1

A U D A C P R O F E S S I O N A L A U D I O E Q U I P M E N T

User Manual & Installation Guide

 AUDAC

http://www.audac.eu

info@audac.eu

Before connecting or installing this product, first read these instructions carefully

2

22

2

Warning

• Use only the correct amplifier output voltage and impedance, exceeding these limits could

cause fire or other failures.

• Avoid explosions: do not use the spea er around gasoline, thinner or other combustibles.

• Only install the spea er in locations that can structurally support the weight of the spea er.

Not doing this may result in the spea er falling down.

• Do not use any other method than specified to mount the spea er. If extreme force is applied

to the spea er, it could fall down.

• Attach a safety wire to the spea er when it is mounted high above the ground. Failure in doing

so could cause the spea er to fall down for any reason.

• Avoid mounting the spea er in locations exposed to constant vibrations. The mounting points

can be damaged by excessive vibration, potentially causing the spea er to fall down.

Caution

• Avoid electric shoc s: switch off the amplifier power when connecting the spea er.

• Avoid installing the spea er in locations exposed to solvents, acids, smo e and heaters, as

excessive exposure to these factors could result in spea er failure, fire or electric shoc .

• Do not operate the spea er for an extended period of time at distorted sound. This could

cause (irreparable) damage to the spea er.

• Do not stand or sit on, nor hang down from the spea er, as this may cause failure of the

spea er.

3

33

3

Installation

• Ma e a hole with a diameter of 165mm. This is very easy when you use the carton that is

inside of the box.

• Ta e the grille from the spea er and put the spea er in the hole.

• Tighten the screws of the spea er so that the spea er will be clasped on the ceiling or wall.

• Inside of the box, you can find gums. Put these gums on the sides of the grille. Then put the

grille on the spea er. The gums on the sides of the grille will prevent the grille from falling

down.

Connections

Impedance

• Plug the spea er cable into the soc et at the bac of the spea er. Ma e sure to match the

impedance. Always plug one cable into the common soc et and the other cable into the

soc et of the desired power tapping.

Ca le

• Be sure that you use the following polarities for your spea er cable, when using several

spea ers in the same location:

Red : Negative or common

Blac : Positive

• The total rated input of all connected spea ers may not exceed the amplifiers output.

4

44

4

Specifications

Nominal Power 10 Watt

SPL (1W/1m) 93 dB

SPL (20W/1m) 100.8 dB

Impedance 8 Ohm

Line transformer impedance 1600 Ohm/6W

3300 Ohm/3W

6600 Ohm/1,5W

Frequency Response -3dB Fo - 14 Hz

Frequency Response -10 dB Fo - 16 Hz

Dimensions (Diameter x Depth) 205x70 mm

Cut-out Diameter 165 mm

Weight 0,70 Kg

Mounting 4 Screws with clamp

Color White RAL9010