CTA ADD-ADMA Manuale utente
Articulating Desk Mount Arm with VESA Plate
ADD-ADMA
CONTENTS:
INSTRUCTIONS:
2A. When the C-Clamp is securely
attached to a surface, use the
provided security tool (C), attach to
security component, and rotate
closewise to put the C-Clamp in an
‘locked’ state. To loosen, rotate
counterclockwise with the security
tool.
Remove arm (D) from the
base clamp mount. Repeat
steps in reverse order to
re-install connection
2B. Align the (2) dimples on the underneath of the
security tool into the two holes on the security
component on the clamp as shown above
2C. Rotate counter-clockwise to
loosen and place the clamp in an
‘unlocked’ state. Continue rotating
until there is enough slack to rotate
the knob.Turn it clockwise to tighten
and place the clamp in a ‘locked’
state.
2
BASE CLAMP SECURITY SETUP
BASE MOUNT INSTALLATION ARM & BASE CLAMP
ADJUSTMENTS
If you need to remove the arm
from the base clamp, take the
provided tool (B), rotate, and
loosen connection.
12
3
Find the included base
pad (E) and peel off the
backing. Align to the
underneath of the
C-Clamp (D) and apply
pad. While the clamp is in unlocked mode, rotate the
knob at the bottom (as shown above) to loosen
or securely tighten to the table top.
ALIGNING SECURITY TOOL WITH SECURITY COMPONENT
A
B
C
D
E
F
E
DB
D
C
C
Articulating Desk Mount Arm with VESA Plate
ADD-ADMA
Each hinge of the product can be
adjusted easily with the provided tool (A).
Loosen to adjust and securely tighten
after preferred position is set.
When all hinges and joints are tightened, do not attempt to
forcibly flex the angles or positioning without loosening. Any
attempt to do so will possibly have an effect on product integrity
and CTA and manufacturer will not be responsible for any
mishandling.
JOINT ADJUSTMENTS
4
When routing cables from
device to the power source, use
provided clips (F) as shown to keep
the cables organized and tight to
the arms to avoid any slack.
CABLE
ROUTING
5
F
A
Indice
Altri manuali CTA Rack e supporto
CTA
CTA PAD-DSGK Manuale utente
CTA
CTA PAD-VADMWE Manuale utente
CTA
CTA ADD-CPOLEGN Manuale utente
CTA
CTA PAD-SWM Manuale utente
CTA
CTA PAD-TAM Manuale utente
CTA
CTA PAD-SSMA Manuale utente
CTA
CTA PAD-UGT Manuale utente
CTA
CTA PAD-ASKB10 Manuale utente
CTA
CTA PAD-PARAFPE Manuale utente
CTA
CTA PAD-ASKP Manuale utente
CTA
CTA ADD-PARAFSV Manuale utente
CTA
CTA PAD-SWM Manuale utente
CTA
CTA PAD-PARAFU Manuale utente
CTA
CTA ADD-PARAFS Manuale utente
CTA
CTA AUT-VDMC Manuale utente
CTA
CTA PAD-MSPC10 Series Manuale utente
CTA
CTA PAD-UATPB2 Manuale utente
CTA
CTA PAD-TPADM Manuale utente
CTA
CTA LT-LFSDM Manuale utente
CTA
CTA PAD-ADMA Manuale utente
