Dynojet Power commander V Manuale utente

2012-2016 KTM 250/350/450/500 XCW - PCV - 1I18-022.01 www.powercommander.com

Installation Instructions

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

THE IGNITION MUST BE TURNED

OFF BEFORE INSTALLATION!

YOU CAN ALSO DOWNLOAD THE

POWER COMMANDER SOFTWARE AND

LATEST MAPS FROM OUR WEB SITE AT:

www.powercommander.com

2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com

FUEL AND IGNITION

PARTS LIST

1 Power Commander

1 USB Cable

1 Installation Guide

2 Power Commander Decals

2 Dynojet Decals

2 Velcro Strips

1 Alcohol Swab

3 Zip Ties

2012-2016 KTM

250/350/450/500 XCW

I18-022.01 www.powercommander.com 2012-2016 KTM 250/350/450/500 XCW - PCV - 2

I18-022.01 www.powercommander.com 2012-2016 KTM 250/350/450/500 XCW - PCV - 3

1 Remove the seat as shown in Figure A.

2 Remove the left side panel covering the air filter as shown in Figure B.

3 Temporarily position the PCV module in the battery box compartment while

routing the PCV wiring harness down the left side of the bike, following along

the underside of the left frame rail as shown in Figure C.

4 Using the supplied velcro, secure the PCV to the inside of the rear fender as

shown in Figure C.

Make sure to clean both surfaces with the alcohol swab before attaching.

5 Using the supplied zip ties, secure the PCV harness to the factory cables.

6 Attach the ground wire ring lug from the PCV harness to the negative (-)

terminal on the battery.

FIG.A

FIG.C

FIG.B

I18-022.01 www.powercommander.com 2012-2016 KTM 250/350/450/500 XCW - PCV - 4

7 Remove the left and right side radiator shrouds.

8 Loosen the fuel tank by removing the bolt at the location shown in Figure D.

9 Prop the fuel tank upward so you can access the throttle body.

WARNING: Be very careful not to over stretch the fuel line.

10 Locate and unplug the stock wiring harness from the fuel injector as shown in

Figure E.

The fuel injector is located at the front of the throttle body. This connector is

difficult to reach and is not clearly visible in Figure E. Using a curved pair of

needle-nose pliers may help to unplug it from the fuel injector.

11 Attach the PCV connectors to the fuel injector and the stock wiring harness.

12 Locate and unplug the stock wiring harness from the Throttle Position Sensor

(TPS).

The TPS is located on the left side of the throttle body. This connector has

a rubber boot covering it that will need to be peeled back to unplug the

connector.

13 Attach the PCV connectors to the bike’s TPS and the stock wiring harness as

shown in Figure F.

FIG.D

remove

FIG.E

FIG.F

I18-022.01 www.powercommander.com 2012-2016 KTM 250/350/450/500 XCW - PCV - 5

14 Locate and unplug the stock Crank Position Sensor (CPS) connectors as

shown in Figure G.

This is a blue 2-pin connector pair located inside the left frame rail near the

hydraulic clutch line.

15 Attach the PCV connectors to the stock CPS connectors as shown in

Figure H.

16 Locate the Ignition Coil Spade connection under the tank near the front of the

frame as shown in Figure I.

17 Attach the PCV wiring harness spades in between the stock connectors as

shown in Figure I.

18 Using the supplied zip ties, secure the PCV wiring harness so it is free and

clear of any hot or moving parts.

19 Reinstall the fuel tank, the radiator shrouds on both sides, the left side panel,

and the seat.

FIG.I

FIG.G

FIG.H

Altri manuali per Power commander V

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Dynojet Accessori per motociclette

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power Commander V Ex Manuale utente

Dynojet

Dynojet 450f Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power Commander Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power Commander III Manuale utente

Dynojet

Dynojet Power Commander III Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power Commander III Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet POWER COMMANDER FC Manuale utente

Dynojet

Dynojet POWER VISION 4 Manuale utente

Dynojet

Dynojet Power Commander 3 Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet DYNOWARE RT - 224 DYNOS Manuale utente

Dynojet

Dynojet POWER VISION 3 Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Dynojet

Dynojet Power commander V Manuale utente

Manuali Accessori per motociclette popolari di altre marche

SRC

SRC B-TRK502-01-01-SL Manuale utente

3M Speedglas 9100 MP Manuale utente

hepco & becker

hepco & becker 6307520 00 01 Manuale utente

HOMCOM

HOMCOM AA0-077 Manuale utente

hepco & becker

hepco & becker 6307558 00 01 Manuale utente

Wunderkind Custom

Wunderkind Custom 106503-F15 Guida utente

Dräger

Dräger HPS 3500 Manuale utente

M-WAVE

M-WAVE SKI Manuale utente

Kuryakyn

Kuryakyn 6212 Manuale utente

hepco & becker

hepco & becker 6507504 00 01 Manuale utente

Tool it

Tool it PROMAX LCD 9.13G Manuale utente

Custom Dynamics

Custom Dynamics TruWrapz Manuale utente

Roof

Roof RO200 CARBON Manuale utente

Kabuto

Kabuto Japan IBUKI Manuale utente

PUIG

PUIG 5051 Manuale utente

rizoma

rizoma ZTH050 Manuale utente

Joubert

Joubert 10001711 Manuale utente

Sperian

Sperian Optrel p420 Manuale utente