Premium PWC1007XB Manuale utente
PWC1007XB
Model:
This product is for domestic use only
Use &Care Manual
Important Safeguards
Manual de uso ycuidado
Precauciones importantes
Este producto es para uso domestico unicamente
ENFRIADOR DE VINO
WINE COOLER
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electrical shock by providing an escape wire for the
electrical current. This appliance is equipped with a cord having a grounding wire
with a grounding plug. The plug must be plugged into an outlet that is properly
installed and ground
WARNING - Improper use of the grounding plug can result in a risk of electric
shock. Consult a qualified electrician or service person if the grounding
instructions are not completely understood or if doubt exists as to whether the
appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your refrigerator to an extension cord
or together with any other appliance in the same wall outlet. Do not splice the
cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous attraction for children. Remove either
the gasket, latches, lid or door from unused appliances, or take some other action
that will guarantee it harmless.
DANGER: Risk of child entrapment. Before you throw away your old refrigerator
or freezer:
Take off the doors.
Leave the shelves in place so that children may not easily climb inside.
DON'T WAIT! DO IT NOW!
SPECIAL INSTRUCTIONS
You must remove the bottom door support on the bottom left hand side of the unit
before you can open the door. (See Fig. A)
INSTALLATION INSTRUCTIONS
Remove the exterior and interior packing materials. Wipe the outside thoroughly
with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
cabinet in a narrow recess or near any heat source, direct sunlight, or moisture.
Let air circulate freely around the cabinet. Keep the rear of the wine cooler 5
inches away from the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the wine cooler and any adjacent
wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating.
Heat sources nearby will cause higher electricity consumption.
To avoid vibration, the cabinet must be set level. To start the wine cooler, turn the
temperature control to the position corresponding to the desired cooling. The wine
cooler temperature will vary depending on the quantity of bottles stored and on
the frequency with which the door is opened.
OPERATION
To turn OFF the wine cooler you must disconnect the power cord from the
electrical outlet. There is no "OFF” position available on the electronic control
panel. When the wine cooler is not to be used for a long period of time, disconnect
the plug and leave the door partially open.
NOTE: Wait 3 to 5 minutes before restarting if operation has been interrupted,
Interior Light
The interior light is manually controlled and does not operate with the opening or
closing of the door. To turn the light ON, manually press the "light" keypad located
on the electronic control panel.
NOTE: Leaving the interior light on for extended time periods will increase the
internal temperature of the cabinet.
Defrosting
Your wine cooler is designed with an "Auto-Cycle" defrost system.
What is Auto Cycle defrost?
The refrigerated surfaces of the interior compartment defrost automatically, during
the "OFF” cycle of the temperature control. Defrost water from the interior
compartment is disposed of automatically, by means of being channeled onto a
drip tray located on the compressor. Heat transfer from the compressor causes
the defrost water to evaporate.
ELECTRONIC CONTROL OPERATION
The electronic LED display on this wine cooler is programmed to display
independently the following temperature information:
INTERNAL CABINET TEMPERATURE: this setting is represented by a steady
state (non-flashing) LED display and is the normal (LED) default setting during
operation.
SET OPERATING TEMPERATURE: This setting is represented by a flashing
LED display and can only be programmed by pressing and releasing either of the
+/- temperature keys during operation.
NOTE: The set temperature can only be adjusted/set while the LED is in flashing
mode.
CARE & MAINTENANCE
DEFAULT SETTINGS: When the unit is first connected to a 115V/60Hz power
supply, and/or in the event of a power failure, the temperature settings
automatically revert to the following default settings:
The LED default setting for the internal cabinet temperature is the real (ambient)
temperature measured at the time the unit is connected or power is restored.
The LED default setting for the set operating temperature is 50oF/10oC. After a
power failure has occurred, the previously set temperature is automatically erased
and will have to be reset.
The LED default setting for temperature selection (oF/oC) is oF (Fahrenheit Scale).
SETTING OPERATING TEMPERATURE: To set/change the operating
temperature:
1. Press and release either of the +/- temperature keys.
The LED display will temporarily reveal the flashing set temperature for
approximately 5 seconds. If you fail to set/change the operating temperature
within this 5 second period, the LED will automatically revert back and display
the internal (cabinet) temperature.
2. Each time you press the +/- keys during flashing mode will change the
temperature incrementally by 1o (Temperature ranges between 43oF ~ 57oF /
6oC~14oC). The operating temperature will flash in the LED display for
approximately 5 seconds after the selection is made, then revert back to
display the internal cabinet temperature.
TEMPERATURE SELECTION (oF/oC): This unit can display temperatures on the
Fahrenheit or Celsius scales. Press the temperature selector keypad to alternate
between the oF/oC scales. The blue indicator light adjacent to the corresponding
mode will illuminate to mark the selection made.
Cleaning
To clean the inside of the cabinet, use a soft cloth and a solution of a tablespoon
of baking soda to one quart of water, or a mild soap solution, or some mild
detergent. Clean the cantilever wine racks using a lightly dampened cloth and
then dry them thoroughly with a soft cloth. Clean the outside with a soft damp
cloth and some mild detergent or appliance cleaner.
Vacation Time
For short vacation periods, leave the electronic controls at their usual settings.
During longer absences:
(a) Remove bottles,
(b) Disconnect from electrical outlet,
(c) Clean the wine cooler thoroughly,
(d) Leave door open to avoid possible condensation, mold or odors.
Power Failure
Most power failures are corrected within an hour or two and will not affect the
internal temperature of your wine cooler. Try and minimize the number of door
openings while the power is off. During power failures of longer duration, take
steps to protect your wine. When power is restored, the previously set operating
temperature is automatically erased and must be re-programmed. (See Setting
Operating Temperature)
If You Move
Remove or securely fasten down all loose items inside the wine cooler. To avoid
damaging the leveling screws, turn them all the way into the base.
Light Bulb Replacement
To replace the interior light bulb:
Remove the screw holding the light bulb cover and remove the cover.
Unscrew the light bulb. Replace the light bulb.
NOTE: This appliance uses a standard 25-watt appliance bulb only. (Available at
most local hardware stores). The replacement bulb should not exceed 25-watt
rating.
Replace light bulb cover. Re-install the screw to secure cover.
Wine Racks:
This unit is equipped with the following wine racks:
6 Cantilevered Wine Racks (Contoured)
11 bottles (750ml) per shelf.
1 Cantilevered Wine Racks (Contoured)
15 bottles (750ml) per shelf.
1 Slide-out Wine Rack (Layered)
13+6 750ml bottles per shelf.
Total Capacity: 100 Bottles.
Some important rules for the correct use of the Wine Cooler:
Beverages should be stored in sealed bottles.
Do not overload the cabinet.
Do not open the door unless necessary.
Should the wine cooler be stored without use for long periods, it is
suggested, after a careful cleaning, to leave the door ajar to allow the air to
circulate inside the cabinet in order to avoid possible condensation, mold or
odors,
DO NOT cover shelves with aluminum foil or any other shelf covering
material which may prevent air circulation.
Recommended Temperatures tor Chilling Wines:
Dry Wines: 9oC/48oF - 14oC/57oF
Rose Wines: 10oC/50oF
Indice
Lingue:
Altri manuali Premium Elettrodomestico da cucina
Premium
Premium PES1209C Manuale utente
Premium
Premium PRBD496MS Manuale del proprietario
Premium
Premium PSM270 Manuale utente
Premium
Premium PWC147MB Manuale utente
Premium
Premium PP1200 Manuale utente
Premium
Premium PWC456MS Manuale utente
Premium
Premium PMFS688 Manuale utente
Premium
Premium PBM50 Manuale utente
Premium
Premium PPN20 Manuale utente
Premium
Premium PHB315 Manuale utente
