Rainbow MR319D Manuale utente
Модель/ Model MR319D
Сerticated in Ukraine
Виріб сертифіковано в Україні
076
Owners manual. Iron
Żelazko
Manualul proprietarului. Fier de călcat
Утюг
Праска
EN
RO
PL
UA
RU
2
EN
Please read and comply with these original instructions prior to the
initial operation of your appliance and store them for later use of
subsequent owners.
This appliance is designed for domestic use only.
Under condition of observance of user regulations and a special-
purpose designation, a parts of appliance do not contain unhealthy
substances.
MR319D
Electrical supply:
Alternating current- AC;
220-240V;
50Hz;
Power consumption: 1000 W;
Protective class I
Protection class IPX0
dry ironing
3
Description of the appliance
Picture1
A- temperature control light
B- power cord
C- thermostat adjustment knob
D- sole plate
SPECIAL INSTRUCTIONS
NEVER immerse the iron, cable or plug in any liquid.
NEVER touch the appliance with wet or damp hands.
DO NOT let children or untrained persons use the appliance without
supervision.
DO NOT leave the hot iron touching fabrics or very inammable
B
А
D
C
4
surfaces.
DO NOT leave the appliance unnecessarily plugged in.
Disconnect the plug from the mains when the appliance is not being
used.
DO NOT use the power cord or the appliance in order to pull the
plug out of the socket.
DO NOT leave the appliance exposed to the weather (rain, sun,
etc.).
DO NOT leave the iron without supervision when it is connected to
the power supply.
INSTRUCTIONS BEFORE USING
- Use iron only for its intended use.
- The iron should always be turned to «Off» before plugging or
unplugging from outlet. Never yank cord to disconnect from outlet;
instead, grasp plug and pull to disconnect.
- Do not allow cord to touch hot surfaces. Let iron cool completely
before putting away. Loop cord loosely around iron when storing.
- Do not operate iron with a damaged cord or if the iron has
been dropped or damaged. To avoid the risk of electric shock,
do not disassemble the iron take it to a qualied serviceman for
examination and repair. Incorrect reassembly can cause a risk of
electric shock when the iron is used.
- Close supervision is necessary for any appliance being used by or
near children. Do not leave iron unattended while connected or on
an ironing board.
- The surface of the device becomes very hot during operation. Be
careful because you may burn yourself greatly by touching the sole
plate.
EN
5
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
BEFORE STARTUP
Before the rst use remove a protective lm (at presence) from an
iron sole.
Make sure that all the parts of appliance don’t have damages.
When using the iron for the rst time, you may notice
a slight emission of smoke and hear some sounds made by the
expanding plastics. This is quite normal and it stops after a short
time. We also recommend passing the iron over an ordinary cloth
before using it for the rst time.
Soft the laundry to be ironed according to the international symbols
on the garment label, or if this is missing, according to the type of
fabric.
6
GARMENT FABRIC THERMOSTAT LABEL TYPE
REGULATION
Table 1
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up
than to cool down) and eliminates the risk of scorching the fabric.
SELECTING THE TEMPERATURE
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (С/Picture 1) according to the
international symbol on the garment label [see Table 1]. The plate
temperature control light (A/Picture 1) indicates that the iron is
heating up. Wait until the plate temperature control light goes off
before ironing.
during ironing, the plate temperature control light (A/
Picture 1) comes on at intervals, indicating that the selected
temperature is maintained. If you lower the thermostat temperature
Signs on labels Type of fabric Thermostat positions
Synthetic ●
Low temperature
Silk - wool ●●
Medium temperature
Cotton - linen ●●●
High temperature
Fabric not to be ironed
EN
7
after ironing at a high temperature, do not start ironing until the plate
temperature control light comes on again.
ADVICE FOR GOOD IRONING
We recommend using the lowest temperatures with fabrics that
have unusual nishes (sequins, embroidery, ush, etc.).
If the fabric is mixed (e.g. 40% cotton 60% synthetics), set the
thermostat to the temperature of the bre requiring the lower
temperature.
If you don’t know the composition of the fabric, determine the
suitable temperature by testing on a hidden corner of the garment.
Start with a low temperature and increase it gradually until it
reaches the ideal temperature.
Never iron areas with traces of perspiration or other marks: the heat
of the plate xes the stains on the fabric, making them irremovable.
The size is more effective if you use a dry iron at a moderate
temperature: excess heat scorches it with the risk of forming a
yellow mark.
- Before cleaning the iron in any way, make sure that the appliance
plug is not connected to the socket.
- Before cleaning unplug the appliance and let it cool completely.
- Do not let water get inside the appliance.
-Avoid scratching the plate with steel wool or metallic objects.
-Any deposits, starch residue or size left on the plate can be
removed using a damp cloth or an unabrasive liquid detergent.
The plastic parts can be cleaned with a damp cloth then wiped over
with a dry cloth.
8
Before cleaning unplug the appliance and let it cool
completely.
Turn the temperature control dial to the «0» position.
Keep the appliance in cool dry place, away from children and
persons with reduced mental or physical abilities.
Old appliances contain valuable materials that can be recycled.
Please arrange for the proper recycling of old appliances. Please
dispose your old appliances using appropriate collection systems.
Subject to technical modications!
EN
9
Prosimy o zapoznanie się z niniejszą instrukcją i zachować ją jako
punkt odniesienia w całym okresie trwania instrumentu.
Urządzenie jest przeznaczone do użytku domowego.
Jeżeli urządzenie używane jest zgodnie z jego przeznaczeniem nie
wytwarza szkodliwych substancji.
Charakterystyka techniczna
MR-319D
Zasilanie: Prąd zmienny
Częstotliwość znamionowa 50 Hz;
Napięcie znamionowe 220-240V;
Moc: 1000W;
Wykonanie Korpusu Ochrona przed wilgocią odpowiada normie
IPХ0;
Tryby pracy: sucho
10
Rysunek 1
A- Lampka kontrolna
B- Przewód zasilający
C- Pokrętło termostatu
D- Powierzchnia grzewcza
-Nigdy nie zanurzaj urządzenia, jego przewodu zasilającego i wtyczki
w wodzie lub innych cieczach.
B
А
D
C
Questo manuale è adatto per i seguenti modelli
1
Indice
Lingue:
Altri manuali Rainbow Ferro
