Lippert Components Happijac Manuale utente

Rev: 07.15.19 Page 1 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Purpose

The purpose of this document is to provide instructions on:

• the installation of support legs (Fig. 1) on the sofa unit attached to the HappiJac Bedlift.

• the removal and installation of the HappiJac Bedlift support brackets (Fig. 2).

Fig. 1

Resources Required

• Cordless or electric drill or screw gun

• Appropriate drive bit

• Non-permanent marking method

• Sharp cutting instrument

• 1 ¼" self-tapping screws

Fig. 2

Rev: 07.15.19 Page 2 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Support Leg Installation

1. Remove the sofa unit from the HappiJac Bedlift and lay it flat face-down in a clean area.

2. The support legs can be adjusted, if needed. The 14-inch legs are normally are installed on the seat

cushion and the backrest uses the 15-inch. The legs can be adjusted by removing the two nuts and bolts

(Fig. 3A) and sliding the bottom part of the leg (Fig. 3B) in or out. Replace nuts and bolts after adjustment.

3. Measure about 12 inches from the outside edge of the cushion portion of the unit (Fig. 4). Feel for

strapping under the fabric and make a small mark between two straps that is close to both the 12-inch

measurement and to the inside edge of the steel frame. Repeat for the other side.

Fig. 4

12"

4. Fold one of the cushion support legs flat by pressing the adjustment button (Fig. 5A) and moving the

leg to one of the side holes (Fig. 5B) in the bracket.

5. Place the tab on the bracket end of the leg (Fig. 5C) on the measurement mark (step 3) with the leg

pointing towards center.

12"

inside edge

of frame

Seatback

Cushion

Fig. 3

Fig. 5

Rev: 07.15.19 Page 3 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

6. Repeat steps 4 and 5 on the other side and make sure the end of the legs do not overlap one over the other.

7. Keeping the brackets in the same position, press the adjustment button (Fig. 5A) and rotate one of the

legs to make sure it does not stick out beyond the seat cushion hinge when in the stored position. Repeat

for the other leg.

8. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab (Fig. 5C). Slide the tab into the cut slot so that support leg

bracket is upright and the arms of the bracket (Fig. 6A) are resting on the seat frame.

Fig. 6

9. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

10. Repeat steps 8 and 9 for the other cushion leg.

11. Find a centerpoint on the seatback between the two cushion leg brackets (Fig. 7A). Make a mark at that

point that is between the straps under the fabric and is close to the inside edge of the frame.

Seatback

inside edge

of frame

Fig. 7

cushion leg

brackets

Rev: 07.15.19 Page 4 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Fig. 8

12. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab. Slide the tab into the cut slot so that support leg bracket is

upright and the arms of the bracket are resting on the seat frame.

13. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

14. Fold all three legs down and reinstall the sofa on the HappiJac support brackets.

15. After the sofa is installed, lower the sofa until it is stopped by the microswitch. Make sure the legs gently

rest on the floor. Adjust the legs, if necessary.

Support Bracket Removal

1. Remove the sofa/dinette configuration or bed platform from the support brackets.

2. Remove the locking pin (Fig. 8A) from the bracket, then lower the bracket arm (Fig. 8B).

Rev: 07.15.19 Page 5 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

3. Remove the stop screw (Fig. 9A) from securing the support bracket, then remove the screw (Fig. 9B)

securing the trolley stop lock bracket (Fig. 9C) and remove the bracket. Set screws aside for later use.

4. Grasp the base of the sofa bracket (Fig. 10A) and pull up until the hooks are even with travel trolley

slots (Fig. 10B), then pull the sofa bracket away from the travel trolley.

5. Repeat for other brackets, if necessary.

Support Bracket Installation

1. Line up the hooks (Fig. 11A) on the end edge of the support bracket with the slots in the lower trolley

(Fig. 11B) then insert the bracket in to the trolley slots.

Fig. 10

Fig. 9

Fig. 11

Rev: 07.15.19 Page 6 CCD-0002704

As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you

have any questions, please do not hesitate to contact us at (574) 537-8900 or by email at [email protected]. Self-help tips,

technical documents, product videos and a training class schedule are available at lci1.com or by downloading the MyLCI app.

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

2. Pull down on the bracket to secure it in the trolley.

3. Line up the holes in the trolley stop lock bracket (Fig. 12A) with the top two holes in the lower trolley

(Fig. 12B). Secure the trolley stop lock bracket with the previously removed screw (Fig. 12C).

4. Secure the support bracket with the previously removed stop screw (Fig. 12D).

5. Repeat steps 2-4 for other support brackets, if necessary.

Fig. 12

Altri manuali per Happijac

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Lippert Components Accessori per automobili

Lippert Components

Lippert Components Solera Manuale utente

Lippert Components

Lippert Components Solera Slide Topper Manuale utente

Lippert Components

Lippert Components Solera Power Awning Manuale per l'uso e la cura

Lippert Components

Lippert Components SolidStep 3.0 Premium Step Manuale utente

Lippert Components

Lippert Components Happijack FT-DR2 Manuale utente

Lippert Components

Lippert Components SURESHADE POWER BIMINI Manuale utente

Lippert Components

Lippert Components Curt Rota-Flex Pin Box Manuale utente

Lippert Components

Lippert Components In-Wall Slide-Out Winnebago Istruzioni operative

Lippert Components

Lippert Components SolidStep Istruzioni per l'installazione

Lippert Components

Lippert Components Solera Classic Istruzioni operative e di manutenzione

Lippert Components

Lippert Components SolidStep XF Manuale utente

Lippert Components

Lippert Components X-Trek Manuale utente

Lippert Components

Lippert Components Sway Command Manuale

Lippert Components

Lippert Components Ground Control 2.0 Manuale utente

Lippert Components

Lippert Components Levelegs Manuale del proprietario

Lippert Components

Lippert Components Kwikee Revolution Step Series Manuale utente

Lippert Components

Lippert Components A-Frame Coupler Istruzioni per l'installazione

Lippert Components

Lippert Components ground control TT Istruzioni per l'installazione

Lippert Components

Lippert Components Jack-It Manuale utente

Lippert Components

Lippert Components OneControl Hotspot Manuale utente

Lippert Components

Lippert Components Solera Istruzioni per l'installazione

Lippert Components

Lippert Components COACH STEP Guida all'installazione

Lippert Components

Lippert Components PSX1 Manuale per l'uso e la cura

Lippert Components

Lippert Components SolidStep XF Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente