Event Lighting StrobeX Manuale utente

Strobe

Model No. StrobeX

USER MANUAL

For safety, please read this user manual carefully before initial use.

Event Lighting reserves the right to revise the manual at any time. Information and specifications within this

manual are subject to change without notice. Event Lighting assumes no liability or responsibility for any

errors or omissions. Please consult Event Lighting for any clarification or information regarding this item.

www.event-lighting.com.au Ver 2.0

www.event-lighting.com.au

CONTENTS

Safety Instructions

- Power input & power Linking

Product Installation

- Fuse replacement

Diagrams

- Lux chart

Control Board Operation

- DMX address setting

- DMX modes setting

- Manual modes setting

- Auto run setting

- Master/slave setting

DMX chart

Technical specifications

Warranty

www.event-lighting.com.au

Safety Instructions

WARNING

•Do not open this device, there is no user-serviceable parts inside. Risk of electric shock.

•Do not look at the light source when the device is on.

•CAUTION: This unit's housing may be hot during and after operation.

•Install this device in a location with adequate ventilation, at least 20 inch (50 cm) from adjacent surfaces.

•Do not leave any flammable material within 50 cm of this unit while operating or connected to power.

•Use a safety chain when mounting this device overhead.

•Do not operate this device outdoors or in any location where dust, excessive heat, water, or humidity may affect it.

•Do not operate this device if the housing, lenses, or cables appear damaged.

•Do not connect this device to a dimmer or rheostat.

•ONLY connect this device to a grounded and protected circuit.

•ONLY use the hanging bracket to carry this device.

•In case of a serious operating problem, stop using immediately.

•The maximum ambient temperature is 104° F (40° C). Do not operate this device at higher temperatures.

Power Input & Power Linking

This device has an auto-switching power supply work with input voltage range of 100~240 VAC, 50/60 Hz.

Link up to the maximum 8A. DO NOT exceed this number.

Product Installation

This device can be mounted in many orientations provided each individual device is secured by the use of correct

mounting bracket.

Use a safety chain when mounting this device overhead.

Fuse Replacement

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.

Before replacing the fuse, unplug mains lead.

Procedure:

Step 1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing (anticlockwise).

Step 2: Remove the old fuse from the fuse holder.

Step 3: Install the new fuse in the fuse holder.

Step 4: Replace the fuse holder in the housing and fix it.

www.event-lighting.com.au

Lux Chart

Menu Map

Address

<001> to <512>

DMX address

Channel

D4, S4, 6, 10

DMX channel modes

Manual

Strobe

<000> to <255>

Strobe speed, “0” no strobe, “001” to “255”, slow to

fast

BLOCK 1

<000> to <255>

Dimmer for Block 1

BLOCK 2

<000> to <255>

Dimmer for Block 2

BLOCK 3

<000> to <255>

Dimmer for Block 3

BLOCK 4

<000> to <255>

Dimmer for Block 4

Auto

Auto 1

Speed <000> to <255>

Select auto program and adjust auto run speed

Auto 2

Auto 3

Auto 4

….

Auto 12

Effect

on Auto

Dimmer

<000> to <255>

Adjust dimmer level and switch on strobe at

different speed for auto run

Strobe

<000> to <255>

Master

Select master/slave mode

Back L

Back light always stays on

100s

Back light turns off after 100s

200s

Back light turns off after 200s

300s

Back light turns off after 300s

Temp.

Temp XXº

Display current temperature on LED panel

Info

Test 1

Test mode without strobe

Test 2

Test mode with strobe

Hour

Display the hours had been used

Recover

Recover to factory default

www.event-lighting.com.au

DMX Address

After select the “Address” and press “Enter”, use “Up”and “Down”button to select the desired DMX address, press

“Entre”to save new setting.

DMX Modes

After select the “Channel” and press “Enter”, use “Up”and “Down”button to select the desired DMX channel mode,

press “Entre”to save new setting.

Manual Mode

After select the “Manual" and press “Enter”, use “Up”and “Down”button to select the block intensity from 000 to 255.

Then select strobe speed from 000 to 255, press “Enter" to save new setting.

Auto Mode

This fixture has 18 built-in programs. Entered "Auto" mode, use “Up”and “Down”button to select the built-in programs

"Auto 1 ~ Auto 18", then press the "Enter" to confirm. Use “Up”and “Down”button to select the operating speed of the

program from 000 to 255, press “Enter" to save new setting. You have to use “Effect on Auto”mode to adjust the

brightness and add strobe effect to auto run.

Effect on Auto

Use “Effect on Auto”to switch on dimmer and strobe function to auto mode. Entered “Effect on Auto” mode, use “Up”

and “Down”button to select dimmer level, then press the "Enter" to confirm. Use “Up”and “Down”button to select

strobe speed from 000 to 255, press “Enter" to save new setting.

Master/Slave Mode

Set the master fixture to auto or manual modes.

Entered “Master”mode, use “Up”and “Down”button to select “No”, press “Enter” to set fixture to slave mode.

Use DMX to link master and slave fixture together.

DMX Data

When there is a ‘*’ flashing, the StrobeX is not receiving any DMX signal. A solid ‘*’ indicated DMX signal is being

received. DMX takes priority over all other functions when a signal is being received.

Once DMX signal is lost, the StrobeX will revert back to the original setting, which also could be DMX or Manual or

Automatic mode.

DMX Chart

S4 channels Mode

Channel

Value

Function

000-005

No Function

006-255

Block 1 strobe slow to fast

000-005

No Function

006-255

Block 2 strobe slow to fast

000-005

No Function

006-255

Block 3 strobe slow to fast

000-005

No Function

006-255

Block 4 strobe slow to fast

www.event-lighting.com.au

D4 channels Mode

Channel

Value

Function

000-009

No Function

010-255

Block 1 dimmer 0% ~ 100%

000-009

No Function

010-255

Block 2 dimmer 0% ~ 100%

000-009

No Function

010-255

Block 3 dimmer 0% ~ 100%

000-009

No Function

010-255

Block 4 dimmer 0% ~ 100%

6 channels Mode

Channel

Value

Function

000-009

No Function

010-255

Master dimmer 0% ~ 100%

000-255

Strobe On Duration Short to Long

000-005

No Function

006-255

Strobe Speed Slow to Fast

000-128

No Function

129-171

Strobe effect 1

172-214

Strobe effect 2

215-255

Strobe effect 3

000-005

No Function

006-015

Block 1 only

016-025

Block 2 only

026-035

Block 3 only

036-045

Block 4 only

046-055

Block 1, 2, 4 only

056-065

Block 1, 3 only

066-075

Block 3, 4 only

076-091

Auto chase 1

092-107

Auto chase 2

108-123

Auto chase 3

124-255

Auto combination

000-255

Auto Run Speed slow to fast

www.event-lighting.com.au

10 channels Mode

Channel

Value

Function

000-255

Master dimmer 0% ~ 100%

000-010

No Function

011-255

Block 1 dimmer 0% ~ 100%

000-010

No Function

011-255

Block 2 dimmer 0% ~ 100%

000-010

No Function

011-255

Block 3 dimmer 0% ~ 100%

000-010

No Function

011-255

Block 4 dimmer 0% ~ 100%

000-255

Strobe On Duration Short to Long

000-004

No Function

005-255

Strobe Speed Slow to Fast

000-128

No Function

129-171

Strobe effect 1

172-214

Strobe effect 2

215-255

Strobe effect 3

000-075

No Function

076-091

Auto chase 1

092-107

Auto chase 2

108-123

Auto chase 3

124-255

Auto combination

000-255

Auto Run Speed slow to fast

www.event-lighting.com.au

TECHNICAL SPECIFICATIONS

Input Voltage: 100V~240V AC, 50/60Hz

Power Consumption: 480W

Power Connection: fixed

Fuse: 5AT

Light Source: 936 pcs 0.5W 6500K SMD5730 Cool White LED

Beam Angle: 120°

Output: 1450 lux @3M

PWM: 2000Hz

LED Lifespan: 50,000 hours

Dimming: 0 –100%

Strobe: 0.5 –23 Hz

DMX Protocol: DMX512

DMX Channel Mode: S4 / D4 / 6 / 10

DMX Interface: 3-pin XLR

Built-in Programming: Yes

Display: 4-button LCD control panel

Cooling: Sensor thermostat controlled variable speed fan

Housing Materials: ABS & steel

Housing Finishing: Matte Black

Net Weight: 6 kg

Overall Size: 425 x 215 x 125 mm

WARRANTY

Please refer to your local dealer or please contact Event Lighting Pty Ltd

Website: www.event-lighting.com.au.

Indice

Altri manuali Event Lighting Attrezzatura per DJ

Event Lighting

Event Lighting STROBEXRGB Manuale utente

Event Lighting

Event Lighting M1S180W Manuale utente

Event Lighting

Event Lighting LM7X12W Manuale utente

Event Lighting

Event Lighting M1S80W Manuale utente

Event Lighting

Event Lighting PAN8X1X30 Manuale utente

Event Lighting

Event Lighting M6B20W Manuale utente

Event Lighting

Event Lighting SABER2 Manuale utente

Event Lighting

Event Lighting ZP200LE Manuale utente

Event Lighting

Event Lighting SURF640 Manuale utente

Event Lighting

Event Lighting LM75 Manuale utente

Event Lighting

Event Lighting BM1S50W Manuale utente

Event Lighting

Event Lighting PAR12x12 Manuale utente

Event Lighting

Event Lighting PANBEAM4x4x10 Manuale utente

Event Lighting

Event Lighting PRO PAR PAR6X12OB Manuale utente

Event Lighting

Event Lighting NITROBALL2 Manuale utente

Event Lighting

Event Lighting BLINDER Series Manuale utente

Event Lighting

Event Lighting PAR12x8A Manuale utente

Event Lighting

Event Lighting M7W15RGBW Manuale utente

Event Lighting

Event Lighting STORM Manuale utente

Event Lighting

Event Lighting PIXBAR6x12 Manuale utente

Event Lighting

Event Lighting DERBY3 Manuale utente

Event Lighting

Event Lighting M7W40RGBW Manuale utente

Event Lighting

Event Lighting F100WWMZ Manuale utente

Event Lighting

Event Lighting F100WWMZ Manuale utente

Manuali Attrezzatura per DJ popolari di altre marche

ALPHA LITE

ALPHA LITE ALPHA 1500 Manuale del proprietario

Chauvet

Chauvet OVATION E-930VW Manuale utente

Zumtobel

Zumtobel APHRODITE Home Manuale utente

Snow Masters

Snow Masters Zig Oscillator Manuale utente

EuroLite

EuroLite 50530554 Manuale utente

Beamz

Beamz BUV243 Manuale utente

thomann

thomann Stairville DJ Lase 40-G MK-III Manuale utente

Eagletone

Eagletone 6 Eyes Flower Manuale utente

EuroLite

EuroLite FLD-1508 Manuale utente

Technical Pro

Technical Pro LG8xSEA Manuale utente

JB Systems

JB Systems Lounge Laser DMX Manuale utente

Lightmaxx

Lightmaxx Vega Halo 90 Manuale utente

Elation

Elation FUZE WASH Z350 Manuale utente

Maverick

Maverick MK3 WASH Manuale utente

Infinity

Infinity TF-260C7 Fresnel Manuale utente

Chauvet

Chauvet EVE E-50Z Manuale utente

Eliminator Lighting

Eliminator Lighting E 138 Manuale utente

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manuale utente