Conf
Submenu1
Submenu2
Submenu3
...
...
...
...
Submenu1
Item1
...
^
v
^
v
Editing
^ v >
> *
> *
>
>
>
...
Save
Undo
*
Slot
Master
Slot A
Slot B
Slot C
*+^
*
>
*
The main level of the configuration menu is
shown. You can select among menu items using
^v keys. To edit the setting, push >to start
editing, and *to get back to the menu. How to
edit, see chapter Editing.
Most data types are edited simply with ^v keys,
finally exiting with *key.
Floating point values, such as scaling and
lopass filter, are edited with ^v> keys: select digit
to edit (blinks) with >and change it with ^v.
When the decimal point is blinking, it can be
moved with ^v. The first digit can be replaced
with a minus sign.
To set a password, push ^to select Set (means
password will be used), then push >to enter the
new password. Cod.0 is shown. The password is
a sequence of six keypresses using all the four
keys. Enter the same password twice; if they
match, Set is shown again and you can exit with
*. If they didn’t match, Off is shown. Redo from
start. To disable a password, push vto select Off
and exit with *.
When all settings are done, exit from the menu
with *key. Two options are shown: Save to keep
the settings made, and Undo, to discard all the
changes. Select Save or Undo and push *.
Finally, exit from the slot selection by third *(or
select another slot with ^v and so on).
Monitor state and simulation
Monitor function can be used while
troubleshooting to view some internal values of
the indicator. It can be accessed either from the
front panel or using the configuration software.
Monitor mode is entered in the normal state by
pressing *and vtogether. Select slot with ^v
and push >to enter. The monitored item can be
selected with ^v. To return to slot selection, push
*. To return to normal state, push *once more.
Objects to monitor are described in sections of
each card.
Some monitor items have a possibility to be
locked, so that the indicator does not anymore
update them. Then they may be changed by the
user to test the system. How to lock in Mekuwin,
see its manual. To lock using the front panel, do
as follows:
1. Enter the monitoring state as described
and the slot you want to.
2. Select the item to be locked using ^v
buttons. Do not push >yet.
3. Press and hold >button. Then push ^
also. Release them both.
4. Now you can enter a new value to
simulate/test something.
5. Exit with *.
To return to normal operation, do the same, but
while holding >, push v.
6
