Cisco HWIC-1FE - WAN Interface Card Expansion... Manuale di istruzioni

OL-12851-01

Connecting 1- and 2-Port Fast Ethernet

High-Speed WAN Interface Cards to the Network

Revised: 04/20/2009, OL-12851-01

This guide describes how to connect Cisco 1- and 2-Port Fast Ethernet high-speed WAN interface cards

(HWICs) to your network. It contains the following sections:

•Cisco 1- and 2-Port Fast Ethernet HWICs, page 1

•Connecting Fast Ethernet HWICs to a Network, page 4

•Related Documents, page 4

•Obtaining Documentation, Obtaining Support, and Security Guidelines, page 5

Cisco 1- and 2-Port Fast Ethernet HWICs

The Cisco Fast Ethernet HWICs are single-wide interface cards, available as a 1-port HWIC

(HWIC-1FE) and as a 2-port HWIC (HWIC-2FE), that provide Cisco modular and integrated services

routers with additional line-rate Layer 3 routed ports. (See the “Fast Ethernet HWICs Supported

Platforms” section on page 2.)

Fast Ethernet HWICs Standards

The Fast Ethernet HWICs are designed in accordance with IEEE 802.3 10BASE-T Ethernet and IEEE

802.3u 100BASE-TX Fast Ethernet standards.

The following IEEE standards are also supported:

•802.1p

•802.1u

•802.1x

Fast Ethernet HWICs Restrictions

The following features are not supported on the Fast Ethernet HWICs:

•Cisco Interswitch Link (ISL) tagging

Connecting 1- and 2-Port Fast Ethernet High-Speed WAN Interface Cards to the Network

Cisco 1- and 2-Port Fast Ethernet HWICs

OL-12851-01

•Connectivity fault management (CFM)

•Flow control

•Online insertion and removal (OIR)

Fast Ethernet HWICs Supported Platforms

Install the Fast Ethernet HWICs in the following Cisco routers:

•Cisco 1841 integrated services router

•Cisco 2800 series integrated services routers

•Cisco 3800 series integrated services routers

Note Insert Fast Ethernet HWICs into HWIC slots only. They do not fit into WIC/VIC slots.

Table 1 shows the maxmum number of each type of HWIC that may be installed, the slot locations, and

slot numbering for each platform.

For information about HWIC slot locations on each router, see the “Interface Card Slot Locations and

Numbering on Cisco Access Routers” section of the Cisco Interface Cards for Cisco Access Routers

guide located at:

http://www.cisco.com/en/US/docs/routers/access/interfaces/ic/hardware/installation/guide/oview_ic.ht

Fast Ethernet HWICs Port Numbering

Port numbers identify the interfaces on the modules and interface cards installed in the router. Modules

and interface cards are identified by three digits: slot number/subslot number/port number.

For example, HWIC port 0 in HWIC subslot 1 of router slot 0 is represented as:

interface FastEthernet 0/1/0

Table 1 Supported Platforms for Fast Ethernet HWICs

Chassis HWIC-1FE HWIC-2FE HWIC slots

Cisco 1841 1 may be installed 1 may be installed1

1. Requires Cisco IOS Release 12.4(24)T or later.

Slot 0 and slot 1

Cisco 2801 1 to 2 may be installed 1 may be installed1Slot 1 and slot 3 support HWICs

Cisco 2811 1 to 2 may be installed 1 may be installed1Slot 0 to slot 3

Cisco 2821 1 to 2 may be installed 1 may be installed1Slot 0 to slot 3

Cisco 2851 1 to 2 may be installed 1 may be installed1Slot 0 to slot 3

Cisco 3825 1 to 4 may be installed 1 to 2 may be installed Slot 0 to slot 3

Cisco 3845 1 to 4 may be installed 1 to 2 may be installed Slot 0 to slot 3

Connecting 1- and 2-Port Fast Ethernet High-Speed WAN Interface Cards to the Network

Cisco 1- and 2-Port Fast Ethernet HWICs

OL-12851-01

Fast Ethernet HWICs LEDs

The Fast Ethernet HWICs use three LEDs per port to indicate full- or half-duplex operation, collisions,

speed, transmit/receive activity, and link status. Figure 1 and Figure 2 show the HWIC-1FE and

HWIC-2FE faceplates, and Table 2 describes the functions of the LEDs.

Figure 1 HWIC-1FE Faceplate

Figure 2 HWIC-2FE Faceplate

FE 0

100

HWIC-1FE

FDX/COL

LINK/ACT

158059

Table 2 Fast Ethernet HWIC LEDs

LED Meaning States

FDX/COL Duplex/Collision On = Full-duplex

Off = Half-duplex

Blinking = Collision activity

100 Speed On = 100 Mbps

Off = 10 Mbps

LNK/ACT Link Status On = Link pulses detected

Off = No link pulses detected

Blinking = Transmit or receive activity

158060

FE 0

100

HWIC-

2FE

FDX/COL

LINK/ACT

FE 1

Connecting 1- and 2-Port Fast Ethernet High-Speed WAN Interface Cards to the Network

Connecting Fast Ethernet HWICs to a Network

OL-12851-01

Connecting Fast Ethernet HWICs to a Network

To connect a Fast Ethernet HWIC to the network, do the following procedure:

Step 1 Confirm that the router is powered down.

Warning

To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,

connect the HWIC-1FE and HWIC-2FE interface cards only to intra-building or unexposed wiring or

cable. The intrabuilding cable must be shielded and the shield must be grounded at both ends. The

intra-building port(s) of the equipment or subassembly must not be metallically connected to

interfaces that connect to the OSP or its wiring. These interfaces are designed for use as

intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and

require isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient

protection in order to connect these interfaces metallically to OSP wiring.

Step 2 Insert the Fast Ethernet HWIC into an HWIC slot on the router. (See Installing Cisco Interface Cards in

Cisco Access Routers.)

Note Insert Fast Ethernet HWICs into HWIC slots only. They do not fit into WIC/VIC slots.

Step 3 Using the appropriate cables, connect the HWIC to your system.

Caution To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,

connect the 1-port HWIC (HWIC-1FE) and 2-port HWIC (HWIC-2FE) only to intrabuilding or

nonexposed wiring or cabling.

•For 10BASE-T operation, Category 3, 4, or 5 UTP cable may be used, for distances of up to

328 feet (100 meters).

•For 100BASE-TX operation, Category 5 UTP cable is required, for distances of up to

328 feet (100 meters).

•The HWICs support Auto-MDIX, so either straight-through or crossover cable can be used.

Step 4 Power up the router.

Related Topic Document Title

Regulatory compliance and safety

information

Cisco Network Modules and Interface Cards Regulatory Compliance and Safety

Information

http://www.cisco.com/en/US/docs/routers/access/interfaces/rcsi/IOHrcsi.html

Cisco IOS software website and reference

documentation

Cisco IOS Software

http://www.cisco.com/web/psa/products/index.html?c=268438303

Connecting 1- and 2-Port Fast Ethernet High-Speed WAN Interface Cards to the Network

Obtaining Documentation, Obtaining Support, and Security Guidelines

OL-12851-01

Obtaining Documentation, Obtaining Support, and Security

Guidelines

For information on obtaining documentation, obtaining support, providing documentation feedback,

security guidelines, and also recommended aliases and general Cisco documents, see the monthly

What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical

documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

CCDE, CCSI, CCENT, Cisco Eos, Cisco HealthPresence, the Cisco logo, Cisco Lumin, Cisco Nexus, Cisco Nurse Connect, Cisco Stackpower,

Cisco StadiumVision, Cisco TelePresence, Cisco WebEx, DCE, and Welcome to the Human Network are trademarks; Changing the Way We Work,

Live, Play, and Learn and Cisco Store are service marks; and Access Registrar, Aironet, AsyncOS, Bringing the Meeting To You, Catalyst, CCDA,

CCDP, CCIE, CCIP, CCNA, CCNP, CCSP, CCVP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems,

Cisco Systems Capital, the Cisco Systems logo, Cisco Unity, Collaboration Without Limitation, EtherFast, EtherSwitch, Event Center, Fast Step,

Follow Me Browsing, FormShare, GigaDrive, HomeLink, Internet Quotient, IOS, iPhone, iQuick Study, IronPort, the IronPort logo, LightStream,

Linksys, MediaTone, MeetingPlace, MeetingPlace Chime Sound, MGX, Networkers, Networking Academy, Network Registrar, PCNow, PIX,

PowerPanels, ProConnect, ScriptShare, SenderBase, SMARTnet, Spectrum Expert, StackWise, The Fastest Way to Increase Your Internet Quotient,

TransPath, WebEx, and the WebEx logo are registered trademarks of Cisco Systems, Inc. and/or its affiliates in the United States and certain other

countries.

All other trademarks mentioned in this document or website are the property of their respective owners. The use of the word partner does not imply

a partnership relationship between Cisco and any other company. (0903R)

Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and

figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and

coincidental.

Connecting 1- and 2-Port Fast Ethernet High-Speed WAN Interface Cards to the Network

Obtaining Documentation, Obtaining Support, and Security Guidelines

OL-12851-01

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Cisco Scheda di rete

Cisco

Cisco PA-4C-E 1 Manuale dell'operatore

Cisco

Cisco uBR10-SRP-OC12SML Manuale utente

Cisco

Cisco uBR10-MC5X20H Manuale utente

Cisco

Cisco Catalyst 4500 Dimensioni

Cisco

Cisco PA-FE-FX Manuale dell'operatore

Cisco

Cisco WAN Interface Card Cable WIC-1DSU-T1 Manuale utente

Cisco

Cisco LINKSYS PLTS200 Manuale utente

Cisco

Cisco Catalyst 4500 Series Manuale

Cisco

Cisco WEC600N Manuale utente

Cisco

Cisco WUSB54GSC Manuale utente

Cisco

Cisco NPE-175 Manuale dell'operatore

Cisco

Cisco ONS 15310-MA Manuale utente

Cisco

Cisco IDTA153 Manuale utente

Cisco

Cisco Linksys WUSB600N Manuale utente

Cisco

Cisco WAN Interface Card WIC-1DSU-56K4 Manuale utente

Cisco

Cisco WAE-674-K9 - Wide Area Application Engine... Manuale utente

Cisco

Cisco One-Port Serial WAN Interface Card Cable... Manuale utente

Cisco

Cisco Gigabit Switch Router Cisco 12012 Guida

Cisco

Cisco WUSB100 Manuale utente

Cisco

Cisco CE-100T-8 Manuale di istruzioni

Cisco

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module... Manuale di installazione e funzionamento

Cisco

Cisco PA-POS-1OC3 Manuale dell'operatore

Cisco

Cisco MGX-FRSM-2CT3 Manuale utente

Cisco

Cisco Gateway Controllers Istruzioni originali

Manuali Scheda di rete popolari di altre marche

FirstComm

FirstComm OBiWiFi5G Manuale utente

Sun Microsystems

Sun Microsystems Interface Adapter Manuale utente

TRENDnet

TRENDnet TU2-ETG Manuale utente

YASKAWA

YASKAWA SI-EN3 Manuale utente

Paradyne

Paradyne BitStorm 2600 IP DSLAM Manuale utente

Belkin

Belkin F5D7050 Manuale utente

3Com

3Com EtherLink 3C509B Manuale utente

TRENDnet

TRENDnet TEG-PCITX Manuale utente

Delta Electronics

Delta Electronics Braking Modules VFDB Series Manuale utente

TwinMOS

TwinMOS Booming Manuale utente

Dialogic

Dialogic Media Board DM/V1200BTEPEQ Manuale utente

Buffalo

Buffalo AirStation WLI-PCM-L11GP Manuale utente

National Instruments

National Instruments NI 9234 Manuale utente

Hama

Hama 49276 Manuale utente

Linksys

Linksys WCF54G - Wireless-G Compact Flash Card Manuale operativo

Compaq

Compaq Wireless LAN 100 Manuale utente

Bose

Bose PowerMatch Dante Manuale utente

TRENDnet

TRENDnet TEG-PCITXR Manuale utente