-02--25-
Introduction
Features and functions
Need To Know
Before Use
This product using magnetic induction thickness mea-
surement method, the thickness equipment specially
designed to perform small, fast, accurate and non-destr-
uctive thickness measurement of coating and plating on
steel magnetic conductor. it is widely used on manufact-
uring, workshop, chemistry or quality measuring range.
Easy- to- read LCD direct display measurement value
and status.
Using Hi- sensibility sensor for precise measure.
0 point, 2 point and basic, three different calibration
modes for quick and easy to process the system toler-
ance calibration.
Single, continually and difference, three different
measure mode.
Result data can record, check and delete into the unit
memory.
The Instruments can do some simple data analysis,
like maximum, minimum, mean, standard deviation,
and measure times.
Buzzer notice function.
Unit can convert between the metric system and British
system.
Low Battery notice function.
Auto power off function.
LCD backlight function.
Simple, compact structure and portable.
d. curvature:
You should not measured at the distorted surface.
e. the reading number:
Because the data you read will not same all the time,
so you should read several value at one measurem-
ent. The part difference of the coating also request
measure several time especially when the surface is
rough.
f. cleanness of surface:
You should clear all the attachment before the mea-
surement, for example, dust, ,grease, erode things
and so on, but do not removed anything contained in
the coating.
3. instruction about the measurement result:
a. single measurement is not credibility at statistics p-
oint. So all the value displayed by the tester are ave-
rage value. The time after time measurement is co-
mplete by detect head and tester within one second.
b. To make the measurement more precision, you can
measure several times, and then delete the big error
one, at last use the tester's analysis function to get
five statistical data: average value (AVG), MAX, MIN,
standard warp (dFR), data number (NO).
