Contents and general safety instructions
III
Festo P.BE-CPX-FB6-EN en 1207c
Ta b l e o f c o n t e n t s
Intended use III..........................................................
Target group IV..........................................................
Service IV...............................................................
Important user information V..............................................
Instructions on this description VII...........................................
1. Installation 1-1...................................................
1.1 General installation instructions 1-3...................................
1.2 Settings of the DIL switches on the bus node 1-7.........................
1.3 Connecting the fieldbus 1-14..........................................
1.3.1 System structure on the remote bus 1-14........................
1.3.2 Pin allocation of the fieldbus interface 1-17.......................
1.3.3 Connecting the fieldbus 1-18..................................
1.3.4 Fieldbus baud rate and fieldbus length 1-21......................
1.4 Fibre-optic cable connection for Interbus 1-22............................
1.5 Selection of the power supply unit 1-23.................................
1.6 Pin allocation of power supply 1-23....................................
2. Commissioning 2-1................................................
2.1 Configuration and addressing 2-4.....................................
2.1.1 Ascertaining the address range 2-4............................
2.1.2 Address assignment of the CPX terminal 2-14.....................
2.1.3 Address assignment after extension/conversion 2-24..............
2.1.4 Bus configuration and addressing 2-27..........................
2.1.5 Switching on the power supply 2-28............................
2.1.6 Bus configuration with the CMD software 2-29....................
2.1.7 Bus configuration without CMD software 2-38....................
2.1.8 Process data entry via the CMD software 2-39....................
2.1.9 Configuration in the remote controller operating mode 2-42.........
2.2 Parametrisation 2-43................................................
2.2.1 Parametrisation concepts 2-45.................................
2.2.2 Device parametrisation with the CMD software 2-49...............
