ELARABY TORNADO TPC-700 Manuale utente
ﻚﻴﻛ نﺎﺒﻟا ﻊﻧﺎﺻ
ﻞﻴﻐﺸﺘﻟا ﻞﻴﻟد
ﻰﺑﺮﻌﻟا ﺔﻛﺮﺸﺑ ﺔﺻﺎﺧ ﺔﻠﺠﺴﻣ ﺔﻳرﺎﺠﺗ ﺔﻣﻼﻋ ﻰﻫ وﺪﻴﻧرﻮﺗ ﺔﻣﻼﻌﻟا هﺬﻫ
ﻞﻳدﻮﻣ
وﺪﻴﻧرﻮﺗ - ﻚﻴﻛ نﺎﺒﻟا ﻊﻧﺎﺻ كرﺎﻴﺘﺧﻹ ًاﺮﻜﺷ
TPC-700
2
-
-
3
4
-
5
6
6
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to an
appropriate waste disposal center.
Cleaning and Maintenance
and place it on the table top and wait for the water to clean.
3. Before packing and storing the product, make sure it is
completely cooled, clean and dry. Install the stirring rod on the
kneading cover and cover it with the kneading pan. The handle of
the main unit has hanging holes and can be hung on the wall.
Tips: Add a small spoonful of cooking oil when making the cake,
which will make the pancake easier to fall off.
5
Operation
FOR FIRST USE
Cleaning and Maintenance
unit, put the heat surface down, and let the pancake fall into the
pre-prepared dish. If the viscosity is too strong to fall off, you can
shake it gently , Or use fork to slowly pull away the stuck part from
the edge of the pancake.
When using for the first time, this product may have a little smoke
and smell. This is normal and will disappear soon. Ensure that the
product is well ventilated.
2．Please check whether all parts and accessories are intact and
undamaged.
3.Clean all parts according to chapter «V. CLEANING AND
MAINTENANCE».
4.The parts are thoroughly dried and assembled, and the product
is ready for use.
Disconnect the power supply and allow it to cool down before
cleaning.
1. Main unit: Wipe the inside and outside of the bread bucket with
a damp cloth. Please be careful not to use sharp or abrasive
objects to protect the non-stick coating. It must be completely dry
before use.
2. Kneading plate, kneading cover, stirring rod: You can directly
rinse with water and wipe carefully with a damp cotton cloth. It
is recommended not to soak the dough cover in the water. If you
accidentally enter the water, you can turn the dough cover back
4
2. Kneading:
As shown in the figure below, first put the ingredients and water
into the kneading pan, and then cover the kneading cover with the
stirring rod. Turn the handle by hand to start kneading. Look inside
through the transparent cover, and mix it evenly. After ready you
can remove the dough cover, and use the ready paste then .
4.To make pancakes with viscous paste:
As shown in the figure below, when the host is heated to the set
temperature, the indicator light on the switch is off. At this time,
grasp the handle of the host, put the heating surface of the host
downwards, and gently put it on the mixing plate to stick the
paste on it. (Pay attention to the operation by hand to gently
press down horizontally, and check the height of the paste , do
not let the paste overflow the pan), take it for about 1-2 seconds,
put the heating surface of the host up on the table and wait for
the surface Bake the dough into a pancake. Pay attention to the
color of the pancake. If it is suitable, you can pick up the main
Operation
3 .Host start:
Plug in the main unit, press the switch on the main unit, the
indicator light on the switch will light up, and start to work
3
Important Safeguards
Household Use Only
Operation
11. Oversize food, low fat food must not be cooked in this
appliance. They may cause fire or electric shock.
12. Do not attempt to dislodge food when donut maker is working.
It may cause injury or damage.
13. Do not use a damaged power socket
14. Any examination, repair, or adjustment for the appliance
should be made by the authorized service agent.
1-Installation: As shown in the figure, align the stirring rod to the
round hole in the middle of the face cover and install it in place;
- Know your Pancake Maker
Pancake machine Parts
Heat plate
Switch
Handle
Power cord
Knead dough cover
Beater
Knead dough Pan
Indice
Lingue:
Altri manuali ELARABY Elettrodomestico da cucina
